Vacuum Cleaner
FOR HOUSEHOLD USE ONLY
Operating
Instructions
Aspiradora
EN
EN
ES
SÓLO PARA USO DOMÉSTICO
Manual de uso
ES
ENGLISH ➔
SPANISH ➔
1 ~ 8
9 ~ 16
EN
ES
Read these instructions before operating the vacuum cleaner
Lea estas instrucciones antes de utilizar el aspirador
EN-Register your product at www.samsung.com/global/register
ES-Gane premios cuando registre su producto en www.samsung.com/global/register
Fill in and retain
Index
Safety lnstructions
Warning:
The model and serial number are located on the bottom of the cleaner.
For your personal records, please enter the COMPLETE model and serial number
in the spaces provided and retain this information.
Your cleaner is model
and has serial number
It is suggested that you attach your sales receipt to this owner’s manual.
Verification of date of purchase may be required for warranty service of your
SAMSUNG product.
Thank you for purchasing a Samsung vacuum cleaner. When using an electrical
appliance, basic precautions should always be followed, including the following:
To reduce the risk of fire, electric shock, or injury:
··
Do not leave appliance unattended when plugged in. Unplug the vacuum from the
outlet when it is not in use, or when it is being cleaned.
··
Do not use outdoors or on wet surfaces.
··
Do not allow to be used as a toy. Close attention is necessary when used by or
near children.
··
Use only as described in this manual. Use only manufacturer’s recommended
attachments.
··
Do not use with damaged cord or plug. If appliance is not working as it should, or
has been dropped, damaged, left outdoors or dropped in water, take it to a
service center.
··
Do not pull or carry the vacuum by the cord, or use the cord as a handle. Do not
close a door on cord, or pull the cord around sharp edges or corners. Do not run
the appliance over its cord. Keep the cord away from heated surfaces.
··
Do not unplug the vacuum by pulling on the cord. To unplug, grasp the plug, not
the cord.
··
Do not handle plug or appliance with wet hands.
··
Do not put any object into vacuum openings. Do not operate with any opening
blocked:Keep free of dust, lint, hair and anything that may reduce air flow.
··
Keep hair, loose clothing, fingers and all parts of body away from openings and
moving parts.
··
Do not use to pick up anything that is burning or smoking, such as cigarettes,
matches or hot ashes.
··
Do not use without dust bag and filters in place.
··
Turn off all controls before unplugging.
··
Use extra care when cleaning on stairs.
··
Do not use to clean up flammable or combustible liquids such as gasoline. Do not
use the vacuum in areas where such liquids may be present.
··
Store your cleaner indoors in a cool, dry area.
··
Do not use extension cords or plug into an electrical outlet with inadequate
current carrying capacity.
··
Avoid vacuuming up sharp objects.
··
Always turn this appliance off before connecting or disconnecting the hose,
replacing bags, or removing the bottom plate for maintenance.
··
Unplug electrical appliances before vacuuming them.
PLEASE READ ALL WARNINGS AND INSTRUCTIONS BEFORE USING THIS APPLIANCE
Assembling Parts
Checking Parts
Attaching the Handle
Attaching the Hose and Tools
Assembled Vacuum Cleaner Parts
Operation
ON-OFF switch
Handle positions
Transporting Cleaner
Carrying Handle
Cleaning Lightweight Flexible rugs
Cleaning Tool Attachments
Motor Protector Feature
Maintenance
Replacing the Dust Bag
Cleaning the Filters
Replacing the Headlight
Replacing the Belt
Clearing Clogs
Thermal Protector
Troubleshooting
Warranty
Save these instructions!
To reduce the risk of electrical shock, this appliance has a polarized plug with one
blade wider than the other. This plug will fit in a polarized outlet only one way. If the
plug does not fit in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to replace the outlet. Do not change the plug in any way.
EN
1
2~3
3~4
4~7
7
8
8
1. Assembling Parts
Checking Parts
Step 1. Attaching the Handle
You should have the following
items when you unpack your
vacuum cleaner.
A. Owner’s manual
B. Handle
C. Extension wand
D. Crevice tool
E. Combination tool
F. Vacuum body
Stand the vacuum upright
and slide the base of the
handle firmly into the
grooves at the top of the
vacuum body.
1-1
1-2
Insert the screw provided
into the existing hole.
Tighten the screw securely
with a screwdriver.
Before securing the handle,
please check that the
handle is fitted to the
vacuum body and make
sure there’s no gap.
1-3
Step 2. Attaching the Hose and Tools
Slide the end of the hose wand with
tabs into the suction intake valve.
Slide the extension wand and the
crevice tool together into the storage
clip.
1-4 1-5
ABCDE F
EN
2
2. Operation
ON-OFF Switch
Assembled Vacuum Cleaner Parts
The assembled cleaner will look
like the illustration to the left.
1.Handle
2.ON/OFF switch
3.Quick release cord hook
4.Exhaust filter
5.Crevice tool
6.Handle release
7.Carrying handle
8.Hose
9.Extension wand
10.Combination tool
WARNING!
OPERATE THE VACUUM CLEANER ONLY AT THE VOLTAGE SPECIFIED ON THE NAMEPLATE.
1.To turn cleaner ON(I), press the
ON/OFF switch to the ON position.
2.To the cleaner OFF(O), press the
ON/OFF switch to the OFF position.
Handle positions
The handle of your cleaner has three
positions; upright for storage and
when using cleaning tools; operating
for general operation on carpet and
floors; low for reaching under low
furniture. Step on handle release
pedal to lower handle.
Transporting cleaner
To move your cleaner from room to
room, put the handle in upright
position, tilt the cleaner back on its
rear wheels and push forward.
2-1 2-2 2-3
Front Back
1
2
4
8
3
5
9
7
10
6
1-7
EN
3
Carrying handle
The cleaner can also be moved by
using the carrying handle.
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the nozzle(front
of cleaner)and will prevent rug from
clinging to cleaner.
Continue to lift front of cleaner so that
when you have reached the edge, it is
completely off the rug. Move cleaner
back to start again, lower front of
cleaner, and use only forward strokes.
Cleaning Tool attachments
Attachment tools can be used to clean
furniture or drapes, on stairs or in
corners. Place the vacuum on the floor
with the handle in the upright position.
while using attachment tools. Do not place
the vacuum on top of furniture or steps as
the brushroller may cause damage
.
A. Combination tool:
Two types of cleaning tools are
included in one attachment: rotate for
desired tool.
·Use brush side to dust furniture,
blinds, books, lamps, shelves.
·Use upholstery side for curtains,
draperies, cushions, fabrics.
B. Crevice tool:
Use in corners, on stairs, baseboards,
and behind furniture.
C. Extension Wand:
Use with desired attachments and
narrow wand for a longer reach.
2-4
Carpet height adjustment
Carpet and rug cleaning takes place at
the nozzle (A).
When it is necessary to raise and lower
the nozzle for various carpet pile
heights, rotate the nozzle control knob
(B) to the desired setting.
2-7
2-8
2-8
2-6
2-5
A
B
C
For maximum cleaning performance,
The following carpet height settings are
recommended:
·Lowest setting: for all types of carpet
·Higher settings: for very deep pile
carpet where easier pushing effort is
desired, while maintaining good
cleaning performance.
Note: If the cleaner is difficult to push,
rotate knob to the next higher setting.
3. Maintenance
Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued
cleaning effectiveness.
Check the dust bag from time to time. Change the dust bag when dirt reaches the dotted line. If more dirt than this
accumulates, your cleaner will not operate effectively.
Note: All new carpet has loose fibers which can fill the bag quickly while vacuuming.
When to replace the Dust bag
EN
4
3-5 3-63-4
How to clean
Disconnect cleaner from electrical
outlet.
The secondary filter (A), located
behind the grill in the bottom of bag
compartment, protects the motor from
dirt particles.
If filter becomes dirty, pull off grill and
lift out filter.
Micro filter (VAU-5200)
Reposition new filter by reversing this
procedure.
HEPA filter (VAU-5400)
This filter will become dirty and needs
to be replaced about once a year to
maintain efficient filtration.
Reposition new filter by reversing this
procedure.
Do not operate cleaner without either
the secondary or final filter in place.
Normal filter (Black)
Hand wash filter in cold water with mild
detergent, then air dry.
Reposition dry filter and grill.
The final filter asists in the filtration
process to return clean air to the room.
To remove this filter, first open the door
on the side of the cleaner (Fig. 3-6).
Grasp filter (B) and pull it straight out.
The filter door is designed with a
“break away” feature which allows it to
snap free if it is pushed open too far.
To reattach, align hinges (C) of cover
with slots on sides of filter area.
How to attach filter door
Check agitator shield
Because your cleaner picks up so well,
we strongly recommend you check for
debris accumulation under the agitator
shield each time you clean the filters.
Removing debris under the shield will
help maintain your cleaner’s excellent
pick up and suction. Remove debris as
follows:
1.
Disconnect cleaner from electrical outlet.
2. Check for dirt accumulation by
removing bottom plate (Fig. 3-10),
removing agitator (Fig. 3-11), and
lifting agitator shield (Fig. 3-13).
3. Remove any debris and replace
shield, agitator and bottom plate
(Figs. 3-13 to 3-15).
Replacing bag door
3-3
Reposition bag door by placing tab on
bottom of door into opening (C).
Press top of door to snap securely
shut.
Removing and installing
filter bag
Replacing Dust Bag
Cleaning secondary and final filters
Disconnect cleaner from electrical outlet.
3-1 3-2
Pull the bag door outward to open.
Set bag door aside.
Grasp dust bag collar (A) and pull
collar from tube (B).
Note: Do not clean out old dust bag
and reuse. Discard used dust bag.
Hold new dust bag as shown. Align
opening in dust bag with (B).
Push (A) firmly onto (B).
Tuck in dust bag.
EN
5
Loading...