4. Disassembly and Reassembly
4-1 Replacement of Magnetron, Motor Assembly and Lamp
Remove the magnetron including the shield case, permanent magnet, choke coils and capacitors (all of which are contained in one assembly).
1.Disconnect all lead wires from the magnetron and lamp.
2.Remove a screw securing the magnetron supporter.
3.Remove the magnetron supporter.
4.Remove the air cover.
5.Remove screws securing the magnetron to the wave guide.
6.Take out the magnetron very carefully.
7.Remove screws from the back panel.
8.Take out the fan motor.
9.Remove the oven lamp by rotating to pull out from hole of air cover.
NOTE1: When removing the magnetron, make sure that its antenna does not hit any adjacent parts, or it may be damaged.
NOTE2: When replacing the magnetron, be sure to remount the magnetron gasket in the correct position and make sure the gasket is in good condition.
Cover Air |
Thermo S/W |
Lamp
Fan Motor
BKT-Mountain
|
|
|
Screw |
|
|
|
|
Magnetron H. V. Trans |
|
||
|
|
||
|
H. V. Capacitor |
|
4-2 Replacement of High Voltage Transformer
1.Discharge the high voltage capacitor.
2.Disconnect all the leads.
3.Remove the mounting bolts.
4.Reconnect the leads correctly and firmly.
PRECAUTION
Servicemen should remov their watches whenever working close to or replacing the magnetron.
PRECAUTION |
|
|
|
There exists HIGH VOLTAGE ELECTRICITY with high |
|
|
|
current capabilities in the circuits of the HIGH |
|
|
|
VOLTAGE TRANSFORMER secondary and filament |
|
|
|
terminals. It is extremely dangerous to work on or |
|
|
|
near these circuits with the oven energized. |
Screws |
H. V. Trans |
|
DO NOT measure the voltage in the high voltage |
|||
|
circuit including filament voltage of magnetron.
Samsung Electronics |
4-1 |
Disassembly and Reassembly
4-3 Replacement of Door Assembly
4-3-1 Removal of Door Assembly
Remove hex bolts securing the upper hinge and |
|
|
lower hinge. Then remove the door assembly. |
Screws |
Upper Hinge |
|
|
|
|
|
Lower Hinge
Screws
4-3-2 Removal of Door "C"
Insert flat screwdriver into the gap between Door "E" and Door "C" to remove Door "C". Be careful when handling Door "C" because it is fragile.
4-3-3 Removal of Door "E"
Following the procedure as shown in the figure, insert and bend a thin metal plate between Door "E" and Door "A" until you hear the 'tick' sound.
1.Insertion depth of the thin metal plate should be 0.5mm or less.
4-3-4 Removal of Key Door & Spring
Remove pin hinge from Door "E"
Detach spring from Door "E" and key door.
Door "E"
|
|
Key Door |
|
Spring |
|
|
|
|
|
|
|
|
|
|
|
|
|
4-2 |
|
|
Samsung Electronics |