Page 1
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box. Carefully unpack your new fixture and lay out all
the parts on a clear area. Take care not to lose any small parts necessary for
installation.
2. Mount the back plate(F) to the wall with the plastic anchors(E) and the wood
screw(G). The side of the mounting plate marked “GND” must face out. The
junction box is not included.
3. Guide supply wires through hole in center of mounting plate.
4. Follow wiring instructions carefully (see fig.2).
5. Attach the fixture body (C) onto the back plate, lock it securely with the
mounting screw(D). Mount the plastic anchors and short cord slot(H) to the
wall, lock them with the wood screw. Slide the fixture wires into the short cord
slot, then attach the long cord slot(I) snap into the short cord slot.
6. If you not need cord assembly of the fixture lamp, please pause and take out
fixture wires nuts of the back plate, then follow wiring instructions carefully.
(see fig.2 and fig.1.1)
7. Raise the shade(A) to the lamp holder，then lock it securely with check ring (B)
until tight.
8. Install the light bulb(not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!
CONNECTING THE WIRES (Fig.2)
1. Connect the electrical wires as follows. Connect the Black wire from the fixture
to the black house (hot) Wire. Connect the white wire from the fixture to the
white (neutral) house wire. Make sure all wire nuts are secured. You may
wrap the connections with electrical tape. If your outlet box has a ground
wires (green or bare copper) connect fixture’s ground wire to it. Otherwise
attach the bare copper fixture wire to the green ground screw on the mounting
plate.
2. Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction
box and test the fixture.
installation instructions do apply to this product.
FIG.1
FIG.2
H
FIXTURE
WIRES
Black or
Smooth
I
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or Bare
Copper(Ground)
Loading...