Samsung SGH-B3310, GT-B3310 Direy
Disassembly and Assembly Instructions
11.
1
1) Remove the battery cover and the battery
1) Be careful not to occur any damages and scratches.
1) Unscrew 6 screw points.
2
2) Unlock the set from the top to the bottom.
1) Be careful not to occur any damages and scratches.
2) Be careful not to change shape of the REAR during
disassembly.
1) Remove the Slide FPCB Connector from the
3
the board.
1) Be careful not to occur any damages to the slide
FPCB.
4 1) Unscrew the 1 point below the speaker.
2) Unscrew the 1 point beside the RF S/W.
①
②
1) Be careful not to occur any damages to components
around screws during disassembly.
11-1
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Exploded View and Parts List
5
1) Take apart the Slide FPCB to the
Front.(Double Sided tape)
2) Unscrew 8 screw points.
1) Remove the screw caps,①~②
6
2) Unscrew 8 screw points.
3) Take apart the Lower
①
②
1) Be careful not to occur damages to the SLIDE FPCB.
2) Be careful not to occur any damages to parts of the
FRONT and the FPCB during disassembly.
1) Remove the friction tape which holds the LCD
7
FPCB.
2) Open the FPCB actuator.
3) Remove the Main Slide FPCB carefully.
(Notice that there is a double sided friction tape
at the bottom.
①
②
1) Be careful not to occur any damages and scratches.
2) Be careful not to occur any damages to parts of
the Lower and the FPCB during disassembly.
8
1) Remove the NUM KEY FPCB actuator.
2) Disassemble the whole after removing the
motor by tweezers
①
②
①
③
②
1) Remove with rounded tweezers.
2) Be careful not to occur any damages and scratches
to FPCB (It could be torn.)
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
1) Remove with rounded tweezers.
2) Be careful not to occur any damages and scratches
to the FPCB.
11-2
Loading...