Samsung SMA5108 User Manual

DRAFT

User manual

SM-A5108

Important safety precautions

Failure to comply with the following precautions may be dangerous or illegal.

Copyright information

● Bluetooth is a registered trademark of the Bluetooth SIG, Inc. worldwide.

● Java TM is a trademark or registered trademark of Sun Microsystems, Inc.

● Picsel and Picsel Viewer TM are trademarks of Picsel Technologies, Inc.

Drive safely at all times

Do not use a hand-held phone while driving. Park your vehicle first.

Switch off the phone when refueling

Do not use the phone at a refueling point (service station) or near fuels or chemicals.

Switch off in an aircraft

Wireless phones can cause interference. Using them in an aircraft is both illegal and
dangerous.

Switch off the phone near all medical equipment

Hospitals or health care facilities may be using equipment that could be sensitive to
external radio frequency energy.
Follow any regulations or rules in force.

Interference

All wireless phones may be subject to interference, which could affect their performance.

Be aware of special regulations

Meet any special regulations in force in any area and always switch off your phone
whenever it is forbidden to use it, or when it may cause interference or danger.

Water resistance

Your phone is not water-resistant. Keep it dry.

Sensible use

Use only in the normal position (held to your ear). Avoid unnecessary contact with the
antenna when the phone is switched on.

Emergency calls

Key in the emergency number for your present location, then press [ ].

Keep your phone away from small children

Keep the phone and all its parts, including accessories, out of the reach of small children.

Accessories and batteries

Use only Samsung-approved batteries and accessories, such as headsets and PC data
cables. Use of any unauthorized accessories could damage you or your phone and may
be dangerous.

• The phone could explode if the battery is replaced with an incorrect type.

• Dispose of used batteries according to the manufacturer’s instructions.

Excessive exposure to sound at high volumes can cause hearing damage.
Always turn the volume down before plugging the earphones into an audio source and

use only the minimum volume setting necessary to hear your conversation or music.

Qualified service

Only qualified service personnel may repair your phone.
For more detailed safety information, see "Health and safety information" on page 20.

U

n

s

e

t

o

t

e

a

e

h

a

b

b

c

o

e

s

a

n

p

t

a

m

a

c

a

r

y

e

a

/

t

c

e

e

e

e

a

s

m

r

e

,

a

e

t

p

a

e

u

s

t

c

e

w

e

d

e

t

u

a

m

t

y

r

l

o

e

pa

k

Make

• Phon

• Adap

• Stere

• User’

Sui

for

You ca

• Multi

• Trav

• Car c

• PC d

• Porta

• Porta

• Musi

• Bluet

ure you h

er

headset

s manual

able Adapte

ach countr

n obtain th

dapter

l charger

arger

ta cable

le battery
le PC dat

controller

oth mono

ve each it

or Charger
in use.

following

kit

cable

stereo he

m

certified ac

accessori

dset kit

ording to th

s for your

e relevant s

phone fro

fety standa

your loca

d, will be pr

l Samsung

vided

dealer.

G

First

Inst

1. Plug

2.

Plug
Whe

3.
ada

4. Rem

Low

When

• a war

• the b

• the e

If the b
battery

t s

teps to

ll and

the adapt
the adapt

the phon

ter from th

ove the ad

battery

he battery
ning tone

ttery low

pty batte

ttery level

.

art

operate

harge

r into the
r into a st

is compl
power o
pter from

indicat

is low:

ounds,

essage di

y icon [

becomes

d

your ph

he pho

hone.
ndard AC

tely charg

tlet.

the phone.

plays, an

] blinks.

oo low, th

one

ne

all outlet.

d (the bat

phone a

ery icon s

tomaticall

ops blinkin

turns off.

g), unplug

Recharg

the

your

Keys and display

Buttons Function

• Press and hold to turn the device on or off.

• Press and hold for more than 7 seconds to reset the device if it

Power

Menu

Home

Back • Tap to return to the previous screen.

Volume • Press to adjust the device volume.

has fatal errors or hang-ups, or freezes.

• Press to lock or unlock the device. The device goes into lock
mode when the touch screen turns off.

• Tap to open a list of options available for the current screen.

• Tap and hold on the Home screen to launch Google
application.

• Press to return to the Home screen.

• Press twice to launch S Voice application.

• Press and hold to open the list of recent applications.

Overview of menu functions

To access Menu mode, press [Settings] in ldle mode.

Call log Samsung Link Local

Phone Group Play Navigation

Contacts S Health Downloads

Messaging S Voice Optical Reader

S Memo Messenger Gmail

Samsung Apps S Translator Play Books

WatchON Email Play Movies & TV

Camera Shopping & wallet Chrome

Gallery App Guide Maps Story Album

Music Google Samsung service

Video Voice Search Help

Internet YouTube Calculator

Clock Talk Voice Recorder

S Planner Google+ Dictionary

Settings Play Store My Files

Google Settings

Solve problems

Help and personal needs

To save the time and expense of an unnecessary service call, perform the simple checks
in this section before contacting a service professional.

When you switch on your phone, the following messages may appear:

“Insert USIM card”

• Be sure that the USIM card is correctly installed.

“Phone locked Enter password”

• The automatic locking function has been enabled. You must enter the phone's
password before you can use the phone.

“Enter PIN1”

• You are using your phone for the first time. You must enter the PIN1 supplied with the
USIM card.

• The PIN1 Check feature is enabled. Every time the phone is switched on, the PIN1 has
to be entered. To disable this feature, use the PIN check menu.

“Enter PUK”

• The PIN1 code has been entered incorrectly three times in succession, and the phone
is now blocked. Enter the PUK1 supplied by your service provider.

“No Service” “Network Failure,” or “Not Done” displays

• The network connection has been lost. You may be in a weak signal area. Move and try
again.

• You are trying to access an option for which you have no subscription with your
service provider. Contact the service provider for further details.

You have entered a number but it was not dialed

• Be sure that you have pressed [ ].

• Be sure you have accessed the right cellular network.

• Be sure that you have not set an outgoing call barring option.

Your correspondent cannot reach you

• Be sure your phone is switched on. ( [ ] pressed for more than one second.)

• Be sure you are accessing the correct cellular network.

• Be sure that you have not set an outgoing call barring option.

Your correspondent cannot hear you speaking

• Be sure you have switched off the microphone.

• Be sure you are holding the phone close enough to your mouth. The microphone is
located at the bottom of the phone.

The phone starts beeping and "LOW BATTERY " flashes on the display

• Your battery is insufficiently charged. Recharge the battery.

The audio quality of the call is poor

• Check the signal strength indicator on the display ( ).
The number of bars indicates the signal strength from strong ( ) to weak ( ).

• Try moving the phone slightly or moving closer to a window if you are in a building.

No number is dialed when you re-call a Contacts entry

• Use the Contact Search feature to ensure the number has been stored correctly.

• Re-store the number, if necessary.

If the above guidelines do not help you to solve the problem, take note of:

• The model and serial numbers of your phone

• Your warranty details

• A clear description of the problem

Then contact your local dealer or Samsung after-sales service.

Health and safety information

Exposure to Radio Frequency (RF) Signals

Certification Information (SAR)

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured
not to exceed the exposure limits for radio frequency (RF) energy set by the Federal
Communications Commission (FCC) of the U.S. government. These FCC exposure limits
are derived from the recommendations of two expert organizations, the National Counsel
on Radiation Protection and Measurement (NCRP) and the Institute of Electrical and
Electronics Engineers (IEEE). In both cases, the recommendations were developed by
scientific and engineering experts drawn from industry, government, and academia after
extensive reviews of the scientific literature related to the biological effects of RF energy.

The exposure limit set by the FCC for wireless mobile phones employs a unit of
measurement known as the Specific Absorption Rate (SAR). The SAR is a measure of
the rate of absorption of RF energy by the human body expressed in units of watts per
kilogram (W/kg). The FCC requires wireless phones to comply with a safety limit of 1.6
watts per kilogram (1.6 W/kg). The FCC exposure limit incorporates a substantial margin
of safety to give additional protection to the public and to account for any variations in
measurements.

SAR tests are conducted using standard operating positions accepted by the FCC with
the phone transmitting at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level
of the phone while operating can be well below the maximum value. This is because the
phone is designed to operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to a wireless base station
antenna, the lower the power output.

Before a new model phone is available for sale to the public, it must be tested and
certified to the FCC that it does not exceed the exposure limit established by the FCC.
Tests for each model phone are performed in positions and locations (e.g. at the ear and
worn on the body) as required by the FCC.

For body worn operations, this model phone has been tested and meets the FCC
exposure guidelines when used with a Samsung accessory designated for this product or
when used with an accessory that contains no metal and that positons the handset a
minimum 1.5 cm from the body.

Non-compliance with the above restrictions may result in violation of FCC RF exposure
guidelines.