Samsung x460 Service Manual Disassembly & Reassembly

- 이 문서는 삼성전자의 기술 자산으로 승인자만이 사용할 수 있습니다 -

- This Document can not be used without Samsung's authorization –

3. Disassembly and Reassembly

3-1. Disassembly and Reassembly X460

[Caution] Attention to red sentence.

Part Picture Description

1. Make sure to separate the AC adapter and

battery before disassembling the system.

2. Slide the knob all the way to the end in the

direction of the arrows (1) and push the battery

in the direction of the arrows (2).

Main

System

3. If you push the battery upwards, the battery is

separated.

M2 X L4, BLACK(4EA)

4. Remove bottom screws.

Kind of screw.

BLUE : M2 X L4, BLACK (4EA)

RED : M2 X L7, BLACK (10EA)

YELLOW : M3 X L4, BLACK (2EA)

5. ODD and DOOR-HDD, DOOR-Memory Screw

Remove.

X460 3 - 1

- 이 문서는 삼성전자의 기술 자산으로 승인자만이 사용할 수 있습니다 -

- This Document can not be used without Samsung's authorization –

3. Disassembly and Reassembly

Part Picture Description

6. Open the HDD door , pull out HDD FPC and

take out the HDD.

[Caution]

Be careful when pull out the HDD.

Before separate top and bottom, remove the

HDD.

7. Pull the memory module latches out ward. The

memory module will pop up.

Main

System

Remove the memory module out at an angle of

30 degrees.

8. Separate ODD by pulling in the arrow

Direction.

9. Remove Bottom Screws.

X460 3 - 2

- 이 문서는 삼성전자의 기술 자산으로 승인자만이 사용할 수 있습니다 -

- This Document can not be used without Samsung's authorization –

3. Disassembly and Reassembly

Part Picture Description

10. Push the keyboard in the arrow direction

[Caution]

When using a tool, be careful not to scratch

the surface of Top and not to be hurt

11. Lift up the cover of connector connected FPC

of keyboard, and then pull out FPC, separate

the keyboard.

Main

System

12. Remove the screw.

13. Separate 3 CABLE, 2 FFC from TOP

ASSY(TOUCH_PAD / SPEAKER / MIC

Cable/Finger print, Bluetooth).

X460 3 - 3

- 이 문서는 삼성전자의 기술 자산으로 승인자만이 사용할 수 있습니다 -

- This Document can not be used without Samsung's authorization –

3. Disassembly and Reassembly

Part Picture Description

Main

14. Remove TOP ASSY by lift up.

15. Remove cables connected to Wireless LAN

Card, remove screw and LAN Card.

golan card : 2 antenna

kedron card : 3 antenna

1. White : main

2. Gray : MIMO(option)

3. Black : Aux

System

16 . Remove the fpc between right sub-board

and main board.

Remove the right sub board screw.

Remove right sub-board.

17. Remove camera cable, lcd cable

Separate antenna wire from main board.

X460 3 - 4