Samsung SF5600 Reference Information

CCHAPTER 2

Installation

2-1

Chapter 2 INSTALLATION

2.1 INSTALLATION PROCEDURE

Please install the machine according to the following flow chart.

START

UNPACK

INSTALL THE FAX MACHINE

CLEAR ALL MEMORY

SET SYSTEM DATA IN USER MODE

SET SYSTEM DATA IN TECH MODE

CONFIRM SYSTEM DATA SETTING

MACHINE ORIENTATION FOR USERS

END

2-2

2.2 UNPACKING

Open the carton and remove the fax machine and accessories. Check the contents to see if anything is
damaged or missing in reference to the figure below.

2-3

2.3 Installation

Choose a proper location for the fax machine, then install the machine according to the following
description.

2.3.1 INSTALLATION LOCATION

Please do not install your facsimile machine where there is a danger of:

1. Overheating

- Allow at least 10 Inches clearance from the top and the side of your unit.

- DO not Install your unit In direct sunlight.

2. Improper Ventilation

- Do not block the ventilation openings or the exhaust fan.

3. Others

- Do not place it in airtight room.

- Do not place it where water or chemical splashes may occur.

- Do not place it near an air conditioner, or in a dusty enviroment.

- Keep your fax unit on a level, vibration-free surface.

Note: Protect your unit from excessive neat and humidity. Use it in a normal
room temperature (10°C - 30°C, 30 % - 80 % RH)

2.3.2 INSTALLATION OF THE TONER CARTRIDGE

1. Take the toner cartridge out of its protective bag, and remove
the shield cover. Remove the green shield cover from the
toner unit.

2. Remove the sealing tape at the side of the toner unit by
pulling it straight out. Be careful not to tear it off.

3. Hold the toner cartridge in both hands with the green tabs on
the top of the unit Rotate the cartridge several times gently
from side to side to distribute the toner inside the unit evenly.

2-4

4. Open the top cover by lifting up the cover release
lever.

5. Holding the cartridge in both hands, fit the two tabs
on the bottom of the cartridge into the grooves
(marked by green label) on both sides of the
compartment, and slide it down into your fax
machine.

2.3.3 INSTALLATION OF THE FUSER FELT

1. Take the fuser felt out of its protective bag.2. Grasp the

tab as shown and pull it towards you.

3. Holding the handle of the fuser felt, insert it into the
slot indicated by the green arrows.

Lift it up

Fit it into the groove.

Fit it down.

2-5

4. Slide it down until it snaps in place.

2.3.4 INSTALLATION OF THE DRUM CARTRIDGE

The drum cartridge is photosensitive. Exposing it to light may damage the drum and result in poor print
quality. Do not open the drum cartridge's protective bag until you have read the following instructions and
are ready to install the drum.

Warning !

Do not expose the drum cartridge to direct room light or sunlight for more than a few minutes.
Do not place the drum cartridge near a window or in an area subject to high heat (above 50°C) or high

humidity (above 80% RH).

Do not touch the drum surface. Lift the drum cartridge by the handle only.

Keep the drum cartridge away from dust and dirt.

1. Take the drum cartridge out of its protective bag.

2. Lower the tap cover half-way. It makes the cartridge
easier to install.

3. Holding the handle of the drum cartridge, fit the
narrow tabs at both ends of the cartridge in the
grooves indicated by green bar.

Fit it into the
groove.

Insert the fuser felt
here