Samsung MJ15, 17, MJ17 Assembly

3 Disassembly and Reassembly

!

This section of the service manual describes the disassembly and reassembly procedures for the
MJ15AS*/MJ17AS*/MJ19AS*/MJ15BS*/MJ17BS*/MJ19BS* TFT-LCD monitors.

WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling

these components.

3-1 Disassembly

Cautions:1. Disconnect the monitor from the power source before disassembly.

2. Follow these directions carefully; never use any metal instrument except provided jig to
separate the cabinet.

3. R/Cover opening jig : BH81-00001A

1. Place monitor face down on cushioned table.
Remove 4 screws from grip on the stand and
remove the stand. Remove 2 screws from the
rear cover.

2. Insert the opening stand into the grooves at a
hole and press until it clicks and lift the rear
cover.

3. Remove 2 screws from the shield.

4. Disconnect function cable from the cover front
and lift up the panel. Remove 4 screws from
the panel shield. (Right / Left)

5. Lift up the panel shield and carefully remove
the silicon glue on the cables with a nipper.

Caution : Lamp wire may be easily
damaged. Please use caution when removing
the silicon.

MJ15AS*/MJ17AS*/MJ19AS*/
MJ15BS*/MJ17BS*/MJ19BS*

3-1

3 Disassembly and Reassembly

!

6. Remove 7 screws, 4 hexa screws from the
boards and lift up the boards.

Caution : When repairing panel only,
disconnect just LVDS cable, Panel-Lamp /
Wire marked in circle in the picture without
removing the screws on board in order to lift
the board up.

7. This picture is panel.

3-2 Reassembly

Reassembly procedures are in the reverse order of disassembly procedures.

3-2 MJ15AS*/MJ17AS*/MJ19AS*/

MJ15BS*/MJ17BS*/MJ19BS*