Samsung WT75C1P, WT75C1I, WT75C1, SWT65D2 User Manual
4. SPIN DRY TIMER
This is used to set the spin time, 1-5 minutes.
5. WATER SELECTOR
During washing,WATER GUIDE KNOB
should be selected to wash.
During spin rinsing,WATER GUIDE KNOB
should be selected to spin.
1. WASH SELECTOR
This is used to select wash action.
2. WASH TIMMER
This is used to set the wash time, 1-15 minutes.
3. CYCLE SELECTOR
This is used to set the Washing/Rinsing or Draining.
1 2
FEATURES
CAUTIONS
PRECAUTIONS WHEN OPERATING
DESCRIPTION OF PARTS
POWERFUL WASHING BY LARGE PULSATOR
This washing machine has a big pulsator so that it
can wash a lot of laundry evenly.
TWO WAY LINT FILTER
Two way lint fiter strains off the lint during washing.
So you can wash laundry cleanly.
NORMAL OR SOFT SELECTOR
You can wash laundry effetively by
two types,Normal or Soft.
Be sure that the washer is grounded.
To avoid electrical shock,use
a metal pipe for the ground
connection. But, don't ground
the washer with gas pipes or
telephone lines to avoid to
dangers of explosion or lightning strike.
Do not put your hands into the spin
dryer basket when it is spinning.
Your fingers can be caught
by spinning laundry and
damaged.
If the supply
cord of this appliance is damaged,
it must only be replaced by a repair shop
appointed by the manufacturer,because
special purpose tools are required.
Warning
to
avoid overfilling and damages
this appliance must be filled with the
operator present using a moderate water
supply pressure only.
This appliance is to be connected to the water
mains using new hose-sets and that
old hose-sets should not be reused.
Ventilation
opening must not be obstructed
by carpeting when the washing machine is
installed on a carpeted floor.
Be sure to cover with the inner
cover on laundry before spinning.
This prevents laundry from
being tossed out and damaged.
Before washing,check all pockets.
If nails or pins remain in pockets,they may
damage the washer or clothes.
Close the water tap a little if the
water pressure is too high.
To avoid water splashes,
close the wash tub lid.
Never splash water on the control panel.
Disconnect the power cord from the
power supply when not in use.
Don't use excessively hot water.
(50
or more)
Plastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.
When you open this lid while
the spin basket is spinning,
the spinning will be stopped
by breake system.
(with pump)
POWER CORD
EARTH WIRE
WATER DRAIN HOSE
(WITHOUT PUMP)
SPIN DRYER BASKET
SPIN DRYER HATCH
WASH TUB LID
Be sure to keep the lid
closed during washing
and spinning.
WASH TUB
PULSATOR
The plug’s shape may not
correspond with this drawing.
CONTROL PANEL
SPIN DRYER LID
INNER LID
WATER DRAIN
HOSE
OVERFLOW
FILTER
LINT FILTER
DRAIN FILTER
DELICATE
WASH/RINSE
DRAIN
NORMAL
SOFT
WASH SPIN
W
A
S
H
S
E
L
E
C
T
O
R
W
A
S
H
T
I
M
E
R
C
Y
C
L
E
S
E
L
E
C
T
O
R
W
A
T
E
R
S
E
L
E
C
T
O
R
S
P
I
N
D
R
Y
T
I
M
E
R
DELICATE
WASH/RINSE
DRAIN
NORMAL
SOFT
W
A
S
H
S
E
L
E
C
T
O
R
W
A
S
H
T
I
M
E
R
C
Y
C
L
E
S
E
L
E
C
T
O
R
S
P
I
N
D
R
Y
T
I
M
E
R
Never allow children to operate
or play with the washer.
Children playing with the washer
may accidentally fall into the
washing tub.
SW-T65B1, SWT65C1
SW-T65A1
ADDITIONAL RINSE
(SHOWER RINSE)(FOR SW-T65B1, SWT65C1-Option)
W ASHING PROCEDURE
3 4
SPIN DRY
1. Before starting washing, check following;
Connect the water supply hose.
- Lay the drain hose down toward a sinkhole.
(In case no drain pump)
- Place the drain hose in sink or bath.
(In case drain pump)
- Connect the power cord to the power supply outlet .
Set the WA TER SELECTOR
KNOB to
SPIN and CYCLE
SELECTOR KNOB to
‘DRAIN’.
4. Set the CYCLE SELECTOR KNOB to
WASH RINSE .
(in case drain pump WASH )
5. Fill water in the wash tub
to the L lower water
level by carefully and
add the detergent.
6. Load laundry in the
wash tub and fill
water to proper
water level.
7. Set the WASH TIMER
1-15minutes.
8. After washing,set the
CYCLE SELECTOR KNOB
to ‘DRAIN
for drain.
1. Transfer the clothes into the spin basket
and arrange the clothes evenly.
RINSING
OVER FLOW RINSE
1. Set the CYCLE SELECTOR KNOB to
WASH RINSE . (In case drain pump WASH )
2. Supply the proper amount of water
as not to overflow the top of the
washing tub.
3. Set the WASH TIMER
2~3minutes.
3.As soon as the WASH TIMER
shuts off, turn off the water tap.
1.Keep suppling water(adjust water pressure
to ensure that the amount of water supplied
does not exceed that water drained.)
4. Drain the water.
Set the CYCLE
SELECTOR
KNOB to DRAIN
5.Repeat this cycle until drain water
is clean. (2~3 cycle)
2.Set the WASH
TIMER 6~8minutes.
4. Set the CYCLE
SELECTOR KNOB
to
DRAIN .
3. Close the spin dryer lid.
4. Set the SPIN DRY TIMER 1-5minutes.2. Be sure to attach the safety cover and
close the inner lid.
inner lid
safty cover
1
2
3
4
5
6
inner lid
safety cover
NORMAL
SOFT
2. Set the WASH SELECTOR KNOB
to the desired mode.
WASH SELECTOR
WASH SPIN
WASH SPIN
3. Set the WATER SELECTOR KNOB
to the desired mode.
(FOR SW-T65B1, SWT65C1)
TO WASH
After rinsing you can select this
course for more effective rinse
(Don't select only this course
for rinse.) Load the laundry
evenly into the spin basket.
Supply water for about 1minute.
Adjust the water flow to prevent
overflow from the wash tub.
After stopping water
supply, cover the
laundry with safety cover
and close the inner lid.
Close the spin dryer
lid.
Set the SPIN DRY
TIMER 2~3 minutes.
Loading...