ASSEMBLY INSTRUCTION
1
Table Base - Left
Table Base - Right
Table Base - Center
Table Top
This page lists all the contents included in
the box. Please take the time to identify the
hardware as well as the individual
components to this product. As you unpack
and prepare for assembly, place the
contents on a carpeted or padded area to
protect them from damage.
Mounting Plate Bolts
Ø1/4''x35mm
Bolts
Ø1/4''x25mm
Lock Washer
Ø5/16''x13mm
Flat Washer
Ø1/4''x16mm
Screws
Ø4mmx40mm
Allen Key
4mm
Cross Metal
1pc 1pc 2pcs
1pc
1pc 1pc 36pcs 4pcs
40pcs 40pcs 5pcs 1pc
DINING TABLE
Attach the Table Base - Left (A) to Table Base - Right (B) by aligning the wood dowels on Table
Base - Left (A) to the pre-drilled holes on Table Base - Right (B) as picture below.
Attach the Table Base - Center (C) to Table Base - Left (A) & Table Base - Right (B) by aligning the
wood dowels on Table Base - Center (C) to the pre-drilled holes on Table Base - Left (A) & Table
Base - Right (B) as picture below. Attach the Cross Metal (F) to the assembly base by using Bolts
(H), Lock Washer (I), Flat Washer (J), and tighten with Allen Key (L).
2
A
B
A
B
A
B
Wood Dowel
Turn the assembly base in step 2 to upright position (*Note: It is recommended to use two or
more persons to turn). Insert Screws (K) to the holes on assembly base and tighten all screws by
using phillips head screwdrivers (not provided). As picture below.
Wood Dowel
C
C
A
B
C
A
C
B
F
L
H
I
J
F
Wood Dowel
K
A
B
C
C
B
A
C
C
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surface with a
dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check
that all connections are tight.
Place the Table Top (D) upside down on a piece of cloth or carpet to prevent finish from scratching.
Remove the Mounting Plate (E) out of Table Top (D) by unfastening the 4 Bolts (G) as picture shown
(*Note : Keep the bolts for step 5). Attach the Mounting Plate (E) to the assembly base in step 3
by inserting Bolts (G), Lock Washer (I), Flat Washer (J) and tighten with Allen Key (L).
3
L
L
G
I
J
L
G
I
J
L
G
I
J
E
Assembly Base
E
D
E
D
Attach the assembly base in step 4 to the Table Top (D) by inserting Bolts (G), Lock Washer (I), Flat
Washer (J) and 4 Bolts (G) unfastened in step 4. Fully tighten all bolts with Allen Key (L). Turn the
table to upright position (*Note: It is recommended to use two or more persons to turn the table).
Place the table on flat surface and adjust the leveler until the table level and does not wobble.
L
G
I
J
L
G
I
J
Leveler
Assembly
Base
D
G
I
J
Loading...