SAMSUNG NB17ASHS_EDC Service Manual Disassembly & Reassembly

NB17A*/NB19A* 3-1

3 Disassembly and Reassembly

This section of the service manual describes the disassembly and reassembly procedures for the
NB17A*/NB19A* monitor.

WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling

these components.

3-1 Disassembly

Cautions : 1. Disconnect the monitor from the power source before disassembly.

2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.

3. R/Cover opening jig : BH81-00001A

1. Place monitor face down on cushioned table.
Remove 2 screws from grip on the stand and
remove signal cable.
(CAUTION : Remove screw grip don’t on the
stand than fall the stand from the top side of
the foot.)

2. Remove front cover and remove back cover.

3. Remove 2 screws shield TCO and remove 1
screw shield power.

4. Remove casket tape and disconnect function
cable, inverter cable.

(NB17A*) (NB19A*)

3 Disassembly and Reassembly

3-2 NB17A*/NB19A*

3-2 Replacement Order of Lamp Assemblies

1. Remove 2 screws from LCD module.
(top & bottom)

Note : Always clear the work table

before operation.

2. Slide out the lamp unit.
Do not use excessive force.

5. Disconnect LVDS cable and remove 4 screws
from the shield.
(the coner of the shield 4 screws)

6. Lift up shield from the panel.