Samsung LTN-156AT03-XXX Datasheet

Approval
TO DATE
SAMSUNG TFT-LCD
SAMSUNG TFT-LCD
MODEL NO. : LTN156AT03-XXX
MODEL NO. : LTN156AT03-XXX
: : Apr. 11, 2009
NOTE : Extension code [ -xxx ]
LTN156AT03-XXX
Surface type [ Glare ]
The information described in this SPEC is preliminary and can be changed without prior notice.
APPROVED BY :
PREPARED BY :
Application engineering part, Mobile Division
Samsung Electronics Co., Ltd.
Samsung Secret
Doc.No. Rev.No
04-A00-G-090409
Page
/ 30LTN156AT03-XXX
1
CONTENTS
Approval
Revision History General Description
1. Absolute Maximum Ratings
1.1 Absolute Ratings of environment
1.2 Electrical Absolute Ratings
2. Optical Characteristics
3. Electrical Characteristics
3.1 TFT LCD Module
3.2 Backlight Unit
3.3 LED Driver
4. Block Diagram
4.1 TFT LCD Module
5. Input Terminal Pin Assignment
5.1 Input terminal pin assignment
5.2 LVDS Interface
5.3 Timing Diagrams of LVDS For Transmitting
5.4 Input Signals, Basic Display Colors and Gray Scale of Each Color.
5.5 Pixel format
- - - - - - - - - - - - - - - - - - - ( 3 )
- - - - - - - - - - - - - - - - - - - ( 4 )
- - - - - - - - - - - - - - - - - - - ( 5 )
- - - - - - - - - - - - - - - - - - - ( 7 )
- - - - - - - - - - - - - - - - - - - ( 10 )
- - - - - - - - - - - - - - - - - - - ( 13 )
- - - - - - - - - - - - - - - - - - - ( 14 )
6. Interface Timing
6.1 Timing Parameters
6.2 Timing Diagrams of interface Signal
6.3 Power ON/OFF Sequence
7. Outline Dimension
8. Packing
9. Markings & Others
10. General Precautions
11. EDID
Samsung Secret
- - - - - - - - - - - - - - - - - - - ( 19 )
- - - - - - - - - - - - - - - - - - - ( 21 )
-- - - - - - - - - - - - - - - - - - ( 23 )
-- - - - - - - - - - - - - - - - - - ( 24 )
- - - - - - - - - - - - - - - - - - - ( 26 )
- - - - - - - - - - - - - - - - - - - ( 28 )
Doc.No. Rev.No
04-A00-G-090409
Page
/ 30LTN156AT03-XXX
2
REVISION HISTORY
REVISION HISTORY
Approval
SummaryPageRevision No.Date
A00Apr. 09. 2009
All
Approval spec was issued
Samsung Secret
Doc.No. Rev.No
04-A00-G-090409
Page
/ 30LTN156AT03-XXX
3
Approval
GENERAL DESCRIPTION
DESCRIPTION
LTN156AT03 is a color active matrix TFT (Thin Film Transistor) liquid crystal display (LCD) that uses amorphous silicon TFT as switching devices. This model is composed of a TFT LCD panel, a driver circuit and a backlight unit. The resolution of a 15.6" contains 1366 x 768 pixels and can display up to 262,144 colors. 6 O'clock direction is the optimum
viewing angle.
FEATURES
• High contrast ratio
• HD (1366 x 768 pixels ) resolution
• High Color Gamut (Typical 60%)
• Low power consumption
• Fast response time
• LED Back Light with embedded LED Driver
• DE (Data enable) only mode
• 3.3V LVDS Interface
• Onboard EEDID chip
• Green product (RoHS compliance)
APPLICATIONS
• Notebook PC
• If the usage of this product is not for PC application, but for others, please contact SEC
GENERAL INFORMATION
Display area Driver element Display colors Number of pixel Pixel arrangement Pixel pitch Display Mode
a-Si TFT active matrix
262,144
RGB vertical stripe
Normally white
mm344.232(H) x 193.536(V) ( 15.6” HD diagonal )
mm0.252(H) x 0.252(V) (TYP.)
NoteUnitSpecificationItem
16:9pixel1366 x 768
Surface treatment
Samsung Secret
Haze 0, Hard-Coating 3H
Doc.No. Rev.No
04-A00-G-090409
Page
/ 30LTN156AT03-XXX
4
Mechanical Information
Approval
Module
size
Note (1) Measurement condition of outline dimension
Vertical (V)
. Equipment : Bernier Calipers . Push Force : 500g f (minimum)
1. ABSOLUTE MAXIMUM RATINGS
1.1 ENVIRONMENTAL ABSOLUTE RATINGS
Operating temperate
(Temperature of glass surface)
Max.
359.8
5.5
450
NoteUnitTyp.Min.Item
mm359.3358.8Horizontal (H) mm210.0209.5209.0
(1)mm--Depth (D)
g430-Weight
NoteUnitMax.Min.SymbolItem
(1)°C60-20 TSTGStorage temperate
(1)°C500TOPR
Note (1) Temperature and relative humidity range are shown in the figure below.
95 % RH Max. (40 °C Ta) Maximum wet - bulb temperature at 39
100
Relative Humidity ( %RH)
90
80
60
40
20
Operating Range
O
C or less. (Ta > 40 °C ) No condensation
( 40,90 )
( 50,50.4 )
( 60,27.7 )
Storage Range
5
0
-40 -20 0 20 40 60 80
Temperature (
O
C)
(2),(4)G240-SnopShock ( non-operating ) (3),(4)G2.41-VnopVibration (non-operating)
(2) 2ms, half sine wave, one time for ±X, ±Y, ± Z. (3) 5 - 500 Hz, random vibration, 30min for X, Y, Z. (4) At testing Vibration and Shock, the fixture in holding the Module to be tested have to be
hard and rigid enough so that the Module would not be twisted or bent by the fixture.
Samsung Secret
Doc.No. Rev.No
04-A00-G-090409
Page
/ 30LTN156AT03-XXX
5
1.2 ELECTRICAL ABSOLUTE RATINGS (1) TFT LCD MODULE
DD
V
=3.3V, V
Approval
SS
= GND = 0V
NoteUnitMax.Min.SymbolItem
Power Supply Voltage
Logic Input Voltage
Note (1) Within Ta (25 ± 2 °C )
DD
DD
+ 0.3VDD- 0.3V
DD
IN
+ 0.3VDD- 0.3V
(1)VV (1)VV
Samsung Secret
Doc.No. Rev.No
04-A00-G-090409
Page
/ 30LTN156AT03-XXX
6
Approval
2. OPTICAL CHARACTERISTICS
The following items are measured under stable conditions. The optical characteristics should be measured in a dark room or equivalent state with the methods shown in Note (5). Measuring equipment : TOPCON SR-3
Contrast Ratio
(5 Points)
Response Time at Ta
( Rising + Falling )
Average Luminance of White (5 Points)
Red
Green
Color
Chromaticity
( CIE )
Blue
CR
RT
L,AVE
X
Y
* Ta = 25 ± 2 °C, VDD=3.3V, fv= 60Hz, f
Normal
X
Viewing
Angle
Y
X
Y
φ = 0 θ = 0
DCLK
= 69.3MHz, IF = 20 mA
Unit
-
msec
2
-200170Y
cd/m
NoteMaxTyp.Min.ConditionSymbolItem
(1), (2), (5)--500
(1), (3)168-T
IF=20mA
(1), (4)
0.6500.6200.590R
0.3700.3400.310R
0.3600.3300.300G
0.6000.5700.540G
-
(1), (5)
SR-3
0.1800.1500.120B
0.0900.0600.030B
X
White
Y
L
θ
Hor.
Viewing
Angle
Ver.
13 Points
White Variation
H
H
L
L
CR 10
At center
Samsung Secret
Doc.No. Rev.No
0.3430.3130.283W
0.3590.3290.299W
04-A00-G-090409
-4530
-4530θ
-1510φ
Degrees
(1), (5)
SR-3
-3520φ
-
Page
(6)1.61.4-δ
/ 30LTN156AT03-XXX
7
Note 1) Definition of Viewing Angle : Viewing angle range(10
Normal Line
o
φ = 0
,
θ = 0
θ
L
φ
H
θL =90
φ
o
x
L
≤≤≤≤
o
C/R)
θ
R
Approval
12 O’clock
y
direction
φH= 90
o
6 O’clock direction
φL= 90
o
x'y'
=90
θ
R
Note 2) Definition of Contrast Ratio (CR) : Ratio of gray max (Gmax) ,gray min (Gmin)
at 5 points(4, 5, 7, 9, 10)
CR(4) + CR(5) + CR(7) + CR(9) + CR(10)
CR =
5
Points : , , , , at the figure of Note (6).
4
5
7
10
9
Note 3) Definition of Response time :
Display data
White(TFT OFF)
Black(TFT ON)
T
R
White(TFT OFF)
T
F
100%
90%
Optical Response
10%
0%
o
Note 4) Definition of Average Luminance of White : measure the luminance of white at 5 points.
342 683 1024
Average Luminance of White ( Y
Y
L4 + YL5 + YL7 + YL9 + YL10
Y
L,AVE
=
5
L,AVE
)
10
9
7
5
4
: test point
Samsung Secret
Doc.No. Rev.No
04-A00-G-090409
Time
VIEW AREA 192
384
576
(lines)
Page
/ 30LTN156AT03-XXX
8
Approval
Note 5) After stabilizing and leaving the panel alone at a given temperature for 30 min , the measurement
should be executed. Measurement should be executed in a stable, windless,and dark room. 30 min after lighting the backlight. This should be measured in the center of screen. IF current : 20.0mA Environment condition : Ta = 25 ± 2 °C
Photo-detector
( TOPCON SR-3 )
= 2°
Field
50 cm
TFT-LCD module
Center of the screen
[ Optical characteristics measurement setup ]
Note 6) Definition of 13 points white variation (
Maximum luminance of 13 points
δL=
Minimum luminance of 13 points
10mm
342 683
10mm
13
10
LCD panel
δ
L
), CR variation( CVER ) [ ~ ]
10mm
1024
12
9
11
1 13
192
8
5
3
10mm
Samsung Secret
Doc.No. Rev.No
7
4
2
04-A00-G-090409
6
384
576
(lines)
1
: test point
Page
/ 30LTN156AT03-XXX
9
Loading...
+ 21 hidden pages