Samzuk Technology Development Co FPBN10A User Manual

User Manual

SAMCOM FPBN10A

INDEX

User Security Information --------------------------------------------- 3

Specification ------------------------------------------------------------ 11

Feature ------------------------------------------------------------------- 11

Products Inspection --------------------------------------------------- 12

Get familiar with the transceiver ------------------------------------ 13

Battery Information ---------------------------------------------------- 14

Disassembly and Reassembly ------------------------------------- 16

Basic Function --------------------------------------------------------- 19

Table ---------------------------------------------------------------------- 25

Troubleshooting Guide ----------------------------------------------- 26

Maintenance and cleaning ------------------------------------------ 27

Maintenance and Cleaning

1. Do not lift the transceiver directly by its antenna or external microphone.

2. Dust the transceiver with an anti-pilling cloth to prevent bad contact.

3. When the transceiver is off work, please cover the microphone cap.

4. The buttons, control knob and the casing of transceiver are easy to become dirty after long usage, you can use a neutral detergent (do not use strong corrosive chemicals) and wrung damp cloth to clean it.

* The company reserves the right to change product design and specifications,

and takes no responsibility for printing errors and omissions that may occur at the public division.

* Since technologies are developing continuously, the corresponding changes of

product design and specifications will go without notice.

* The reproduction of this manual in part or entirety without permission is strictly

prohibited.

* Our company reserves the right of final explanation to these commitments above.

Troubleshooting Guide

Problems

Battery may have been exhausted. Please

No Power

Battery lasts no long after charging

It can not reach others of a group

There are voices

from other people rather than group members in the channel.

When transmitting

voices, only a small or even no sound can be heard on the other side.

Consistent noises

update or recharging the battery. Battery may not be installed correctly. Please remove the battery and reload it.

Battery’s lifetime is due. Please update the

battery. Battery is not charged fully, so please ensure that the battery indicator is green when removing it.

Make sure you are using the same frequency

and “sub-audio frequency/sub-audio digital settings” as other members of the group. Confirm whether you are in the valid range of transceiver since other members of the group may be too far away.

Please change the sub-audio frequency/sub-

audio digital settings. At this time, be sure to change all the walkie-talkies of the group at the same time. (Need dealers to rechange.)

Confirm whether the rotary volume knob is to the appropriate volume. Send the machine to dealers to check the microphone.

Other members of the group may be too far away and can not receive the voices you send, please get close and try again.

Solutions

User Security Information

Handheld transceiver product safety and RF radiation

Warning: Please read the manual carefully before using. It contains the important safety using operation instruction, and RF energy and control information contributing to meet the RF radiation limitation requirement of national and international standards.

Information provided in this manual may replace the general safety information of the editions before.

Handheld Transceiver Safety Guidelines and Instruction

To control the transceiver radiation, ensure to meet the general or non-controlled environment radiation limitation standard, please operate following below procedures.

Press PTT key when talking; and release PTT key when receiving.

Because measured RF energy radiation will be generated when transmitting, so transmitting time should not exceed 50% of the using time. Place the tranceiver vertically on the front, make sure the microphone (and other parts including the antenna) is no less than 1 to 2 inches (ie 2.5 to 5cm) away from your lips when transmitting signals. It is very important to keep the correct distance from the transceiver, since the farther away the less radiation. If you carry the portable transceiver around your body, please put into SAMZUK specially designed fixture, leather, box or other annex. If not, the body by radiation will be out of range of general or noncontrolled environment RF radiation limitation that required by Radio Authority, Ministry of Information Industry. If you do not use any accessories, not place the transceiver on the front specified location, please make sure that it is no less than 1 inch (about 2.5cm) away from your body when transmitting signals. It is very important to keep the correct distance from the transceiver, since the farther away the less radiation. Only use the certified and provision antenna, battery and accessories or other alternatives by Samzuk. If not, the radiation will be out of range of RF radiation that required by Radio Authority, Ministry of Information Industry. Below web site lists the approved parts and accessories by Samzuk

QT & DQT tables

Frequency of 50 groups QT (Hz)

Code of 105 groups DQT

Voice compression and expansion

This feature ensures the user in a variety of noisy environments can get a clear call. Set by the dealers in the channel through programming software.

Scrambler

This feature is voice encryption, user no such feature can not receive the real voice, so makes your call be kept confidential. This feature may be set by dealers in the channel through programming software.

DTMF encoding

This transceiver has DTMF encoding function. It can be set by dealer througn programming software.

Electromagnetic Interference / Electromagnetic Compatibility

Remark: Electromagnetic Interference (EMI) occurs in nearly every electronic equipment, by not enough shielding, improper design or incorrect electromagnetic compatibility configuration.

Not allowed to change the transmitting frequency, to increase the transmission power (including the installation of additional RF power amplifier). Not allowed to use an external antenna or other transmitting antenna. Shall not cause harmful interference to a variety of legitimate radio services while using, if found harmful interference, should immediately stop using, and to take measures to eliminate the interference before continuing. Prohibition of interconnection with the public telephone network, public mobile communication network and other telecommunication networks.

Place

To avoid electromagnetic interference and other problems caused by electromagnetic incompatibility, please turn off the transceiver in the place where there is a sign showing “No transceiver”. Hospitals or medical institutions may use external RF energy very sensitive equipment. Prohibit the use of airports and aircraft radio.

+ 11 hidden pages