ASSEMBLY INSTRUCTION
END TABLE WITH 1 DRAWER
Table Top
A B C D
1PC 4PCS 1PC 1PC
Bolt
E
1/4”x1-1/4”xØ13
1PC 16PCS
Leg Post
Bolt
F
F
1/4”x1/2”xØ13
Upper
Cross Bar
Allen Wrench
G
4MM
1PC
Lower Cross Bar
This page lists all the contents included in the box.
Please take the time to identify the hardware as
well as the individual components to this product.
As you unpack and prepare for assembly, place
the contents on a carpeted or padded area to
protect them from damage.
1
***Do not tighten screws & bolts until the entire unit is completely assembled.
Assemble the Upper Cross Bar (C) to the Leg Post (B), then using the Bolt (F) by Allen
1
Wrench (G).
C
B
Assemble the Lower Cross Bar (D) to the Leg Post (B), then using the Bolt (F) by Allen
2
Wrench (G).
G
F
D
F
X 2
B
B
G
F
F
2
X 2
B
***Do not tighten screws & bolts until the entire unit is completely assembled.
Attach the Upper Cross Bar (C) to the assembled Lower Cross Bar (D) as bellow shown,
3
then using the Bolt (E) by Allen Wrench (G).
G
B
E
B
Attach the Table Top (A) to Leg Post (B) as shown, then using the Bolt (F) by Allen Wrench
4
(G).
C
B
D
B
B
G
X 4
F
F
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces
with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time.
Periodically check that all connections are tight.
B
B
A
B
3
Loading...