Samsung LTN-160AT01-A Datasheet

A-PDF Watermark DEMO: Purchase from www.A-PDF.com to remove the watermark

PI

TO DATE

SAMSUNG TFT-LCD

MODEL NO. : LTN160AT01-A02

NOTE : Extension code [ -A02 ]

www.jxlcd.com

:

Regional向

: Aug. 8, 2008.

→ LTN160AT01-A02

Surface type [ Glare ]

The information described in this SPEC is preliminary and can be changed without prior notice

APPROVED BY :

PREPARED BY :

LCD Mobile Division, Application Engineering Part

SAMSUNG ELECTRONICS CO., LTD.

Samsung Secret

Doc.No. Rev.No

01-P01-S-080808

Page

/ 31LTN160AT01-A

1

CONTENTS

PI

Revision History General Description

1. Absolute Maximum Ratings

1.1 Absolute Ratings of environment

1.2 Electrical Absolute Ratings

2. Optical Characteristics

3. Electrical Characteristics

3.1 TFT LCD Module

3.2 Backlight Unit

3.3 Inverter

4. Block Diagram

4.1 TFT LCD Module

4.2 Backlight Unit

4.3 Inverter Unit

5. Input Terminal Pin Assignment

5.1 Input Signal & Power

5.2 LVDS Interface

www.jxlcd.com

5.3 Backlight Unit

5.4 Timing Diagrams of LVDS For Transmitting

5.5 Input Signals, Basic Display Colors and Gray Scale of Each Color.

5.6 Pixel format

5.7 DVR Address

- - - - - - - - - - - - - - - - - - - ( 3 )

- - - - - - - - - - - - - - - - - - - ( 4 )

- - - - - - - - - - - - - - - - - - - ( 5 )

- - - - - - - - - - - - - - - - - - - ( 7 )

- - - - - - - - - - - - - - - - - - - ( 10 )

- - - - - - - - - - - - - - - - - - - ( 13 )

- - - - - - - - - - - - - - - - - - - ( 15 )

6. Interface Timing

6.1 Timing Parameters

6.2 Timing Diagrams of interface Signal

6.3 Power ON/OFF Sequence

7. Outline Dimension

8. Packing

9. Marking & Others

10. General Precaution

11. EDID

Samsung Secret

Doc.No. Rev.No

-- - - - - - - - - - - - - - - - - - - ( 20 )

-- - - - - - - - - - - - - - - - - - - ( 22 )

-- - - - - - - - - - - - - - - ---- -- ( 24 )

--- - - - - - - - - - - - - - - - -- - ( 25 )

--- - - - - - - - - - - - - - - - - - ( 27 )

--- - - - - - - - - - - - - - - - - - ( 29 )

01-P01-S-080808

Page

/ 31LTN160AT01-A

2

REVISION HISTORY

LTN160AT01-A02 model Preliminary spec was issued first.AllP00Aug8.2008

PI

SummaryPageRevision No.Date

www.jxlcd.com

Samsung Secret

Doc.No. Rev.No

01-P01-S-080808

Page

/ 31LTN160AT01-A

3

PI

GENERAL DESCRIPTION

DESCRIPTION

LTN160AT02-N01 is a color active matrix TFT (Thin Film Transistor) liquid crystal display (LCD) that uses amorphous silicon TFT as switching devices. This model is composed of a TFT LCD panel, a driver circuit and a backlight unit. The resolution of a 16.0" contains 1366 x 768 pixels and can display up to 262,144 colors. 6 O'clock direction is the optimum viewing angle.

FEATURES

• High contrast ratio, high aperture structure

• 1366 x 768 pixels resolution (16:9)

• Color Gamut (Typical 45%)

•

Viewing angle ( H90 / V60)

• Low power consumption

• Fast Response Time

• Single CCFL

•DE(Data enable) only mode

• 3.3V LVDS Interface

• Onboard EEDID chip

• RoHS Compliance

APPLICATIONS

• Notebook PC

• If the usage of this product is not for PC application, but for others, please contact SEC

www.jxlcd.com

GENERAL INFORMATION

Display area Driver element Display colors Number of pixel Pixel arrangement Pixel pitch

Display Mode

a-Si TFT active matrix

262,144

RGB vertical stripe

Normally white

mm353.45 (H) x 198.72(V) ( 16.0” diagonal )

mm0.25875 (H) x 0.25875 (V) (TYP.)

NoteUnitSpecificationItem

16 : 9pixel1366 x 768

Glass thickness Surface treatment

Samsung Secret

Doc.No. Rev.No

Haze 0, Hardness 3H

01-P01-S-080808

mm0.5

Page

/ 31LTN160AT01-A

4

Mechanical Information

PI

Module

size

Note (1) Measurement condition of outline dimension

. Equipment : Vernier Calipers . Push Force : 500g ⋅f (minimum)

1. ABSOLUTE MAXIMUM RATINGS

1.1 ENVIRONMENTAL ABSOLUTE RATINGS

Operating temperate

(Temperature of glass surface)

Max.

365.5

214.5

6.5

545

NoteUnitTyp.Min.Item

mm365.0364.5Horizontal (H) mm214.0213.5Vertical (V)

(1)mm6.2-Depth (D)

g530-Weight

NoteUnitMax.Min.SymbolItem

(1),(5)°C60-20 TSTGStorage temperate

(1),(5)°C500TOPR

(2),(4)G240-SnopShock ( non-operating )

Note (1) Temperature and relative humidity range are shown in the figure below.

95 % RH Max. (40 °C ≥ Ta) Maximum wet - bulb temperature at 39 OC or less. (Ta > 40 °C ) No condensation

www.jxlcd.com

100

-40 -20 0 20 40 60 80

Relative Humidity ( %RH)

90

80

60

40

20

Operating Range

Storage Range

5

0

( 40,90 )

( 50,50.4 )

( 60,27.7 )

Temperature (OC)

(2) 2ms, half sine wave, one time for ±X, ±Y, ± Z. (3) 5 - 500 Hz, random vibration, 30min for X, Y, Z. (4) At testing Vibration and Shock, the fixture in holding the Module to be tested have to be

hard and rigid enough so that the Module would not be twisted or bent by the fixture.

(5) If product is used for extended time excessively or exposed to high temperatures for extended time,

there is a possibility of wide viewing angle film damage which could affect visual characteristics.

(3),(4)G2.41-VnopVibration (non-operating)

Samsung Secret

Doc.No. Rev.No

01-P01-S-080808

Page

/ 31LTN160AT01-A

5

1.2 ELECTRICAL ABSOLUTE RATINGS

PI

(1) TFT LCD MODULE

VDD=3.3V, V

DD

+ 0.3VDD- 0.3V

Power Supply Voltage

Logic Input Voltage

Note (1) Within Ta (25 ± 2 °C )

DD

IN

(2) BACK-LIGHT UNIT

Lamp Current

Lamp frequency

Note 1) Permanent damage to the device may occur if maximum values are exceeded

Functional operation should be restricted to the conditions described under normal operating conditions.

L

SS

= GND = 0V

NoteUnitMax.Min.SymbolItem

(1)VV (1)VV

Ta = 25 ± 2 °C

NoteUnitMax.Min.SymbolItem

(1)mArms7.03.0I (1)kHz8040F

www.jxlcd.com

Samsung Secret

Doc.No. Rev.No

01-P01-S-080808

Page

/ 31LTN160AT01-A

6

PI

2. OPTICAL CHARACTERISTICS

The following items are measured under stable conditions. The optical characteristics should be measured in a dark room or equivalent state with the methods shown in Note (5). Measuring equipment : TOPCON SR-3

Contrast Ratio

(5 Points)

Response Time at Ta

( Rising + Falling )

Average Luminance

of White (Center)

Red

Color

Chromaticity

( CIE )

www.jxlcd.com

Green

Blue

www.jxlcd.com

* Ta = 25 ± 2 °C, VDD=3.3V, fv= 60Hz, f

CR

RT

AVE

Normal

X

Y

X

Y

X

Y

Viewing

Angle

φ = 0 θ = 0

DCLK

= (72.33)MHz, IL= 6.0 mA

Unit

-

msec

2

-220190YL,

0.6450.6150.585R

0.3550.3250.295R

0.3300.3000.270G

0.6000.5700.540G

0.1750.1450.115B

0.1100.0800.050B

cd/m

-

NoteMaxTyp.Min.ConditionSymbolItem

(1), (2), (5)-600300

(1), (3)168-T

IL=6.0mA

(1), (4)

(1), (5)

PR-650

Viewing

Angle

13 Points

White Variation

White

Hor.

Ver.

X

Y

θ

L

H

CR ≥ 10

H

L

0.3430.3130.283W

0.3590.3290.299W

-4540

-4540θ Degrees

-1510φ

-3025φ

-

(1), (5) BM-5A

(6)1.7--δ

Samsung Secret

Doc.No. Rev.No

01-P01-S-080808

Page

/ 31LTN160AT01-A

7

Note 1) Definition of Viewing Angle : Viewing angle range(10

Normal Line

o

φ = 0

,

θ = 0

θ

L

φ

H

θL =90

φ

o

x

L

≤≤≤≤

o

C/R)

θ

R

PI

12 O’clock

y

direction

φH= 90

o

6 O’clock direction

φL= 90

Note 2) Definition of Contrast Ratio (CR) : Ratio of gray max (Gmax) ,gray min (Gmin)

at 5 points(4, 5, 7, 9, 10)

Points : , , , , at the figure of Note (6).

Note 3) Definition of Response time :

Display data

Optical Response

o

CR(4) + CR(5) + CR(7) + CR(9) + CR(10)

CR =

4 9

www.jxlcd.com

100%

90%

10%

0%

5

White(TFT OFF) White(TFT OFF)

7

5

10

Black(TFT ON)

T

R

x'y'

θR=90

T

F

o

Note 4) Definition of Average Luminance of White : measure the luminance of white at 5 points.

Samsung Secret

Doc.No. Rev.No

01-P01-S-080808

: test point

Page

Time

/ 31LTN160AT01-A

8

PI

Note 5) After stabilizing and leaving the panel alone at a given temperature for 30 min , the measurement

should be executed. Measurement should be executed in a stable, windless,and dark room. 30 min after lighting the backlight. This should be measured in the center of screen. Lamp current : 6.0mA ( Inverter : SIC-130T ) Environment condition : Ta = 25 ± 2 °C

Photo-detector

( TOPCON SR3 )

Field

= 2°

50 cm

TFT-LCD module

Center of the screen

www.jxlcd.com

Note 6) Definition of 13 points white variation (

[ Optical characteristics measurement setup ]

Maximum luminance of 13 points

δL=

Minimum luminance of 13 points

10mm

13 12

342 683

10

δ

L

), CR variation( C

1024

LCD panel

VER

) [ ~ ]

1 13

10mm

11

9

192

8

5

3

10mm

Samsung Secret

Doc.No. Rev.No

7

4

2

01-P01-S-080808

6

384

576

(lines)

1

: test point

Page

/ 31LTN160AT01-A

9

Samsung LTN-160AT01-A Datasheet

Specifications and Main Features

Frequently Asked Questions

User Manual