Samsung UN60H7100AFXZA Installation Guide
1
Unpack
Taking the TV Out of the Box
• Warning:
Do not touch the TV’s screen
when you take it out of the box.
Hold it by its edges only. If you
touch the screen, you can cause
the TV panel to crack.
• Recommendation 1:
Two people should remove the
TV from the box as shown above.
When removing the TV, hold it
by its edges only. Do not touch
the screen.
• Recommendation 2:
If only one person is available
to remove the TV from the
box, remove it as shown in the
illustration above. Hold the TV
by its edges. Do not touch the
screen.
Included in this Box
Remote Control
MIC
TV
KEYPAD
SEARCH
SOURCE
CH
VOL
VOICE
GUIDE
RETURN
CH.LIST
EXIT
SMART HUB
3D CC P.SIZEMTS
INFO
MENU
Samsung
Smart Control
Remote
Control
Batteries
(2 AA, 2 AAA)
Keyboard
Wireless Keyboard
* UH7100 series models only
Also included
• User manual • Regulatory guide • 3D Active Glasses
Stand Parts and Cables
x 2
Base
Wall Mount Adapter
(65 inches models)
Cable Holder Power Cord
Stand Cover Stand Neck
x 4
x 2
x 2
Screws (x12)
IR Extender
Cable
[UH7100-QSG]BN68-05937E-02ENG.indb 1 2014-09-30 10:56:05
2
Assemble
X 2
X 12 (M4 X L14)
1 Locate the Base, Stand Cover,
Stand Neck and Screws in the box
and set them aside.
3 Fit the Base and Stand Neck
together, making sure the notch
on the Stand Neck aligns with the
stand.
X 2
2 Place the TV on a soft surface,
screen side down. Use the packing
material to protect the screen.
X 8 (M4 X L14)
4 Assemble each side of the Base
and Stand Neck, inserting 4 screws
each.
[UH7100-QSG]BN68-05937E-02ENG.indb 2 2014-09-30 10:56:08
1 2 3
Press each side of the Sta nd Cover and the n separate it fro m the TV.
✎
(Whe n you separate the stand from the T V while insta lling the wall
mount k it, you must also separate the Stand Cover from the T V).
5 Holding the stand parallel
to the screen, slide the
Stand Neck into the
notches on the back of
the TV.
X 4 (M4 X L14)
6 Insert 4 screws, and
then use a screwdriver
to secure the stand to
the TV.
7 Insert and press the
Stand Cover.
8 Set the TV upright on its
stand. Confirm that the
TV is level and stable.
You are now ready to
connect external devices
to the TV.
[UH7100-QSG]BN68-05937E-02ENG.indb 3 2014-09-30 10:56:10
3
Connection panel on
the back of the TV
Connect
* Recommended Connections
After you have connected all
your external devices, plug the
TV’s power cord into the back
of the TV. DO NOT plug it into
a wall outlet until you have
reached Section 7, Initial Setup.
Internet
Connect here with an Ethernet cable or
wirelessly later during the Initial Setup.
TV signal
Connect your
coaxial cable to the
Antenna In port.
[UH7100-QSG]BN68-05937E-02ENG.indb 4 2014-09-30 10:56:11
Cable/Satellite/DVR
Connect your Cable box or
digital video recorder with an
HDMI cable.
Loading...