Page 1
Dining Table
IMPORTANT
Carefully remove all the parts from the carton and
place them individually on a soft cloth to prevent
scratches or other damage.
Carefully and strictly follow these assembly instructions
to ensure a completed product as designed.
Do not use power tools above 8 volts to assemble.
Part List
A.
To p
1 pc.
B.
Leg
4 pcs.
Hardware List
Hex Wrench
1 pc.
Small
Hex Wrench
1 pc.
Tool(s) required for assembly: Slotted screwdriver, Level
M6x18
Head Cap Bolt
24 pcs. (+1 extra)
C.
Stretcher
1 pc.
Spring Washer
24 pcs. (+1 extra)
Flat Washer
24 pcs. (+1 extra)
D.
Wood Stick
2 pcs.
Steel Plate
4 pcs.
Page 2
Assembly Instructions 2/3
IMPORTANT
Use a soft cloth between these parts and the floor.
Do not use power tools above 8 volts to assemble.
Do not tighten all the bolts until each part is properly assembled.
Keep Hex Wrench in a safe place as the bolts may need to be tightened up in the future.
Head Cap Bolt
Spring Washer
Flat Washer
Steel Plate
B
STEP 1
Attach Steel Plates to Legs (B) with
Flat Washers, Spring Washers,
Head Cap Bolts
B
, tighten the bolts.
(See Figures 1)
Figure 1
B
C
STEP 2
Turn all Legs (B).
Attach legs together.
STEP 3
Attach leg units to
Stretcher (C).
Page 3
Assembly Instructions 3/3
D
Wood Stick
D
STEP 4
Turn the unit.
Attach Wood Sticks (D) to hole of
end stretcher. (See Figure 2)
Figure 2
Figure 3
Head Cap Bolt
Spring Washer
Flat Washer
STEP 5
Attach base unit to Top (A) with
Flat Washers, Spring Washers,
Head Cap Bolts
(See Figure 3)
, tighten all bolts.
A
Figure 4
STEP 6
Turn unit over to its’ upright position.
To level the unit, adjust the adjustable levelers on the bottom
of the legs. (See Figure 4)
Note: Unit must be level to work properly.
Page 4
CARE INSTRUCTIONS
NEVER
allow liquids to remain on furniture.
Absorption causes parts to warp
and split and finishes to delaminate.
Do not use power tools
above 8 volts to assemble.
PREVENT
CRACKING
Do not place
in direct sunlight.
PREVENT
FADING
NEVER
use glass cleaners on
finished furniture. Ammonia
chemically attacks the finish.
Do not write
directly on surface.
PREVENT
MARKING
Do not place hot
objects on surface.
PREVENT
FINISH DAMAGE
Do not use rubber
based placemats.
PREVENT
DISCOLORING
CLEAN
with a soft cloth moistened
in lukewarm soap and water.
Buff with a dry clean cloth.
Do not use commercial
waxes and polishes.
PREVENT
YELLOWING
Loading...