NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Mounting Strap (A)
Green grounding
Screw (E)
Mounting Screw (B)
Lock Nut (F)
Wire Connector (C)
Ball Nut (G)
Fixture Mounting
Screw (D)
Set Screw (H)
Installation Steps
Turn off the power at fuse or circuit box.
1. Thread two fixture mounting screw through the mounting strap, and
then secure with two lock nuts. Adjust the length of the fixture
mounting screws if necessary.
2. Attach the mounting strap to the outlet box by using mounting screw.
3. Rod Connections
a. Thread the fixture wire from the fixture through the lower rod, and
then secure the lower rod onto fixture usint the threaded pipe.
b. Thread the fixture wire through the middle rod, and then secure
the middle rod, and then secure the middle rod onto the lower
rod using the threaded pipe.
c. Thread the fixture wire through the upper rod,and then secure the
upper rod onto the middle rod using the threaded pipe.
d. Thread the fixture wire through the hook and fixture canopy, and then
secure the hook onto the upper rod using the threaded pipe.
Note: Length adjustable from 32-1/4" to 86-1/4" . Use
fewer rods if shorter length is desired.
4. Hang the hook to the loop of the fixture canopy.
5. Pull out the outlet wires and house grounding wire
from the outlet box. Make wire connections using
the wire connectors:
---The smooth wire (marked) from the fixture to the
black wire from the power source.
---The ridged wire (unmarked) from the fixture to the
white wire from the power source.
---Attach the fixture grounding wire to the mounting
strap with the green grounding screw. Then connect
it to the house grounding wire with a wire connector.
Carefully put wires back into the outlet box.
Outlet Box
House Grounding Wire
Wire Connector (C)
Fixture Mounting Screw (D)
Mounting Strap (A)
Lock Nut (F)
Mounting Screw (B)
Green Grounding Screw (E)
Fixture Canopy
Ball Nut (G)
Threaded Pipe
Upper Rod
Threaded Pipe
Middle Rod
Threaded Pipe
Threaded Pipe
Lower Rod
Threaded Pipe
Glass Bracket
Set Screw (H)
Socket
Type A Max.60W
( not included )
Glass Shade
6. Attach the fixture canopy to the mounting strap by inserting
the fixture mounting screw, and then secure it with two ball nuts.
7. Install 3x60W Max medium base bulb ( not included) to the socket.
Check relamping label at socket area or packaging for maximum
allowed wattage.
8. Attach the glass shade to the glass bracket by threading set
screws onto glass notches. ( Do not over tighten.)
Support Brace
Outlet Box
9. Angled mounting recommended for a vaulted or angled ceiling.
( See Fig.1)
Turn on the power at fuse or circuit box.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Strap (A)
Green grounding
Screw (E)
Mounting Screw (B)
Lock Nut (F)
Wire Connector (C)
Ball Nut (G) Set Screw (H)
Fixture Mounting
Screw (D)
Canopy
Mounting Hardware
Glass Shade
12" Rod 6" Rod
B
3" Rod
A: 21-1/4"
B: 27-3/4"
A
Loading...