Samsung WT90H2, SWT80H0, SWT80H0P, SWT80H1, SWT80H1P Owner's Instructions Manual

BEFORE USING THE WASHER

● In case of pump drained washer,

remove the cap-hose from
the drain hole.

CAUTIONS

●

Be sure that the washer is grounded.

To avoid electrical shock,use
a metal pipe for the ground
connection. But, don't ground
the washer with gas pipes or
telephone lines to avoid
dangers of explosion or lightning strike.

●

Do not put your hands into the spin

dryer basket when it is spinning.

Your fingers can be caught
by spinning laundry and
damaged.

●

Never allow children to operate

or play with the washer .

Children playing with the washer
may accidentally fall into the
washing tub.

●

Disconnect the power cord from the

power supply when not in use.

●

Ventilation

by carpeting when the washing machine is
installed on a carpeted floor .

●

If the supply

it must only be replaced by a repair shop
appointed by the manufacturer ,because
special purpose tools are required.

● W arningto avoid overfilling and damages

this appliance must be filled with the operator
present using a moderate water supply
pressure only .

opening must not be obstructed

cord of this appliance is damaged,

PRECAUTIONS WHEN OPERATING

●

Don't use excessively hot water.
(50˚C or more)

Plastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.

●

Before washing,check all pockets.

If nails or pins remain in pockets,they may
damage the washer or clothes.

●

Close the water tap a little if the

water pressure is too high.

●

Be sure to cover with the inner

cover on laundry before spinning.

This prevents laundry from
being tossed out and damaged.

●

To avoid water splashes,

close the wash tub lid.

●

Be sure lay the drain hose down
(in case no drain pump)

●

Never splash water on the control panel.

1

DESCRIPTION OF PARTS

SPIN DRYER LID

When you open this lid while
the spin basket is spinning,
the spinning will be stopped
by brake system.

INNER LID

DRAIN HOSE

(WITH PUMP)

LINT FILTER

WASH TUB

WASH TUB LID

Be sure to keep the lid
closed during washing

and spinning.

WATER DRAIN HOSE

(WITHOUT PUMP)

POWER CORD

The plug’s shape may not
correspond with this drawing.

SPIN DRYER
BASKET

PULSATOR

DRAIN FILTER
(with pump)

1. WASH

This is used to select wash action.

SELECTOR

2. WASH TIMER

This is used to set the wash time, 1-15 minutes.

3. CYCLE SELECTOR

This is used to select the Washing /

Rinsing or draining

1 2 5 3 4

CONTROL PANEL

4. SPIN DRY TIMER

This is used to set the spin time, 1-5 minutes.(or 1-10 minutes)

5.WATER SELECTOR

During washing,WATER SELECTOR KNOB should

be selected to wash.During spin rinsing,WATER
SELECTOR KNOB should be selected to spin.

2

W ASHING PROCEDURE

TO WASH

1. Before starting washing, check the following;

Connect the water supply hose and open the water tap.

- Lay the drain hose down toward a sinkhole.
(In case no drain pump)

- Place the drain hose in sink or bath.
(In case drain pump)

-Connect the power cord to the power supply outlet .

2. Set the WASH SELECTOR KNOB
to the desired mode.

3. Set the CYCLE SELECTOR KNOB to

‘WASH

4. Set the WATER SELECTOR
KNOB to WASH .

●

RINSE’. (In case drain pump “WASH”)

FOR B TYPE

6. Fill water in the wash tub
and add the detergent.

7. Set the WASH TIMER 1-15minutes.

8. After washing,set the
CYCLE SELECTOR KNOB
to ‘DRAIN’ for drain.

5. Load laundry in the
wash tub.

SPIN DRY

1. Transfer the clothes into the spin basket
and arrange the clothes evenly.

close the inner lid.

inner lid

safty cover

3. Close the spin dryer lid.

4. Set the SPIN DRY TIMER 1-5minutes.2. Be sure to attach the safety cover and
(or 1-10minutes)

3