Samsung RS21KLMR mechanical disassembly
21
88.. MMEECCHHAANNIICCAALL DDIISSAASSSSEEMMBBLLYY
8-1. Freezer Disassembly
1. Insert a flat-blade screwdriver on the slot
as shown and unlock the tabs.
2. Disconnect the wire connector in the back of
control panel
The door gasket is set into groove on door liner
1.Open the door.
2.Grasp the gasket and pull it out from
the door liner.
The unit have two light switches on the side
wall of freezer & refrigerator.
1.Use a small flat-blade screw driver to unlock
the hook and pull the switch out until the wire
connector is exposed.
The light of freezer is located at lower side
of Auger motor case.
1.Remove ice bucket.
2.Remove the lamp cover by releasing the screw.
3.Change the bulb(rated component)
Control Panel Light SWITCHES
Lights (Dispenser MODEL)
Door Gasket
1
3
2
22
Refer to Refrigerator Disassembly
Disassemble/assemble method is
same as the light in refrigerator
Lift the guard up and pull it out from door liner
1.Pull the shelf out as far as it goes.
2.Lift it up and pull it out from the unit.
The drawers are located at bottom side of
freezer.
1.Pull the drawer out as far as it goes.
2.Lift it up slightly and pull it out from the unit.
The ice Bucket is located in the upper portion of
the freezer. this assembly stores ice made by the
ice maker and dispenses ice cubes.
1.Lift the ice bucket up
2.Slide it out from the unit.
Lights (Basic MODEL) Drawers in FREEZER
Ice Bucket
Door Guard in FREEZER
Shelves
23
1.Pull the shelf out as far as it goes.
2.Lift it up and pull it out from the unit.
1.Remove ice bucket.
2.Remove the screws(4) that secured the case
3.Slide it out from the unit. then, you can
disassemble the auger motor from the
back of the case.
1. Remove ice bucket and the Ice maker.
2. Remove the covers(①) and sensor covers(②)
3. Remove the screws(3pcs) that secured the
assembly.
4. Disconnect the wire connector(③) and the
connecter for Sensor (it can be possible
to disconnect this connector after removing
the sensor cover)
1. Remove the assembly of cover multi freezer
2. Pull the assembly out toward front by holding
upper side of the assembly up to see the
connector.
3. Disconnect
the wire
connector
and take the
assembly out.
Ice Maker
Cover Multi Freezer Assembly
Cover Evaporator Assembly
Auger Motor & case
1 2
①
②
③
Loading...