In-ceiling Housing
Installation Manual |
SHD-3000F1 |
|
Table Of Contents
Overview
What’s Included
Installation Instructions
Installation (indoor type)
Installation (outdoor type)
Product Specifications
3
3
4
4
8
12
_ SHD-3000F1
Overview
This In-CEILING HOUSING is a mounting ADAPTOR that is designed to mount the smart dome camera in built-in style on a double-layer ceiling.
What’s Included
ENG
HOUSING |
SAFETY BRACKET (1EA) |
SAFETY WIRE (1SET) |
||
|
|
|
|usvjr |
|
|
|
|
svjr |
|
|
|
|
|usvjr |
|
TEMPLATE (1EA) |
outdoor type (3EA) |
Lower bracket (exclusively for |
||
indoor type (2EA) |
indoor dome cameras) (1EA) |
|||
|
|
|||
In-ceiling Housing |
|
|
|
|
Installation Manual |
SHD-3000F1 |
|
|
INSTALLATION MANUAL
SHD-3000F1 _
Installation Instructions
1.Select an installation position or place that can endure more than 4 times of the total weight of the installation structure.
. At least 250mm or more of spare height is required above the CEILING BOARD. 3. CEILING BOARD’s thickness should be less than 40mm.
. Be sure to secure the SAFETY WIRE to avoid a product fall.
. If you want to attach the camera to the ADAPTOR, use the only provided SCREWS.
More250mmthan 250mm
CEILING BOARD Less40mmthan 40mm
Installation (indoor type)
1. Place the TEMPLATE on the CEILING BOARD and drill a guided hole.Remove the round filling (“C”) from the TEMPLATE.
2 Place TEMPLATE A onto the CEILING BOARD to which you will attach the ceiling mount ADAPTOR and drill a hole of Ø198mm in diameter.
See the figure below for the hole shape.
Ø198mm
Ø198mm
CEILING BOARD
TEMPLATE
_ SHD-3000F1
. Fix the ANCHOR BOLT onto the concrete CEILING, and secure the SAFETY WIRE to the
ANCHOR BOLT as below:
Tighten the nut (“N1”) on the ANCHOR BOLT.
2 Insert the provided SAFETY BRACKET into the ANCHOR BOLT. 3 Tighten two nuts (“N2”,”N3”) onto the ANCHOR BOLT.
4 Hook and fix one end of the SAFETY WIRE onto the SAFETY BRACKET.
5 Hook and fix the other end of SAFETY WIRE onto the HOUSING as shown below.
|
Nut(N1) |
ANCHOR |
BOLT |
|
Safety BRACKET |
||
|
|
|
|
|
Nut(N2,N3) |
|
|
|
|
|
|
SAFETY WIRE |
|
|
|
ANCHOR BOLT |
|
|
|
|
|
|
|
CEILING |
|
|
|
|
CEILING |
|
HOUSING
The ANCHOR BOLTs and nuts are optional and not included in the product package.
3.To connect to the camera, insert the external cable through the side hole on the housing to the inside of the housing as shown in the figure.
M Refer to the installation manual of the camera that you want to install, and prepare necessary cables for camera connection.
ENG
HOUSING
CEILING
HOUSING
Hole
External Cable
SHD-3000F1 _