Vacuum
Cleaner
For Household
use Only
Operating
Instructions
Read these instructions before operating the vacuum cleaner
The design and specification may be different depending on the models.
Register your product at www.samsung.com/global/register
DJ68-00148S REV(0.0)
Safety Instructions
Thank you for purchasing a Samsung vacuum cleaner. When using an electrical appliance, basic precautions should always be followed, including the following:
PLEASE READ ALL WARNINGS AND INSTRUCTIONS BEFORE USING THIS APPLIANCE
Warning:
. Unplug the vacuum from the outlet
necessary when used by or near
manufacturer’s recommended
is not working as it should, or has water, take it to a service center. the cord as a handle. Do not close a corners. Do not run the appliance
.
unplug, grasp the plug, not the
operate with any opening blocked: air flow.
away from openings and moving
such as cigarettes, matches
such as gasoline. Do not use
.
outlet with inadequate current
disconnecting the hose, replacing
.
.
Save these instructions!
has a polarized plug with one blade only one way. If the plug does fit, contact a qualified electrician to
.
1
Assembling Parts
Assembled Vacuum Cleaner Parts
to the left.
|
Handle |
|
|
Power Switch |
|
|
Upper Tank |
|
|
Frame and |
|
Louvers |
Filter(Inside |
|
|
Louvers) |
|
Cord |
Upper Tank |
|
Container |
Post-Motor Filter |
|
Filter |
Hepa Media Filter |
|
Height |
(Optional Item) |
|
Lock ’n Seal™ |
||
Adjustment |
||
Lever |
||
Knob |
||
Handle |
||
Powerfoot |
||
Release Pedal |
||
|
Furniture Protection Guard |
VOLTAGE SPECIFIED ON THE NAMEPLATE.
1-2 |
the |
to |
. |
firmly |
the |
body. |
Check to be sure the Handle is fitted to the vacuum body. If there is a gap in front, continue to push firmly until the Handle is flush.
Insert one screw provided from the screw packet into the existing hole. Tighten securely with a Philliphs head screwdriver.
1-4
Assembly on the back of the vacuum as shown.
Attach the Hose with the remaining two screws from the packet.
Tighten securely
with a screwdriver.
Grasping the Quick Reach Handle, slide the end of the Hose Wand onto the Hose Wand Base. Snap the Hose into the Hose Clip.
NOTE: The Powerfoot will not operate effectively unless the Hose Wand is firmly attached.
1-5 |
Slide the |
|
Extension |
|
Wand and |
|
the Crevice |
|
Tool together |
|
into the |
|
storage clip |
|
as shown. |
Slide the Dusting Brush Tool into the storage clip as shown.
2
Operation
2. How to use you samsung vacuum
ON-OFF Switch |
Handle positions |
2-3 |
Transporting cleaner
Carrying handle
CAUTION:
The Rotating Floor Brush continues to rotate while tools are in use. To reduce the risk of injury from moving parts, always move the cleaner with the Carrying Handle at the back of the cleaner. Always place vacuum cleaner on floor with Handle in Upright position when using tools. Never place your fingers under the cleaner when it is running. Never place Powerfoot on furniture or uneven surfaces. Do not place vacuum cleaner close enough to objects to pull them into rotating brush.
used to clean stairs or in
on the floor position.
To maintain maximum cleaning performance, the following maintenance steps must be performed:
Empty the Dirt Container when the dirt reaches the “Full” line on the side.
Check the Upper Tank and PreMotor Filters monthly and clean or replace as needed.
Clean or replace the Post-Motor Filter every three months.
Note: More frequent filter cleaning may be necessary if you are vacuuming new carpet, fine dust, or have allergy concerns. Follow the instructions on the following pages to perform these simple maintenance steps.
To move your cleaner from room to room, put the handle in upright position, tilt the cleaner back on its rear wheels and push forward.
Dusting Brush Tool:
Use to dust furniture, blinds, books, lamps, shelves, draperies, cushions.
Crevice Tool:
Use in tight narrow spaces.
Extension Wand:
Use with desired attachment for a longer reach.
NOTICE:
The Floor Brush will continue to rotate while you use your vacuum for above floor cleaning. To prevent carpet damage, do not lean on the vacuum or let the Powerfoot tilt forward.
NOTICE:
While vacuuming, certain carpets and low humidity conditions may generate small static discharges. The discharges are entirely harmless and are not associated in any way with the main power supply.
WARNING:
To reduce the risk of electric shock, turn Power Switch OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.
3
|
Maintenance |
|
2-6 |
2-7 |
Carpet height adjustment |
|
2-8 |
|
Cleaning lightweight flexible rugs |
|
|
container.
Put the Dirt Container back in the vacuum and slide the lever to the "Lock" position.
control (some models only)
vacuum
Cleaning The Upper Tank & Filter
Unplug the cleaner from electrical outlet.
The Upper Tank Filter can be reached by removing the Dirt Container, reaching underneath the Upper Tank and turning the rim of the Filter Frame to unlock. Pull straight down to remove. Brush the dirt off the Louvers and Upper Tank Filter.
The foam Upper Tank Filter may be removed and hand washed in cold water with mild detergent. Rinse well then air dry thoroughly before replacing.
The Upper Tank and Louvers may also be wiped clean with a damp cloth.
4