Samsung SAM335 User Manual

English

Class B Digital Device or Peripheral

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inter ference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or experienced radio TV technician for help.

CAUTION: Changes or modifications not expressly approved by the manufacturer

responsible for compliance could void the user's authority to operate the equipment

iii

Before Starting

This manual is for AceLink ADSL modem users. This book includes from the introduction to installation, and problem solutions.

We recommend that the user read this guide carefully before operation of equipment. If already familiar with the ADSL modem or similar systems, please read the notices in the explanations for review.

If you encounter any problems or have any questions, please contact the service provider.

About Manual

Following contents are described in each chapter of AceLink ADSL modem manual.

Chapter 1 ‘Introduction’ describes the main functions of the AceLink ADSL modem,

as well as its applications, hardware structure, and specifications

Chapter 2 ‘AceLink ADSL Modem Setup’ examines what the user must know

before installation, and describes the AceLink ADSL modem setting environment and connection to network.

Appendix A ‘Troubleshooting’ describes major problems in using the AceLink ADSL

modem, and solutions.

Appendix B ‘Cable Specifications’ describes every sort of cable specification that is

needed for installation of AceLink ADSL modem.

Appendix C ‘Description of Terms ’ explains terminology that you need to know

during the use of AceLink ADSL modem.

Contents

Chapter 1 Introduction ...............................................1-1~1-7

Introduction to AceLink ADSL modem ................................................1-2

Name and Function of each part...........................................................1-3

Front View................................................................................................. 1-3

Rear View.................................................................................................. 1-4

AceLink ADSL modem specifications................................................... 1-5

Software Specifications

Chapter 2 AceLink ADSL Modem Setup..................... 2-1~2-13

Before Installation.................................................................................2-2

Safety Check............................................................................................. 2-2

Service Environment Check.................................................................... 2-3

Preparing cables.....................................................................................2-4

Modem Setting Environment................................................................... 2-6

Checking the Contents...........................................................................2-7

Modem Setup ......................................................................................... 2-8

1. Drawing the Network Configuration....................................................2-9

2. Power Disconnection.......................................................................... 2-10

3. Connecting Ethernet Cables.............................................................. 2-10

4. POTS Micro-filter Connection........................................................... 2-11

5. Power Connection...............................................................................2-12

6. Checking all the Connections............................................................. 2-13

............................................................................... 1-7

Appendix

A Troubleshooting.........................................A-1~A-3

Points You Must Know before Inquiring at the Place Where

You Purchased........................................................................................A-1

Troubleshooting - Problems and Solution .............................................A-2

B Cable Specifications...................................B-1~B-3

Twisted pair Category-3,4,5 Straight-through Ethernet Cable...............B-1

Telephone Cable (RJ-11)...........................................................................B-3

C Description of Terms.................................. C -1~C-4

Figure Contents

Figure 1-1 Front view of AceLink ADSL modem.............................................................. 1-3

Figure 1-2 Rear view of AceLink ADSL modem................................................................1-4

Figure 2-1 RJ-11 telephone cable........................................................................................ 2-5

Figure 2-2 RJ-45 UTP Ethernet Cable............................................................................... 2-5

Figure 2-3 AceLink modem package..................................................................................2-7

Figure 2-4 Example of network configuration.................................................................... 2-9

Figure 2-5 Ethernet Cable Connection............................................................................. 2-10

Figure 2-6 POTS micro-filter connection......................................................................... 2-11

Figure 2-7 Power adapter connection............................................................................... 2-12

Figure B-1 Twisted pair Category-3,4,5 Straight-through cable.......................................B-1

Figure B-2 Twisted pair Category-3,4,5 Straight-through cable connector signal...........B-2

Figure B-3 Pin connection of Twisted pair Category-3,4,5 Straight-through

cable connector.................................................................................................B-2

Figure B-4 RJ-11 telephone cable.......................................................................................B-3

Table Contents

Table 1-1 AceLink ADSL modem's LED functions............................................................ 1-3

Table 1-2 AceLink ADSL modem's port functions............................................................. 1-4

Table 1-3 Hardware specifications of AceLink ADSL modem ..........................................1-5

Table 1-4 DMT specifications of AceLink ADSL modem.................................................. 1-6

Table 1-5 Specifications of external connector of AceLink ADSL modem....................... 1-6

Table 1-6 Specifications of external connector of AceLink ADSL modem....................... 1-6

Table 1-7 Specifications of AceLink ADSL modem software............................................ 1-7

Table B-1 Pin connection of RJ-11 telephone cable connector..........................................B-3

vii

Chapter 1 Introduction

This chapter describes the main functions of the AceLink ADSL modem, as well as its applications, hardware structure, and specifications.

y Introduction to the AceLink ADSL modem y Name and function of each component y AceLink ADSL modem specifications

1-1

Chapter 1

1-2

Introduction

Introduction to AceLink ADSL modem

It is possible to access the Internet and other multimedia service networks through an existing telephone line (PSTN) using AceLink ADSL modem.

Unlike previous dial-up modems, AceLink ADSL modems provide the fastest speed available as well as allow use of the telephone at the same time.

Characteristics of AceLink ADSL modem;

Various Applications

Some of the applications of AceLink ADSL modem include Internet access, chatting (real-time communication), file transfers, and data download/upload.

Inexpensive Price

AceLink ADSL modem uses a pre-existing phone line (PSTN) instead of using a separate cable, which needs a great amount of money and time to install.

Reliable Network Connection

AceLink ADSL modem operates in connection with the master system in the local telephone office letting the telephone office manage all of the networking services.

Easy Installation

AceLink ADSL modem is easy install so that a popular user can easily connect to ISP and receive the internet service.

Web-based Management

AceLink ADSL modem provides a web environment management function. Whereby, the user can monitor the modem’s state and change the settings easily.

Name and Function of each part

Front View

Figure 1-1 Front view of AceLink ADSL modem

1-3

Number Label Color Function

❶ Power Green On, while AC power is provided. ❷ Link(ADSL) Green

❸ Data(ADSL) Green

On, while connected to telephone office’s ADSL master system.

Flashing, when sending/receiving to/from telephone office’s ADSL master system.

❹ Link(User) Green On, while connected to PC. ❺ Data(User) Green Flashing, when sending/receiving data through PC.

Table 1-1 Ac eLink ADSL modem's LED functions

Chapter 1

1-4

Introduction

Rear View

Figure 1-2 Rear view of AceLink ADSL modem

Number Label Port Function

❶ Off / On Power Switch A power switch of AceLink ADSL Modem.

❷ ADSL

❸ Phone ❹ DC 5V

❺ Console

ADSL line

port

Telephone

port

Power input

port

Serial port

(RS232C)

❻ Ethernet Eth ernet port

Table 1-2 Ac eLink ADSL modem's port functions

Connect RJ-11 telephone line from the telephone socket on the wall. This port is used to send/receive ADSL data.

Connected to ordinary telephone through micro-filter.

A jack to connect Input power (AC 110V, DC 5V adapter) to ADSL modem.

Used for maintenance of ADSL by technician.

Connect to PC’s network adapter by using UTP. Category-3,4,5 Straight-through cable. Provide up to 10Mbps speed.

AceLink ADSL modem specifications

Hardware Features

Category Specification

1-5

Power Supply of Main Board

Power Supply Adapter

User Interface

LED

Package

y Input Power : DC 5V (5V/1.5A) y Voltage usable : 3.3V and 12V y Power consumed : 4.5Watts (Max) y Rated Input : AC 110V, 60Hz y Rated Output : DC +5.0V 1.5A y ADSL Interface(RJ-11) : Telephone line y Telephone Interface(RJ-11) : Telephone y Ethernet Interface(RJ-45) : Connection to 10Mbps Ethernet Port

(Straight-through)

y Console Interface(DB-9:Female) : 19,600bps Null modem interface y Power : A green light is on during normal operation of the modem. y Link (ADSL) : A green light is on when it is linked to ADSL home

system network.

y Data (ADSL) : A green light flickers during transmitting/receiving of

data with ADSL home system network.

y Link (User) : A green light is on when it is linked to Ethernet port

of PC.

y Data (User) : A green light is on during transmitting/receiving of

data with PC.

y Package Material : Plastic y Dimension : 37(width) x 233(length) x 164.2(height) mm y Weight : 1 Kg (modem, power supply device and cabl es are

included)

y Installation : Vertical installation is available (an installation rack is

provided).

Table 1-3 Hardware specifications of AceLink ADSL modem

Chapter 1

1-6

Introduction

DMT Specifications

Category Down Stream Up stream Remarks

Max Data Rate 8Mbps 640Kbps

ADSL OverHead 96Kbps 32Kbps Frame Mode 3

Bandwidth 0.11Mhz ~ 1.1Mhz 30Khz ~ 110Khz

TX Power 20dBm 12dBm Bin Width 4.3125Khz

Max Sym/bin 16 Bit

Latency Fast channel : < 2ms, Interleaved < 20ms

Applied Standar d

ANSI/T1.413, ITU-T/G.992.1, ITU-

T/G.992.2

Table 1-4 DMT specifications of AceLink ADSL modem

External Connector Specifications

접속 DSLAM 및

전송거리에 따

라 차이가 있을

수 있습니다.

T1.413 standard

(+/-50ppm)

Type Options Remarks

RJ-45 Ethernet

RJ-11 Telephone

Line

RJ-11 ADSL Line y Connected to external ADSL line

Power Jack y AC/DC converter 5V adapter

Power Switch y Power On/Off switch

y Internet access available by connecting to extern al

y Telephone access available through external micro-

filter

Table 1-5 Specifications of external connector of AceLink ADSL modem

Other Specifications

Content Item Remarks

Working Temp. 0 ~ 45℃

Telephone Service Linked to telephone using external micro-filter

Foreign Standard

Table 1-6 Specifications of external connector of AceLink ADSL modem

Form approval(EMI CLASS B)

U.S. FCC Part 15 & 68

+ 29 hidden pages