Samsung RF266AEPN User Manual

Before calling service

ENGLISH

Automatic Ice Maker does not work

• Allow your refrigerator to operate and

cool down for 24 hours (1 full day) be-

fore the ice maker starts producing ice.

• To ll the ice bucket to maximum ca-

pacity, dispense a few cubes 8 and 16

hours after installation.

• If ICE OFF is lit, the ice maker will not make ice.

• To activate the ice maker, press the ICE OFF but-

ton on the control panel so it is no longer lit.

• If you have the model RF268, RFG238 or

RFG298, the gure may differ slightly from your

refrigerator. For details, refer to the “Using the

Control Panel” section of the User Manual.

3 sec

• Recommended Temp Settings

: -2°F for freezer and 38°F for refrigerator.

• Filter indicator : The lter Indicator will be Red

when you have used your water lter for 6 months,

Reset the indicator (it will be Blue) after replacing

the lter by holding the "Alarm/Hold 3 sec for

Filter Reset" button for 3 seconds.

• Ice off : Press the "Ice Off" button to turn the ice

making function off.

• Cooling Off (Show Room) mode : If the Display

shows the "0F 0F" code, it means that the Cool-

ing Off function is activated and the refrigerator is

not cooling. To cancel the Cooling Off mode, hold

the Energy Saver + Freezer buttons together for

3 seconds.

Display

• When installing, servicing or cleaning behind the

refrigerator, be sure of the following:

• To protect your oor's nish when moving the

refrigerator, cut a large section of the cardboard

carton and place under the refrigerator where

you are working.

• Pull the unit straight out and push back in straight

after nishing.

Moving and Installing

PUSH

• Check if the ice bucket is completely

inserted.

• Freezer temp may not be enough;

set it to -2°F or lower.

Slow Ice cube freezing

• If the water lter is clogged, small or bubbled ice

cubes may be produced.

• Replace the water lter cartridge with a new one.

Small or bubbled ice cubes or Slow water dispensing

After installation or when replacing the

water lter, dispense at least a gallon

(2~3minutes) of water to remove trapped

air from the water line. Otherwise, water

may drip after dispensing water.

• Slowly turn the water lter 90°

clockwise so it is aligned with the

printing mark on the cover, locking

the lter in position.

Make sure to align the water lter

label mark with center of cover l-

ter printing as illustrated.

Water ﬁlter replacement

• The rst glass of water may not be cold enough

because the stored water in the water valve has

not cooled completely. Dispense several glasses

of water and then it would be cool.

Water is not cool enough

• Allow your refrigerator to operate and cool down

for 24 hours (1 full day) to reach to the set tem-

perature.

• Also, when you put room temperature or warmer

food into your refrigerator, it may need an addi-

tional 24 hours for the fridge to reach the set tem-

perature.

Refrigerator or freezer Compartments are warm

• If food with too much moisture is stored near the

cooling vents, it may get frozen. Be sure to keep

moist food away from the cooling vents.

Food stored in refrigerator is frozen

• Wipe off the condensation with a dry towel (This

may occur during hot and humid seasons.)

• If the condensation occurs on the doors, turn off

the Energy Saving function.

• If you open the doors frequently or for too long, it

may cause moisture inside the fridge.

Moisture forms on outside/inside of refrigerator

• These noises may be heard occasionally inside

the refrigerator. This is normal. This sound occurs

when various items contract or expand while

temperatures are changing; especially during

defrosting. This may also occur when electronic

devices including the ice maker are operating.

Noise Clicks, Pops, Cracks, Snaps

• You can select your Pantry temperature from

among the following.

Fresh(38°F[3°C])

Chilled(34°F[0°C])

Deli(41°F[5°C]) modes.

Cool Select Pantry (on some models)

• Insert a at-blade screwdriver into a slot on the

control lever, turn it clockwise or counter-clock-

wise to level the

door.

Control Lever

Screwdriver

• Open the freezer drawer to gain an access to the

adjustable hinge pin. Next, adjust the refrigerator

door using the provided 0.16 inch wrench.

RAISE

• If you need to add more height to the door, insert

the provided snap rings.

Leveling & Door Alignment

• If the water line is not inserted into the coupler

properly, air could penetrate into the water line

causing water dripping from the water dispenser.

•

CAUTION : Insert the water line into the coupler

completely and slide in the clip at the end of the

coupler.

Water dispenser dripping

Red Clip

(1/4")

Dispenser Door Tube

Cabinet Tube

If you have RF265, RF266F, RF268 or RFG299,

the gure may differ slightly from your Refrigerator.

For details, refer to the user manual “Using the

control panel”

DA99-01900A REV(0.4)

PUSH