DESCRIPTION OF PARTS
SPIN DRYER LID
When you open this lid while
the spin basket is spinning,
the spinning will be stopped
by breake system.
INNER LID
DRAIN HOSE
(WITH PUMP)
OVER FLOW
FILTER
WASH TUB
STRAINER
WASH TUB LID
Be sure to keep the lid
closed during washing
(FILTER)
and spinning.
WATER DRAIN HOSE
(WITHOUT PUMP)
1.WASH TIMER
This is used to set the wash time, 1-15 minutes.
2.CYCLE SELECTOR
This is used to select the Washing /
Rinsing or draining
POWER CORD
The plug’s shape may not
correspond with this drawing.
SPIN DRYER
BASKET
PULSATOR
DRAIN FILTER
(with pump)
CONTROL PANEL
3. SPIN DRY TIMER
This is used to set the spin time, 1-5 minutes.(or 1-10 minutes)
4.WATER SELECTOR
During washing,WATER SELECTOR KNOB should
be selected to wash.During spin rinsing,WATER
SELECTOR KNOB should be selected to spin.
2
W ASHING PROCEDURE
TO WASH
1. Before starting washing, check the following;
Connect the water supply hose and open the water tap.
- Lay the drain hose down toward a sinkhole.
(In case no drain pump)
- Place the drain hose in sink or bath.
(In case drain pump)
-Connect the power cord to the power supply outlet .
5. Load laundry in the
wash tub and fill
water to ‘H’high
water level.
2. Set the CYCLE SELECTOR KNOB to
3. Set the WATER SELECTOR
4. Fill water in the wash tub
●
‘WASH
KNOB to WASH .
RINSE’. (in case drain pump “WASH”)
and add the detergent.
SPIN DRY
1. Transfer the clothes into the spin basket
and arrange the clothes evenly.
6. Set the WASH TIMER 1-15minutes.
7. After washing,set the
CYCLE SELECTOR KNOB
to ‘DRAIN’ for drain.
3. Close the spin dryer lid.
close the inner lid.
inner lid
safty cover
4. Set the SPIN DRY TIMER 1-5minutes.2. Be sure to attach the safety cover and
(or 1-10minutes)
3