Samsung SHD-100C User Manual

INSTALLATION MANUAL – SHD-B-100C Heavy Duty Corner Mount

Compatible Model List

SNV-5084, SNV-5084R, SNV-6084, SNV-6084R,
SNV-7084, SNV-7084R, SNV-8080

¼-20 x 1/2” Tamper­Resistant Torx Screw (x3) and
1/4” Flat Washer (x3)

Cover

Mounting Plate

Backbox

#8-32 x 3/8” Phillips Head Screws (x4)
and #8” Flat Washer (x4)

Notches (x2)

Tabs (x3)

Unpacking

Unpack carefully. This is mechanical equipment and should be
handled with care. If an item appears to have been damaged in
shipment, replace it properly in its carton and notify the shipper. If
any items are missing, notify Broadsight Systems, Inc. The shipping
carton is the safest container in which the unit may be transported.
Save it for possible future use.

Service

If the unit ever needs repair service, the customer should contact
Broadsight Systems, Inc. for a return materials authorization (RMA)
and shipping instructions.

Care and Maintenance

Perform routine maintenance to keep the unit dust free.

Model Designation

SHD-B-100C Heavy Duty Corner Mount

Description

The Heavy Duty Corner Mount is designed to mount a camera in the
corner of a room that requires maximum protection to the camera.
The unit is designed to accommodate multiple camera models.

Hardware Kit – SBD-B-100C

None

Tools Required

TT-27 Tamperproof Torx Bit or Wrench
Cross Recessed (Phillips Head) Screwdriver
Camera Mounting Hardware
Backbox Mounting Hardware
Appropriate Sized Drill Bits

Certification

Camera installation should be performed by a licensed professional
and conform to the National Electrical Code (NEC) and any applicable
local codes.

Installation

1. Remove Cover by loosening three (3) Tamper Resistant screws

using the designated Torx bit or wrench. Set cover aside.

2. Remove Mounting Plate by loosening four (4) #8-32 screws and

washers. Lift Mounting Plate slightly to unhook it from Backbox.

3. Hold Backbox up to installation surface and use holes in Backbox

as a template. Mark hole locations for drilling.

4. Set Backbox aside and drill out mounting surface as needed.

5. Attach Backbox to mounting surface using appropriate anchors

and fasteners. Each fastener should have a minimum 200 lbs
pull-out strength. Run cable into backbox.

6. Attach compatible camera to the Mounting Plate using

appropriate fasteners. Make power/video/data connections to
the camera.

7. Reinstall Mounting Plate by slipping Captive Fastener heads over

the Notches in the Backbox. Secure Mounting Plate by
reinstalling #8-32 screws and washer (from Step 2).

8. Carefully slide Cover over the dome bubble (not shown); avoid

scratching the dome bubble. Align holes in Cover with Tabs in
Backbox. It may be safest to leave the plastic film on the dome
bubble as long as possible.

9. Secure Cover by replacing ¼-20 Tamper Resistant fasteners and

washers (from Step 1).

Made in the USA by Broadsight Systems, Inc. for Samsung Techwin Page 1 of 2

Dimensional Drawings

(Units: Inches)

Made in the USA by Broadsight Systems, Inc. for Samsung Techwin Page 2 of 2