Take specially care of tuning or test,
because specificity of cellular phone is sensitive for surrounding interference(RF noise).
Be careful to useakind of magnetic object or tool,
●
because performance of parts is damaged by the influence of magnetic force.
Surely useastandard screwdriver when you disassemble this product,
●
otherwise screw will be worn away.
Useathicken twisted wire when you measure level.
●
thicken twisted wire has low resistance, therefore error of measurement is few.
A
Repair after separate Test Pack and Set because for short danger(for example an
●
over-current and furious flames of parts etc) when you repair board in condition of
connecting Test Pack and tuning on.
Take specially care of soldering, because Land of PCB is small and weak in heat.
●
Surely tune on/off while using AC power plug, becausearepair of battery charger is
●
dangerous when tuning ON/OFF PBA and Connector after disassembling charger.
Don't use as you pleases after change other material than replacement registered on SEC
●
System.
Otherwise engineer in charge isn't charged with problem that you don't keep this rules.
1-1
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Safety Precautions
ESD(Electrostatically Sensitive D evices) Precaution
1-2.
Several semiconductor may be damaged easily by static electricity. Such parts are called by
ESD(Electrostatically Sensitive Devices), for example IC, BGA chip etc. Read Precaution below.
You can prevent from ESD damage by static electricity.
Remove static electricity remained your body before you touch semiconductor or parts with
●
semiconductor. There are ways that you touch an earthed place or wear static electricity
prevention string on wrist.
Use earthed soldering steel when you connect or disconnect ESD.
●
Use soldering removing tool to break static electricity.,otherwise ESD will be damaged by
●
static electricity.
Don't unpack until you set up ESD on product. Because most of ESD are packed by box
●
and aluminum plate to have conductive power,they are prevented from static electricity.
You must maintain electric contact between ESD and place due to be set up until ESD is
●
connected completely to the proper place oracircuit board.
1-2
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Specification
2.
GSM General Specification
2-1.
GSM900
Phase 1
Freq.
Band[MHz]
Uplink/Downlink
ARFCN range
Tx/Rx spacing45MHz
Mod. Bit rate/
Bit Period
Time Slot
Period/Frame
Period
Modulation0.3GMSK
MS Power33dBm~5dBm
Power Class5pcl ~ 19pcl
Sensitivity-102dBm
880~915
925~960
0~124 &
975~1023
270.833kbps
3.692us
576.9us
4.615ms
GSM850
Phase 1
824.2~848.8
869.2~893.8
128~251
45MHz
270.833kbps
3.692us
576.9us
4.615ms
0.3GMSK
33dBm~5dBm
5pcl ~ 19pcl
-102dBm
DCS1800
Phase 1
1710~1785
1805~1880
512~885512~810
95MHz80MHz
270.833kbps
3.692us
576.9us
4.615ms
0.3GMSK0.3GMSK
30dBm~0dBm30dBm~0dBm
pcl
0
-100dBm-100dBm
~15
pcl
PCS1900
1850~1910
1930~1990
270.833kbps
3.692us
576.9us
4.615ms
pcl
0
~15
pcl
TDMA Mux8
Cell Radius35Km
8
35Km
88
2Km-
2-1
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
GSM Tx Power Class
2-2.
Specification
TX Power
control level
533±3
631±3
729±3
827±3
925±3
1023±3
1121±3
GSM
GSM900
850
dBm
dBm
dBm
dBm
dBm
dBm
dBm
TX Power
control level
030±3
128±3
226±3
324±3
422±3
520±3
618±3
DCS1800
dBm
dBm
dBm
dBm
dBm
dBm
dBm
TX Power
control level
030±3
128±3
226±3
324±3
422±3
520±3
618±3
PCS1
900
dBm
dBm
dBm
dBm
dBm
dBm
dBm
1219±3
1317±3
1415±3
1513±3
1611±5
179±5
187±5
195±5
dBm
dBm
dBm
dBm
dBm
dBm
dBm
dBm
716±3
814±3
912±4
1010±4
118±4
126±4
134±4
142±5
150±5
dBm
dBm
dBm
dBm
dBm
dBm
dBm
dBm
dBm
716±3
814±3
912±4
1010±4
118±4
126±4
134±4
142±5
150±5
dBm
dBm
dBm
dBm
dBm
dBm
dBm
dBm
dBm
2-2
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Specification
GSM EDGE TX power class
2-3.
TX Power
control level
827±3
925±3
1023±3
1121±3
1219±3
1317±3
1415±3
GSM900
GSM850
dBm
dBm
dBm
dBm
dBm
dBm
dBm
TX Power
control level
226±3
324±3
422±3
520±3
618±3
716±3
812±3
DCS1800
dBm
dBm
dBm
dBm
dBm
dBm
dBm
TX Power
control level
226±3
324±3
422±3
520±3
618±3
716±3
812±3
PCS1900
dBm
dBm
dBm
dBm
dBm
dBm
dBm
1513±3
1611±5
179±5
187±5
195±5
dBm
dBm
dBm
dBm
dBm
910±3
1014±3
1112±4
1210±4
138±4
146±4
154±4
dBm
dBm
dBm
dBm
dBm
dBm
dBm
910±3
1014±3
1112±4
1210±4
138±4
146±4
154±4
dBm
dBm
dBm
dBm
dBm
dBm
dBm
2-3
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Product Function
3.
Main Function
Mega Pixel Camera
-3.2
WQVGA
-3.0"
TOUCH WIZ" Full Touch UI
-"
BlueTooth V2.1+EDR
-
USB
-
-
-
-
-
-
-
-
-
-
2.0
SMS/MMS/EMS(OMA v1.2
MP3/AMR/AAC/AAC+/e-AAC+/WMA
Quad Band(EGSM900/DCS,PCS,EDGE)
MicroSD Card Support
External Memory
FM Radio Support,Radio Data System, Analog TV Support
Full Internet Browsing
Accelerometer rotation
Face Detection&Smile Shot
TFT TOUCH SCREEN
262K
)
3-1
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Array course control
4.
Software Adjustments
4-1.
Test Jig(GH99
RF Test Cable(GH
-36900
39-00985
A)
A)
Test Cable(GH39-01160A)
Adapter(GH
99-38251
A)
4-1
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization