Samsung SC-8421 User Manual

Operating Instructions
VACUUM CLEANER
Before operating this unit, please read the instructions carefully.
Indoor use only.
Register your product at www.samsung.com/register
DJ68-00321M REV(0.5)

IMPORTANT SAFEGUARDS

1. Read all instructions carefully. Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate on the bottom of the cleaner.
2. WARNING: Do not use the vacuum cleaner when rug or floor is wet.
Do not use to suck up water.
3. Close supervision is necessary when any appliance is used by or near children. Do not allow the vacuum cleaner to be used as a toy. Do not allow the vacuum cleaner to run unattended at any time. Use the vacuum cleaner only for its intended use as described in these instructions.
4. Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full in order to maintain the best efficiency.
5. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour the plastic parts of the unit.
6. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the cleaner parts. Do not stand on the hose assembly. Do not put weight on the hose. Do not block the suction or the exhaust port.
7. Switch the vacuum cleaner off on the body of the machine before unplugging from the electrical outlet. Disconnect the plug from the electrical outlet before changing the dust bag or dust container. To avoid damage, please remove the plug by grasping the plug itself, not by pulling on the cord.
8. This appliance is not intended for use by persons (including children) with reduced physi-
cal, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person respon­sible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
9. The plug must be removed from the socket outlet before cleaning or maintaining the appli­ance.
10. The use of an extension cord is not recommended.
11. If your vacuum cleaner is not operating correctly, switch off the power supply and consult an authorized service agent.
12. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
13. Don’t carry the vacuum cleaner by holding the hose.
Use the handle on the vacuum cleaner set.

ASSEMBLING THE CLEANER

1
OPTION
OPTION
Features may vary according to model.
CAUTION :
Please do not use dust bin handle when carrying machine.
For storage, park the floor nozzle.

OPERATING THE CLEANER

2
2-1 ON/OFF SWITCH 2-2 POWER CORD
2-3 POWER CONTROL (INFRARED CONTROL)
1) REMOTE CONTROL TYPE
- HOSE
SENDER
HANDLE CONTROL
1. Vacuum cleaner ON/OFF Press the ON/OFF button to operate the vacuum cleaner. Press again to stop the vacuum cleaner.
2. Vacuum cleaner MIN/MID Press the MIN/MID button to operate the vacuum at a low level (for curtain cleaning, etc.). Press again to operate the vacuum in a MID mode.
3. Using at MAX Press the MAX button to operate the vacuum at maxi­mum intake.
NOTE
When removing the plug from the electrical outlet, grasp the plug, not the cord.
- BODY
OPTIONAL - DIGITAL SIGNAL
POWER CONTROL
RECEIVER
Press the power control button repeatedly to select the correct mode. (ON(MIN) MID MAX OFF)
NOTE : If the remote handle control is not
working, the cleaner can be operated using the control button on the body of the machine.
2) BODY-CONTROL TYPE
- HOSE
- BODY
To reduce suction for cleaning draperies, small rugs, and other light fabrics, pull the tap air until the hole is open.
MIN = For delicate surface e.g. net curtains. MAX = For hard floors and heavily soiled carpets.
2-4 HOW TO USE AND MAINTAIN THE ACCESSORIES
Features may vary according to model.
PIPE
Adjust the length of the telescopic pipe by sliding the length control button locat­ed in the center of the telescopic pipe back and forth.
ACCESSORY
To check for blockages, separate the tele­scopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube.
Push the accessory on to the end of the hose han­dle.
Pull out and turn the dust­ing brush for cleaning deli­cate areas.
To use the upholstery tool, push the accessory on to the end of the hose handle in the opposite direction.
ELBOW EXTENDING TUBE
(OPTION)
1234 5
1. Connect the elbow extending tube to connecting part for hose knob and telescopic pipe.
2. Fit the telescopic pipe to the lower part of the elbow extending tube.
3. Press the PUSH button.
4. With the PUSH button pressed, the elbow extending tube is folded.
5. Using the elbow extending tube allows hard to reach areas (e.g. under furniture)to be cleaned without having to kneel down.
4
OPTION
OPTION
Carpet
Cleaning
Floor
Cleaning
Adjust the inlet lever according to the floor surface.
Vacuum dust in wide area at once
Remove waste matter completely if the inlet is blocked.
Remove waste matter completely if the inlet is blocked.
OPTION
For improved pick-
up of pet hair and
fibre on carpets
OPTION
Brush for blanket
For picking up pet hair and fibre on upholstery and bed linen.
Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. In this case, clean the drum with care.
1 2 3
Remove waste matter
Push the Open button of the transparent screen cover to separate the cover.
4
Remove dust inside the brush housing using a dry duster or crevice tool.
Clogs on turbine keeps brush from turning, and in this case, take care of it.
Remove waste matter com­pletely when inlet is blocked.
Warning : Use for bedclothes only. Be cautious not to damage brush during unclogging.
Turn the lock button to ‘UNLOCK’, and remove waste matter.
Remove the brushbar from the transparent screen.
5
Insert brushbar into rotating belt and assemble.
Turbine
Brush
such as dust and hair tangled around the brushbar using scissors.
6
Click the transparent screen cover back into place to reassemble.
To reassemble, align the cover to the front of the main body and close. After closing the cover, ensure that the lock button is turned to the ‘LOCK’ position.
5
CLICK

EMPTYING THE DUST BIN

3
1 2 3
Once dust reaches the dust full mark, or once the dust full light is on, empty the dust bin.
4 5
Throw away dust in the bin.
- Empty into a plastic bag (recommended for asthma/allergy sufferers)
Close the dust bin cover.
Take the dust bin out by pressing the button.
Before use, push the dust bin into the main body of the vac­uum cleaner until you hear the "click" sound.
Separate the dust bin cover.
NOTE
You may rinse the dust bin with cold water
6

CLEANING THE DUST PACK

4
4-1. WHEN TO CLEAN THE DUST PACK
- If suction is noticeably reduced during cleaning, please check the dust pack as indicated below.
Suction is significantly weakened during cleaning. Shaking sound of inlet stuck to the floor (soft mats, blankets, etc.) is heard.
SENDER
Turn the vacuum power to 'MAX'
HANDLE CONTROL
If the filter check indicator turns red with the inlet floating 10 cm above flat floor, clean it.
When the indicator light comes on, please empty the Dust Pack(4-2) as shown in the fol­lowing illustrations.
Loading...
+ 16 hidden pages