Samsung UN65H7150AFXZA, UN55H7150AFXZA Installation Guide

Unpack

Taking the TV Out of the Box

• Warning:

Do not touch the TV’s screen when you take it out of the box. Hold it by its edges only. If you touch the screen, you can cause the TV panel to crack.

Included in this Box

Remote Control

MIC

KEYPAD

SOURCE

VOL

VOICE

GUIDE

RETURN

CH.LIST

EXIT

SMART HUB

3D CC P.SIZEMTS

INFO

Samsung

Smart Control

Also included

• User manual

• Regulatory guide

• 3D Active Glasses

Remote

Control

• Recommendation 1:

Two people should remove the TV from the box as shown above. When removing the TV, hold it by its edges only. Do not touch the screen.

Stand Parts and Cables

Batteries

(2 AA, 2 AAA)

Wall Mount Adapter

(65 inches models)

Cable Holder Power Cord IR Extender

Base

• Recommendation 2:

If only one person is available to remove the TV from the box, remove it as shown in the illustration above. Hold the TV by its edges. Do not touch the screen.

x 2

Stand Cover Stand Neck

x 4

x 2

Screws (x12)

[UH7150-QSG]BN68-05937A-02ENG.indb 1 2014-09-30  10:24:28

Assemble

X 2

X 12 (M4 X L14)

1 Locate the Base, Stand Cover,

Stand Neck and Screws in the box and set them aside.

3 Fit the Base and Stand Neck

together, making sure the notch on the Stand Neck aligns with the stand.

X 2

2 Place the TV on a soft surface,

screen side down. Use the packing material to protect the screen.

X 8 (M4 X L14)

4 Assemble each side of the Base

and Stand Neck, inserting 4 screws each.

[UH7150-QSG]BN68-05937A-02ENG.indb 2 2014-09-30  10:24:30

1 2 3

Press each side of the Stand Cove r and then se parate it fro m the TV.

✎

(Whe n you separate the stand f rom the TV w hile insta lling the wa ll mount k it, you must al so separate the Stand Co ver from the T V).

5 Holding the stand parallel

to the screen, slide the Stand Neck into the notches on the back of the TV.

X 4 (M4 X L14)

6 Insert 4 screws, and

then use a screwdriver to secure the stand to the TV.

7 Insert and press the

Stand Cover.

8 Set the TV upright on its

stand. Conﬁrm that the TV is level and stable. You are now ready to connect external devices to the TV.

[UH7150-QSG]BN68-05937A-02ENG.indb 3 2014-09-30  10:24:33

Connection panel on the back of the TV

Connect

* Recommended Connections

After you have connected all your external devices, plug the TV’s power cord into the back of the TV. DO NOT plug it into a wall outlet until you have reached Section 7, Initial Setup.

Internet

Connect here with an Ethernet cable or wirelessly later during the Initial Setup.

TV signal

Connect your coaxial cable to the Antenna In port.

[UH7150-QSG]BN68-05937A-02ENG.indb 4 2014-09-30  10:24:34

Cable/Satellite/DVR

Connect your Cable box or digital video recorder with an HDMI cable.

+ 8 hidden pages