5.5 Input Signals, Basic Display Colors and Gray Scale of Each Color.
5.6 Pixel format
- - - - - - - - - - - - - - - - - - - ( 3 )
- - - - - - - - - - - - - - - - - - - ( 4 )
- - - - - - - - - - - - - - - - - - - ( 5 )
- - - - - - - - - - - - - - - - - - - ( 7 )
- - - - - - - - - - - - - - - - - - - ( 11 )
- - - - - - - - - - - - - - - - - - - ( 14 )
- - - - - - - - - - - - - - - - - - - ( 15 )
6. Interface Timing
6.1 Timing Parameters(DE Mode)
6.2 Timing Diagrams of interface Signal (DE Mode)
6.3 Power ON/OFF Sequence
7. Outline Dimension
8.General Precautions
SEC Confidential
Doc.No.Rev.NoPage/ 24LTN141XA-L01204-001-G-030716
- - - - - - - - - - - - - - - - - - - ( 20 )
- - - - - - - - - - - - - - - - - - - ( 22 )
- - - - - - - - - - - - - - - - - - - ( 23 )
REVISION HISTORY
REVISION HISTORY
Approval
Date
Rev.No.Summary
Page
LTN141XA-L01 model was First issued.July.16, 2003000All
www.jxlcd.com
www.jxlcd.com
SEC Confidential
Doc.No.Rev.NoPage/ 24LTN141XA-L01304-001-G-030716
Approval
GENERAL DESCRIPTION
DESCRIPTION
LTN141XA-L01 is a color active matrix TFT (Thin Film Transistor) liquid crystal display
(LCD) that uses amorphous silicon TFT as a switching devices. This model is composed of
a TFT LCD panel, a driver circuit and a backlight system. The resolution of a 14.1" contains
1,024 x 768 pixels and can display up to 262,144 colors. 6 O'clock direction is the Optimum
viewing angle.
FEATURES
•Thin and light weight
•High contrast ratio
•XGA ((1024x768) pixels) resolution
•Low power consumption
•DE (Data enable) only mode.
•3.3V LVDS (FPD Link) Interface with 1 pixel / clock
•Auto-Recovery Function
•SPWG Style-B
APPLICATIONS
•Notebook PC and desktop monitors
•Display terminals for AV application products
•Monitors for Industrial machine
•If the usage of this product is not for PC application, but for others, please contact SEC
www.jxlcd.com
GENERAL INFORMATION
Display area285.696(H)X214.272(V) (14.1”diagonal)
Driver elementa-si TFT active matrix
Display colors262,144
Number of pixel1024 x 768
Pixel arrangementRGB vertical stripe
Pixel pitch0.279(H) x 0.279(V)
Note (1) Temperature and relative humidity range are shown in the figure below.
www.jxlcd.com
95 % RH Max. ( 40 OC ≥ Ta)
Maximum wet - bulb temperature at 39 OC or less. (Ta > 40 OC) No condensation.
(2) 3ms, half sine wave, one time for ±X,±Y,±Z.
(3) 10 ~ 300 ~ 10 Hz, Sweep rate 10 min, 30 min for X,Y,Z.
(4) At testing Vibration and Shock, the fixture in holding the Module to be tested have to be
hard and rigid enough so that the Module would not be twisted or bent by the fixture.
-40-20020406080
100
80
60
40
20
Snop
Vnop
-
-
Relative Humidity ( %RH)
95
Operating Range
8
Storage Range
5
0
210G
1. 5
G
(2), (4)
(3), (4)
Temperature (OC)
SEC Confidential
Doc.No.Rev.NoPage/ 24LTN141XA-L01504-001-G-030716
1.2 ELECTRICAL ABSOLUTE RATINGS
Approval
(1) TFT LCD MODULE
ITEMSYMBOLMIN.MAX.UNITNOTE
Power Supply VoltageVcc
Logic Input VoltageVIN
NOTE (1) Within Ta ( 25 ± 2 OC )
(2) BACK-LIGHT UNIT
ITEMSYMBOL
Lamp currentIL
Lamp frequency
NOTE (1) Permanent damage to the device may occur if maximum values are exceeded.
Functional operation should be restricted to the conditions described under Normal Operating
Conditions.
FL
Vss-0.3
Vss-0.3
MIN.UNIT.NOTE
3.0
50
(Vcc + 0.3)
MAX.
7.0
80
V
V(Vcc + 0.3)
mArms
KHz
( Vss = GND = 0 V)
Ta = 25 ± 2 OC
( 1 )
( 1 )
(1)
(1)
www.jxlcd.com
www.jxlcd.com
SEC Confidential
Doc.No.Rev.NoPage/ 24LTN141XA-L01604-001-G-030716
Approval
2. OPTICAL CHARACTERISTICS
The following items are measured under stable conditions. The optical characteristics should be
measured in a dark room or equivalent state with the methods shown in Note (5).
Measuring equipment : TOPCON BM-5A