Page 1
ART WORK SPEC
Changes Note: NEW
Design: Hyunwoo Lim
Size: 148mm x 210mm
Page: 12 Print Color: Black Part Code DJ68-00832D
Date: 2020-02-19 Post Processing : Cut Rev No 00
Material: Wood Free 80g VCA-SAE90*
Product
Model/PJT
Vacuum CleanerHQ R&D PIC: Jungran Kim
Page 2
Clean station
User manual
VCA-SAE90*
• Before operating this unit, please read the instructions carefully.
• For indoor use only
VCA-SAE90_EN_00832D-00_SA.indd 1 2020-02-18 오후 8:18:00
Page 3
English
Contents
PREPARATION
Safety Information 3
INSTALLATION
Installing the clean station 7
Installation guide 7
OPERATION
Using the clean station 8
Product specications
Model VCA-SAE90*
Power 230-240V, 50Hz or 220-230V, 50Hz
Weight 5.6kg
Depth
Height
Width
Size W180mm xD185mm xH600mm
NOTE
• The wave pattern on the exterior of the product is
a natural appearance due to the use of pearl plastic
materials and its pearl distribution.
MAINTENANCE
Maintaining the clean station 10
Dust bag 10
Dustbin 11
Grille lter 11
Outlet lter 11
Accessories
PULL
Dust bag: 3units
(Inside the product:
1unit / Spare:
• If you want to purchase an additional dust bag, check the model name (VCA-ADB90) and
Samsung logo (
2
VCA-SAE90_EN_00832D-00_SA.indd 2 2020-02-18 오후 8:18:02
PULL
PULL
Power cord Dustbin User manual
2units)
NOTE
) rst and contact a Samsung Electronics retailer nearest you.
Page 4
English
PREPARATION
Safety Information
The following contents are written for users’ safety and prevention of
property damage. Before using the product, please read this manual
thoroughly and use the product correctly.
For safety reasons, people with physical, sensory difculties, or mental
disorder, lack of experience and knowledge should not use this product
without the supervision of their guardians.
Caution/Warning symbols used
WARNING
Indicates that a danger of death or serious injury exists.
CAUTION
Indicates that a risk of personal injury or material damage exists.
Other symbols used
PREPARATION
NOTE
Indicates that the following text contains additional important information.
3
VCA-SAE90_EN_00832D-00_SA.indd 3 2020-02-18 오후 8:18:02
Page 5
English
Failure to meet these requirements
could cause damage to the internal
PREPARATION
parts of the vacuum and void your
warranty.
General
• This appliance is not intended
for use by persons (including
children) with reduced physical,
sensory or mental capabilities,
or lack of experience and
knowledge, unless they have been
given supervision or instruction
concerning use of the appliance
by a person responsible for their
safety. Children should not clean
or perform maintenance on the
vacuum without adult supervision.
Installation
CAUTION
• The clean station should be placed
and used on a stable oor.
– If the product falls over, an
injury or product and oor
damage may occur.
• Do not place or use the product on
an uneven oor, a carpet, a living
room table, or a desk etc.
– If the product falls over, an
injury or product and oor
damage may occur.
• Do not place the product at a
wall behind which pipes (gas or
water etc.) or electrical cables are
installed.
• Do not install the product near
water, in an area with excessive
moisture, or near window, etc.
• Do not install the product in a
place where people frequently
pass by, near an entrance, or a
narrow passage.
– If people trip over the product,
an injury or product damage
may occur.
Power related
WARNING
• Do not bend the power cord with
excessive force or put heavy
objects on the power cord.
– Otherwise, electric shock or re
may occur.
• If there is dust, water, etc. on a
contact point of the power plug
pins, wipe them carefully.
– Otherwise, abnormal operation
or electric shock may occur.
• Do not pull the power cord and
do not touch the power plug with
wet hands.
– Otherwise, electric shock or re
may occur.
4
VCA-SAE90_EN_00832D-00_SA.indd 4 2020-02-18 오후 8:18:03
Page 6
English
• Do not use a power source with
the incorrect voltage. Do not use
a multi-plug outlet or power strip
for the product. Do not leave the
power cord lying on the oor.
Attach the cord close to a wall.
– Otherwise, electric shock or re
may occur.
• Do not use a damaged power
plug, power cord, or loose power
outlet.
– Otherwise, electric shock or re
may occur.
• If the power cord is damaged,
have a Samsung authorized
service center’s qualied
repairman replace the power cord
with a new power cord.
– Otherwise, electric shock or re
may occur.
• Except for an authorized
repairman, do not disassemble or
modify the clean station.
• When using the product in a
veranda, make sure the power
cord and the power plug do not
touch water.
Operation
WARNING
• Static electricity may occur
depending on the humidity,
temperature, or oor material, etc.
of your operating environment. If
it happens repeatedly, contact a
Samsung service center.
• Do not cause a short circuit by
touching the power terminal with
chop sticks, metal screw drivers,
etc.
– Otherwise, product malfunction
or electric shock may occur.
• Make sure that any liquid such
as water or juice does not touch
inside or outside the product.
– Otherwise, electric shock or re
may occur.
• The clean station is manufactured
for Samsung Jet wireless vacuum
cleaner only, so do not use the
clean station for other purposes.
• Do not use the product near
heating appliances such as
heaters, or in areas containing
combustible sprays, or ammable
materials.
– Otherwise, re or product
deformation may occur.
PREPARATION
5
VCA-SAE90_EN_00832D-00_SA.indd 5 2020-02-18 오후 8:18:03
Page 7
English
• If there is a gas leak, or a
combustible spray is used such
PREPARATION
as a dust remover, do not touch
the power outlet and open the
window for ventilation.
– Otherwise, an explosion or re
may occur.
• If the product makes a strange
sound or emits a smell or smoke,
turn off the product immediately,
and then contact a Samsung
service center.
– Otherwise, electric shock or re
may occur.
CAUTION
• Do not allow children or a pet to
ride on or play with the product.
– If the product falls over, an
injury or product and oor
damage may occur.
• When moving the product, you
should grip it with both hands.
NOTE
• When the dust bag of the clean
station is lled with dust, the
product may stop temporarily due
to the overheating prevention
device of the motor. Replace the
dust bag and operate the product
again.
• As a new product, it may have a
slight odor for the rst 3 months
after purchase.
6
Maintenance
WARNING
• When cleaning the exterior of
the product, unplug the product
rst and then wipe it with a
dry towel. Do not spray water
directly onto the product or wipe
it with volatile materials such as
benzene, thinner, or alcohol.
– Otherwise, product damage
such as plastic breakage,
deformation, discoloration,
printing deterioration, etc. may
occur.
CAUTION
• Do not push the clean station in
case it falls over.
– Personal injury, oor and
product damage may occur.
• When the clean station emits bad
odor, replace the dust bag or clean
the lters.
• When you pull the power cord out
of the groove at the bottom of the
clean station, do not pull it hard.
Turn the cord gently on its side
so that it can come out without
interruption.
– Otherwise, the power cord may
get damaged and could cause an
electric shock or re.
VCA-SAE90_EN_00832D-00_SA.indd 6 2020-02-18 오후 8:18:03
Page 8
English
PUSH
PUSH
INSTALLATION
Installing the clean station
Installation guide
1
As the outlet is at the rear of the product,
do not put the product close against a wall,
allow 10 cm space between the wall and the
product, and place the product on a stable
oor.
INSTALLATION
2
Put the power cord into the groove at the
bottom of the clean station, arrange the cord
neatly along the wall and plug the product in.
• When the cord is placed on the oor
carelessly, the power cord may be damaged
or a person can trip over the cord.
• When the clean station is plugged in, the
product status indicator turns to 'blue' and
then goes off.
Please refer to the QR code for detailed information on the use of product and
cleaning methods.
7
VCA-SAE90_EN_00832D-00_SA.indd 7 2020-02-18 오후 8:18:06
Page 9
English
OPERATION
Using the clean station
The clean station is compatible with the provided dustbin only.
OPERATION
1
PUSH
button
2
Product
status
indicator
3
Press the [PUSH] button on the upper cover of
the clean station.
PUSH
Insert the dustbin into the clean station. Dust
is ejected automatically.
• When the clean station is in operation, the
product status indicator turns to 'blue'.
Start/Stop
button
• Press the [Start/Stop] button to stop
operation.
When the clean station's operation stops
completely, pull the dustbin out and close
the clean station by pressing the upper cover
rmly.
8
VCA-SAE90_EN_00832D-00_SA.indd 8 2020-02-18 오후 8:18:07
Page 10
English
NOTE
• When dust still remains inside the dustbin
even after using the clean station, press
the [Start/Stop] button to operate the clean
station.
– Press the button again to stop operation.
• If the dustbin is lled with dust and will not
eject it properly, use a hand to push down
the top of the washable micro lter, and
then operate the clean station.
• When there are foreign object residues,
remove them by referring to 'Maintaining
the clean station' section of the manual.
CAUTION
• After using the clean station, you should
close the dustbin by pressing the bottom
cover rmly until you hear it 'click'.
OPERATION
9
VCA-SAE90_EN_00832D-00_SA.indd 9 2020-02-18 오후 8:18:08
Page 11
English
PUSH
PULL
PUSH
PULL
PUSH
PUSH
PULLPULL
PUSH
PULL
PUSH
PULL
MAINTENANCE
Maintaining the clean station
Dust bag
Time to replace a dust bag
When the product status indicator turns to
'red', you should replace the dust bag.
1 2
1 Grip both sides of the front cover and pull
the cover towards you.
2 Open the cover by pulling the [PULL]
button.
3
4
Press the 'PUSH' lever. Pull the 'PULL' lever out in a diagonal
direction and remove the dust bag.
MAINTENANCE
5
1
6
1
2
PULL
button
2
Insert a new dust bag towards the back and
push the 'PULL' lever upward rmly until you
After replacing the dust bag, assemble the
clean station in reverse order.
hear it 'click'.
Be cautious not to assemble incorrectly
when inserting the dust bag.
NOTE
• If the dust bag emits a bad odor even though it is not lled with dust, replace the dust bag.
• When you operate the clean station after replacing the dust bag, the status indicator changes
from red to blue.
10
VCA-SAE90_EN_00832D-00_SA.indd 10 2020-02-18 오후 8:18:09
Page 12
English
PUSH
PULL
Dustbin
After emptying the dustbin, clean it with
water and dry completely before use.
Grille lter
• Lift up the grille lter inside the product
and pull it out. Then, detach the nonwoven
fabric from the lter.
• Remove the dust on the nonwoven fabric
by shaking it and reassemble the grille
lter.
Outlet lter
1
2
• Do not clean the outlet lter with water.
Shake the lter.
• To maintain the best performance of the
outlet lter, replace the lter once a year.
VCA-SAE90_EN_00832D-00_SA.indd 11 2020-02-18 오후 8:18:11
MAINTENANCE
11
Page 13
If you have any questions or comments relating to Samsung products,
please contact the SAMSUNG customer care center.
Country / Location Customer Care Center Web Site
AUSTRALIA
1300 362 603 (Other)
1300 425 299 (HHP)
HONG KONG 3698 4698
1800-22-8899 (HHP)
MALAYSIA
1800-88-9999 (OTH)
+603-7713 7420 (Overseas
www.samsung.com/au/support
www.samsung.com/hk/support (Chinese)
www.samsung.com/hk_en/support (English)
www.samsung.com/my/support
contact)
1800 7267864 /
SINGAPORE
1800-SAMSUNG (Other)
1800 4252997 /
www.samsung.com/sg/support
1800-GALAXYS (HHP)
SOUTH AFRICA 0860 SAMSUNG (726 7864) www.samsung.com/za/support
1800 40 SAMSUNG (1800
INDIA
40 7267864) (Toll-Free)
1800 5 SAMSUNG (1800 5
www.samsung.com/in/support
726864) (Toll-Free)
This product is RoHS compliant
DJ68-00832D-00
VCA-SAE90_EN_00832D-00_SA.indd 12 2020-02-18 오후 8:18:11
Loading...