copyright laws.
No part of this guide may be reproduced,
distributed, translated, or transmitted
in any form or by any means, electronic
or mechanical, including photocopying,
recording, or storing in any information
storage and retrieval system, without
the prior written permission of Samsung
Electronics.
5
Trademarks
• SAMSUNG and the SAMSUNG logo
are registered trademarks of Samsung
Electronics.
• Bluetooth
Bluetooth SIG, Inc. worldwide.
• Wi-Fi
Direct
logo are registered trademarks of the Wi-Fi
Alliance.
Your device uses a non-harmonised
frequency and is intended for use in all
European countries. The WLAN can be
operated in the EU without restriction
indoors, but cannot be operated outdoors.
• All other trademarks and copyrights are
the property of their respective owners.
6
is a registered trademark of
®
, Wi-Fi Protected Setup™, Wi-Fi
®
, Wi-Fi CERTIFIED™, and the Wi-Fi
™
Getting started
Volume
Device layout
button
Power button
Light sensor
Touch screen
Menu button
Home button
Front camera
IrLED
Speaker
Multipurpose
jack
Memory card
slot
SIM card slot
Back button
7
Getting started
Microphone
Rear camera
S Pen
Flash
Do not cover the antenna area with
your hands or other objects. This may
cause connectivity problems or drain
the battery.
8
Headset jack
Speaker
GPS antenna
Getting started
Installing the SIM or USIM card
Insert the SIM or USIM card provided by the
mobile telephone service provider.
• Only microSIM cards work with the
device.
• Some LTE services may not be
available depending on the service
provider. For details about service
availability, contact your service
provider.
Open the cover of the SIM card slot.
1
Insert the SIM or USIM card with the gold-
2
coloured contacts facing downwards.
9
Getting started
Push the SIM or USIM card into the slot
3
until it locks in place.
Close the cover of the SIM card slot.
4
Charging the battery
Before using the device for the first time
or when the battery has been unused for
extended periods, you must charge the
battery.
Use only Samsung-approved
chargers, batteries, and cables.
Unapproved chargers or cables can
cause the battery to explode or
damage the device.
The USB 3.0 cable can be used to
charge the device, but it may not be
supplied with the device depending
on the region or service provider.
10
Getting started
Connect the USB cable to the USB power
adaptor and then plug the end of the USB
cable into the multipurpose jack.
When using a USB 2.0 cable, plug the USB
cable into the right side of the multipurpose
jack as shown in the image below.
11
Getting started
Connecting the charger improperly
may cause serious damage to
the device. Any damage caused
by misuse is not covered by the
warranty.
After fully charging, disconnect the device
from the charger. First unplug the charger
from the device, and then unplug it from the
electric socket.
To save energy, unplug the charger
when not in use. The charger does
not have a power switch, so you must
unplug the charger from the electric
socket when not in use to avoid
wasting power. The charger should
remain close to the electric socket
and easily accessible while charging.
12
Getting started
Checking the battery charge
status
When you charge the battery while the
device is off, the following icons will show
the current battery charge status:
ChargingFully charged
Turning the device on and off
When turning on the device for the first
time, follow the on-screen instructions to set
up your device.
13
Getting started
Press and hold the Power button for a few
seconds to turn the device on and off.
Viewing the user manual
The user manual provides complete
information about operating your device.
You may incur additional charges
for accessing the Internet or
downloading media files. For details,
contact your service provider.
14
Loading...
+ 28 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.