Samsung SADT-104WM User Manual
SADT - 104WM
Wall Mount Adaptor
imagine the possibilities
Thank you for purchasing this Samsung product.
To receive more complete service, please
register your product at
www.samsung.com/global/register
SADT-104WM_ENG.indd 1 2008-01-24 오전 10:24:02
ENG
SADT-104WM_1
Overview
The WALL MOUNT ADAPTOR is used to install the SMARTDOME
CAMERA (SCC-C6433/C6435) in an indoor wall.
Notice
• Make sure that you must select an installation spot to endure the total weight of "Wall
Mount Adapter", "Smart Dome Camera".
• This product is designed to use with anchor bolts and anchor nuts (M10).
• If installing in a concrete wall, use a M10 anchor bolt (nut) with flat washer and spring
washer.
• Each installed anchor bolt should endure 700kg of pulling force.
• Wall Mount Adapter can be installed directly in the wall, and also attached to CORNER
MOUNT ADAPTOR(SADT-110CM), or POLE MOUNT ADAPTOR(SADT-100PM)
Installation
1. Select an installation spot which can endure more than 4 times of the product weight.
2. Refer to the user guide of the SMARTDOME CAMERA, prepare the outdoor power cable,
BNC cable, communication cable to connect the Camera.
SADT-104WM_ENG.indd 1 2008-01-24 오전 10:24:03
2_SADT-104WM
3. If you install the Wall Mount Adaptor in a wall, place the template on the wall and drill 4
holes for the anchor bolts (M10) and nuts (M10) before inserting them.
If you install it in a corner of the wall, use the Corner Mount Adaptor (SADT-110CM). If
installing on the pole of the wall, use the Pole Mount Adaptor (SADT-100PM).
4. Prepare the Camera Adaptor for the applicable camera.
Remove the Bracket Sealing from the Camera Adaptor.
TEMPLATE
The positions for
installing a ANCHOR BOLT
80 mm
150 mm
BRACKET CEILING
CAMERA ADAPTOR
SADT-104WM_ENG.indd 2 2008-01-24 오전 10:24:03
ENG
SADT-104WM_3
5. Remove the Connectors at the end of the Camera Adaptor.
In the next step, peel off the coating of the cable and connect it to the external cable
using soldering. (See the wiring diagram of the installation guide for the Camera to
connect the cables.)
Lastly, use an insulation tape to wrap up the soldering portion of two cables.
Repeat the above steps to connect all of the 4 Connectors to the appropriate external
cables.
CAMERA ADAPTOR CAMERA ADAPTOR
CABLE
CONNECTOR
EXTERNAL CABLE
BNC JACK
SOLDERING
CONNECTOR
CONNECTOR
BNC JACK
EXTERNAL CABLE
SADT-104WM_ENG.indd 3 2008-01-24 오전 10:24:04
Loading...