Operating Instructions
VACUUM CLEANER
❈
Before operating this unit, please read the instructions carefully.
❈ Indoor use only.
Register your product at www.samsung.com/global/register
IMPORTANT SAFEGUARDS
1. Read all instructions carefully. Before switching on, make sure that the voltage of your
electricity supply is the same as that indicated on the rating plate on the bottom of the
cleaner.
2. WARNING : Do not use the vacuum cleaner when rug or floor is wet.
Do not use to suck up water.
3. Close supervision is necessary when any appliance is used by or near children. Do not
allow the vacuum cleaner to be used as a toy. Do not allow the vacuum cleaner to run
unattended at any time. Use the vacuum cleaner only for its intended use as described
in these instructions.
4. Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full in
order to maintain the best efficiency.
5. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep
the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour the plastic parts of the unit.
6. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the
cleaner parts. Do not stand on the hose assembly. Do not put weight on the hose. Do
not block the suction or the exhaust port.
7. Switch the vacuum cleaner off on the body of the machine before unplugging from the
electrical outlet. Disconnect the plug from the electrical outlet before changing the dust
bag or dust container. To avoid damage, please remove the plug by grasping the plug
itself, not by pulling on the cord.
8. This appliance is not intended for use by young children or infirm persons without
supervision ;
Young children should be supervised to ensure that they do not play with the appliance.
9. The plug must be removed from the socket outlet before cleaning or maintaining the
appliance.
10. The use of an extension cord is not recommended.
11. If your vacuum cleaner is not operating correctly, switch off the power supply and consult
an authorized service agent.
12. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
13. Don’t carry the vacuum cleaner by holding the hose.
Use the handle on the vacuum cleaner set.
14. Unplug the cleaner when not in use. Turn off the power switch before unplugging.
1
ASSEMBLING THE CLEANER
1
*OPTION
OPTION
Features may vary according to model. Refer to 5,6 page.
▼
CAUTION
Please do not press the button of
dust bin handle when carrying
machine.
For storage, park the floor nozzle.
2
OPERATING THE CLEANER
2
2-1. POWER CORD
Please make sure your
cable is fully extended
before use.
2-2. POWER CONTROL (INFRARED CONTROL)
1. Vacuum cleaner ON/OFF ( )
- HOSE
SENDER
HANDLE CONTROL
[The cleaner is controlled by using
infrared signals.]
Press the ON/OFF button to operate the vacuum cleaner.
Press again to stop the vacuum cleaner.
2. Vacuum cleaner MODE (-/+)
Press the MODE button repeatedly to select the correct
mode.
(ON) MIN → MID → MAX
3. Using Auto mode
Press the Auto button to operate the vacuum
cleaner automatically.
NOTE
When removing the
plug from the
electrical outlet, grasp
the plug, not the cord.
- BODY
Press the power control button repeatedly to select the
correct mode.
(ON(MAX) → OFF)
NOTE : If the remote handle control is not
The filter light is illuminated when the dust
pack requires checking or emptying.
An audio signal will also sound.
The IR light indicates the part that
receives the infra-red signal from the
handle control.
3
working, the cleaner can be operated
using the control button on the body of
the machine.
This indicates that the automatic suction
mode is selected. The level of suction is
indicated by the LED display.
2-3. HOW TO USE AND MAINTAIN THE ACCESSORIES
Features may vary according to model.
▼
PIPE
Adjust the length of the telescopic
pipe by sliding the length control button located in the center of the telescopic pipe back and forth.
To check for blockages, separate the telescopic pipe and adjust to shorten. This allows
for easier removal of waste clogging the tube.
ACCESSORY
All in one Accessory
ELBOW EXTENDING TUBE
1234 5
(OPTION)
1. Connect the elbow extending tube to connecting part for hose knob and
telescopic pipe.
2. Fit the telescopic pipe to the lower part of the elbow extending tube.
3. Press the PUSH button.
4. With the PUSH button pressed, the elbow extending tube is folded.
5. Using the elbow extending tube allows hard to reach areas (e.g. under
furniture)to be cleaned without having to kneel down.
OPTION
▲▲
▲
Carpet
Cleaning
Push the accessory on to
the end of the hose handle.
Pull out and turn the dusting brush for cleaning delicate areas.
To use the upholstery tool,
push the accessory on to
the end of the hose handle
in the opposite direction.
▲
Floor
Cleaning
Adjust the inlet lever according to the
floor surface.
4
Remove waste matter completely if
the inlet is blocked.
OPTION
▲▲
▲
Carpet
Cleaning
▲
Floor
Cleaning
OPTION
OPTION
For improved
pick-up of pet hair
and fibre on carpets
Adjust the inlet lever according to the
floor surface.
Vacuum dust in wide area at once
Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to
matters tangled around the drum. In this case, clean the drum with care.
1
Push the Open button of
the transparent screen
cover to separate the cover.
4
Remove dust inside the
brush housing using a
dry duster or crevice tool.
2 3
Remove the brushbar
from the transparent
screen.
5
Insert brushbar into
rotating belt and
assemble.
Remove waste matter completely if
the inlet is blocked.
Remove waste matter completely
if the inlet is blocked.
Remove waste matter
such as dust and hair
tangled around the
brushbar using scissors.
6
Click the transparent
screen cover back into
place to reassemble.
OPTION
Brush for blanket
For picking up pet hair
and fibre on upholstery
and bed linen.
Clogs on turbine keeps brush from turning, and in this case, take care of it.
Turbine
Remove waste
matter completely when
inlet is blocked.
Warning : Use for bedclothes only. Be cautious not to damage brush during unclogging.
Turn the lock button to
‘UNLOCK’, and remove
waste matter.
Brush
To reassemble, align the cover to the
front of the main body and close. After
closing the cover, ensure that the lock
button is turned to the ‘LOCK’ position.
5
EMPTYING THE DUST BIN
3
1 2 3
Once dust reaches the DUST
FULL mark, empty the dust bin
4 5 6
Throw the dust away
in the bin.
- Empty into a plastic bag
(recommended for asthma/allergy sufferers)
After empting the DUST
BIN, remove the obstacles
like hair, fur on the cap of
the DUST BIN.
Take the dust bin out by
pressing the button.
Separate the dust
bin cover.
Before use, push the dust bin
into the main body of the vacuum cleaner until you hear
the "click" sound.
OPTION
NOTE
You may rinse the
dust bin with cold
water.
6
CLEANING THE DUST PACK
4
4-1. WHEN TO CLEAN THE DUST PACK
- Please, check the dust bin and dust pack if suction is noticeably reduced
or the filter check indicator lamp turns on after empting the dust bin.
The lamp will illuminate to signal
when suction is reduced.
If the light comes on, please clean the
DUST BIN as shown.
4-2. CLEANING THE DUST BIN
1
Detach the DUST BIN.
2
After empting the DUST BIN,
remove the obstacles like hair, fur
on the cap of the DUST BIN.
NOTE :
Please, check the filter
check indicator lamp (4-3)
as shown in the following
illustrations if the lamp is
still illuminated even after
cleaning the dust bin.
4-3. CHECKING THE FILTER CHECK INDICATOR LAMP
Turn the vacuum power to 'MAX'
HANDLE CONTROL
If the filter check indicator turns
red with the inlet floating 10cm
above flat floor, clean the DUST
PACK.
7
4-4. CLEANING THE DUST PACK
12
Remove the dust bin and dust
pack as shown.
Remove the fixed frame
of the dust pack cover.
3
Remove the sponge and filter
from the dust pack.
4
Wash the sponge and the filter
of the dust pack with water.
Let the sponge and filter dry
in the shade for more than 12
hours.
7 8
65
Put the sponge and
filter into the dust
pack.
Before reassembly,
align the dust pack cover
and dust pack correctly.
NOTE :
Make sure the filter is completely dry before putting it back into the vacuum
cleaner. Allow 12 hours for it to dry.
Put the assembled dust pack
into the main body.
8
CLEANING THE MOTOR PROTECTION FILTER
5
Take out both the dust bin and the
dust pack.
CLEANING THE OUTLET FILTER
6
1
Remove the dust bin.
3
Dust the HEPA filter.
4
Remove the motor protection filter from
the vacuum cleaner. Shake and tap the
dust from it and put back in machine.
2
Put the HEPA filter into the main body
until you hear a ‘click’ sound.
Pull out the HEPA Filter as shown.
NOTE : Replacement filters are available at your local Samsung distributor.
9
CHANGE THE BATTERY(OPTIONAL)
7
BATTERY TYPE : AAA Size
NOTE
1. When the vacuum cleaner does not work, replace the batteries.
If the problem persists, please contact our authorized dealer.
2. Use 2 batteries of size AAA.
WARNING
1. Never disassemble or recharge the batteries.
2. Never heat up the batteries or throw them into fire.
3. Do not reverse (+),(-) poles.
4. Dispose of the batteries properly.
- IF YOU HAVE A PROBLEM
PROBLEM CAUSE REMEDY 0
Motor does not start.
Suction force is gradually
decreasing.
Cord does not rewind fully. Check that the cord is not
Vacuum cleaner does not
pick up dirt.
Low or decreasing suction
This Vacuum cleaner is approved the following.
EMC Directive : 2004/108/EEC
Low Voltage Safety Directive : 2006/95/EC
If you have any comments or questions regarding Samsung products,
contact the SAMSUNG customer care center.
No power supply.
Thermal cut-out.
Nozzle, suction hose or tube
is blocked.
twisted or wound unevenly.
Crack or hole in hose.
Filter is full of dust.
Check cable, plug and socket.
Leave to cool.
Check for blockage and
remove it.
Pull the cord out 2-3m and
push the cord rewind button.
Check hose and replace if
required.
Please check filter and, if
necessary, clean as illustrated in the instructions.
Country
U.K
SOUTH AFRICA
Customer Care Center
0845 SAMSUNG(7267864)
0860 7267864 (SAMSUNG)
10
☎
Web Site
www.samsung.com
www.samsung.com
DJ68-00368A REV(0.5)
Loading...