Operating
Instructions
V A CUUM CLEANER
※ Before operating this unit, please read the instructions carefully
IMPORTANT SAFEGU ARDS
▶ This appliance must be connected to the same main voltage as shown on the rating
plate.
▶ This vacuum cleaner is not suitable for removing liquids of any kinds.
▶ Carpets treated with a liquid cleaner must be allowed to dry before being cleaned with
the unit.
▶ Never operate the vacuum cleaner without a dust bag.
▶ If a dust bag is not inserted, the cover cannot be closed, please do not close forcibly.
▶ Keep children away from the electrical appliance. It must not be used on people or
animals.
▶ Never use your appliance to vacuum matches, glowing embers, or cigarette-ends,
Avoid vacuuming hard, pointed objects, since they may damage the appliance or dust
bag.
▶ If your vacuum cleaner has a fault, please contact your electrical retailer or an auth-
orized service agent.
▶ If the main cable is defective, the complete cable winder must be replaced by a
service agent.
Protecting the environment
▶ When you have unpacked the unit, do not simply throw the packing into the
household waste.
▶ Take them to the appropriate collecting points for recycling.
NOTE:
The packing is retained in case you should need to transport
your vacuum cleaner or return to service at some point in the future.
1
HANDLE
IDENTIFICATIONS PARTS
AIR REGULATOR
RUG/FLOOR
TUBE
SELECTOR
BUTTON FOR SUCTION
HOSE REMOVAL
CARRYING HANDLE
FLOOR NOZZLE
*
▶ Features marked with * may vary according to model.
ASSEMBLING THE V ACUUM-CLEANER READ Y FOR USE
1) Connect the suction hose to the
suction tube.
2) Connect the suction tubes together
SUCTION HOSE
DUST-FULL INDICATOR
ON/OFF BUTTON
POWER CONTROL
SWITCH
CORD REWIND BUTTON
*
*
3) Connect the nozzle to the suction tube.
4) Connect the hose clamper to the body
of the cleaner.
2
POWER CORD
1) PULLING OUT
The power cord is long enough to
be drawn out for convenience.
2) REWINDING
Upon finishing cleaning disconnect
the plug from the electrical outlet
and just press the cord rewind button
lightly with your toe.
NOTE:
When removing the power cord from the electrical outlet, grasp the plug, not
the cord.
ON / OFF SWITCH
With the cord plugged into an electrical
outlet, start or stop the vacuum cleaner by
pushing lightly on the switch downward
with your toe.
POWER CONTR OL
The vacuuming power can be adjusted to
suit any situation with the electrical power
control.
(ONLY VARIABLE CONTROL TYPE)
MIN = For delicate fabrics, e.g.net
curtains.
MAX = For hard floors and heavily
solid carpets.
3
DUST-FULL INDICAT OR
If the “Dust-Full”indicator switch changes to “RED”while you are cleaning, the dust bag
requires replacement.
NOTE :
If the “Dust-Full indicator continues to display “RED”even after changing the
dust bag turn the cleaner off and check whether the hose, tube or nozzle is
clogged.
RUG/FLOOR SELET OR
Before use make sure that the position of button is in right position for the type of surface
to be cleaned.
①
Push the side ① when cleaning the capets.
Push the side ② when cleaning the floor, tile,mat,etc.
②
USING THE ACCESSORIES
The accessories are stored at the rear side
of the cleaner.
▶ Dusting brush for furniture,
shelves, books, etc.
▶ Crevice tool for radiators, crevice,
corners, between cushions.
Located on the right rear side of the
cleaner.
1) Disconnect the hose clamper from the
body of the cleaner.
2) Connect the hose clamper to the blow
hole.
USING THE BLOWER
4
PARK POSITION
Located on the top rear side of the
vacuum cleaner, there is a support for a
convenient park position during pauses
when using the nozzle.
TRANSPORTING AND ST ORING THE VA CUUM CLEANER
For easy storage and transportation, this
vacuum cleaner has a clip system built on
the body, which will keep the tube, hose
and nozzle in a vertical position.
REPLACING THE DUST B AG
1) To open the cover of the dust bag compartment press the clamper forward located at the front of the dust cover.
2) remove the dust bag from the cleaner.
5
3) After removing the used dust bag, insert
the cardboard bag collar of the new dust
bag into the suction inlet to the full.
4) Press the dust cover down gently until
the clamper relocks.
FOR CLOTH FILTER BAG
Use only a designated cloth filter bag:
After using, if the cloth filter bag is full of
dust, clean the cloth filter bag and use it
again.
PROBLEM CAUSE REMEDY
TROUBLE SHOO TING
Motor does not start No voltage
Suction force is
gradually decreasing
Cord does not rewind fully
Filter, nozzle, suction
hose or tube is blocked.
Check that the cord is not
twisted or wound unevenly
Check cable, plug and
socket.
Remove the object.
Pull the cord out 2~3m &
push down the cord,
rewind button.
6
This Vacuum cleaner is approved the following
EMC Directive : 89/336/EEC, 92/31EEC and 93/68/EEC
EN 61000-3-2 : 1995, EN 55014 : 1993 and EN 55104 : 1995
Low Voltage Safety Directive : 73/23/EEC and 93/68/EEC
IEC 335-1, IEC 335-2-2, EN 60335-1 and EN 60335-2-2
DJ68-40014A REV(0.3
7
)
Loading...