INSTALLATION AND OPERATION MANUAL TMC-F SERIES
TMC-F Series
10/100 MBPS ETHERNET 2 PORT MEDIA CONVERTER
This manual serves the
following Model Names:
TMC-FSTM1ACM-A
TMC-FSTS1ACM-A
TMC-FSTM1POEM-A
TMC-FSTS1POEM-A
TMC-FSTM1-B
TMC-FSTS1-B
TMC-FSCM1ACM-A
TMC-FSCS1ACM-A
TMC-FSCM1POEM-A
TMC-FSCS1POEM-A
TMC-FSCM1-B
TMC-FSCS1-B
TMC-FSFPPOE30M
1 CHANNEL: ELECTRICAL
The TMC-F series converts 10/100 Mbps Fast Ethernet from an electrical signal to an
optical signal and back to an electrical signal. The electrical connection uses an RJ45
data connector.
Depending on the specific model in use, the optical connector is either a ST or SC, 1
or 2 Fibers, multimode (M) or singlemode (S), and the unit operates on either AC /
DC or DC only power.
The TMC-F Series standard size units may be directly plugged into the SBP-C14 or
SBP-C03 Racks or operated as a standalone module. The TMC-F-M small size units
operate as standalone modules only.
OPTICAL
1
INS_TMC-F_REV– 08/12/19 PAGE 1
INSTALLATION AND OPERATION MANUAL TMC-F SERIES
FIGURE 1 – TMC-F SERIES STANDARD SIZE UNIT
MULTIMODE OR
SINGLE MODE
OPTICAL FIBER
BLACK
BLACK WITH WHITE STRIPE
FIGURE 2 – TMC-F SERIES STANDARD SIZE UNIT
REAR PANELFRONT PANEL
NOTE: Remove Electrical Connector for Rack Mount Units
INS_TMC-F_REV– 08/12/19 PAGE 2