Introduction
Package Contents
Note
Please make sure the following items are included with your monitor.
If any items are missing, contact your dealer.
Contact a local dealer to buy optional items.
Unpacking
Type 1
Monitor & Simple stand
Note
• MagicRotation program can not be provided as Simple Stand does not support Pivot function.
Type 2
Monitor & HAS stand
Type 3
8
Type 4
Introduction
Monitor & Dual Hinge Stand
Monitor & HAS stand
23 inches or larger
Manuals
Quick Setup Guide Warranty Card
(Not available in all loca-
Cables
D-Sub Cable Power Cord DVI Cable (option)
User's Guide
tions)
USB Cable
(Applicable to the stand models that have USB ports only.)
Others
Cleaning Cloth(Option) Cable holding ring
(Supplied for the models that
Audio Cable
have speakers only.)
9
Note
Cleaning Cloth is only provided for highly polished black products as a product feature.
Your Monitor
Initial Settings
Select the language using the up or down key.
The displayed content will disappear after 40 seconds.
Turn the Power button off and on. It will be displayed again.
Introduction
It can be displayed up to three (1) times. Make sure to adjust the resolution of your PC before reaching
the maximum count.
Note
The resolution displayed on the screen is the optimal resolution for this product.
Adjust your PC resolution so that it is the same as the optimal resolution for this product.
10
Front
Introduction
Note
Touch them lightly with your fingers to use them.
MENU button [MENU/ ]
Opens the on-screen menu and exits from the menu. Also use to exit the OSD menu
or return to the previous menu.
Customized Key[ ]
You can customize key assignment for the Custom button according to your pref-
erences.
Note
You can configure the customized key for a required function via Setup > Customized Key.
Adjust buttons [ ]
These buttons allow you to adjust items in the menu.
Brightness button [ ]
When OSD is not on the screen, push the button to adjust brightness.
11
Introduction
button
Push the ' ', then selects the video signal while the OSD is off. (When the ' '
button is pressed to change the input mode, a message appears in the upper left of
the screen displaying the current mode -- analog or digital input signal.)
Note
• If you select the digital mode, you must connect your monitor to the graphic
card's DVI port using the DVI cable.
• This function is not available for products with an Analog interface only.
Enter button [ ]
Activates a highlighted menu item.
AUTO button
Use this button for auto adjustment.
(Available in Analog mode only)
Power button [ ]
Use this button for turning the product on and off.
Power Indicator
This light is lit when operating normally, and blinks once when your adjustments
are saved.
Note
See PowerSaver described in the manual for further information regarding power
saving functions. For energy conservation, turn your monitor OFF when it is not
needed or when leaving it unattended for long periods.
Volume button[ ]
When OSD is not on the screen, push the button to adjust volume.
Note
Applicable to the models that have speakers only.
Headphone sound output terminal[ ]
Note
Applicable to the models that have speakers only.
Speaker
You can hear sound by connecting the soundcard of your PC to the monitor.
12
Rear
Introduction
Note
Applicable to the models that have speakers only.
Note
The configuration at the back of the monitor may vary from product to product.
POWER port
POWER port
Connect the power cord for your monitor to the
POWER port on the back of the product.
DVI IN
RGB IN
DVI IN
Connect the DVI Cable to the DVI IN port on the
back of your monitor.
Note
Applicable to the digital (DVI)-dedicated models
only.
RGB IN
Connect the D-sub cable to the 15-pin, RGB IN
port on the back of your monitor.
USB connection termi-
nal (Option)
13