Sand & Stable LFMF4079 Assembly & Installation Instrutions

ASSEMBLY AND INSTALLATION INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
WARNING:
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
Hardware Package (included):
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Mounting Strap (A) Fixture Mounting
Mounting Screw (B)
Wire
Connector
(C)
Screw(D)
Installation Steps
Turn off the power at fuse or circuit box
1. Thread two fixture mounting screws through the mounting strap, and then secure with two lock nuts. Adjust the length of the fixture mounting screws if necessary.
2. Attach the mounting strap to the outlet box by using two mounting screws.
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green grounding screw. Then connect it to the house grounding wire with the wire connector. Carefully put the wires back into the outlet box.
Green Grounding Screw (E)
Lock Nut (F)
Outlet Box House Grounding Wire
Wire Connector (C)
Fixture Mounting Screw(D)
Green Grounding Screw (E)
Fixture Canopy
Ball Nut (G)
Bulb Type A Max.60W (not included)
Ball Nut (G)
Glass Bracket
Set Screw
Socket Base
4. Attach the fixture canopy to the mounting strap by inserting the fixture mounting screws, and then secure it with two ball nuts.
5. Install 1x60W Max medium base bulb (not included) to the socket. Check relamping label at socket area or packaging for maximum allowed wattage.
6. Attach the glass shade to the glass bracket by threading set screws onto the glass notches. (Do not over tighten.)
Turn on the power at fuse or circuit box
Notch
Glass Shade
Assembly Ki
t
Loading...