Samsung LS17PEA Disassembly and Reassembly

11 Disassembly and Reassembly

11-1

11 Disassembly and Reassembly

This section of the service manual describes the disassembly and reassembly procedures for the LS17PEA/LS19PEB
TFT-LCD monitors.

WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling

these components.

11-1 Disassembly

Cautions: 1. Disassemble stand on a flat desk.

2. Disconnect the monitor from the power source before disassembly.

Description Picture Description

1. Place a soft cloth on the desk and place the
monitor on the cloth upside down. Remove the
stand in the direction of the arrow.

2. Turn the monitor so the front section is facing
upwards. Remove the marked parts from the
front cover, as shown in the figure below.

3. Remove the marked part from the top edge of
the front cover, as shown in the figure below.

11 Disassembly and Reassembly

11-2

Description Picture Description

4. Remove the marked parts from both sides of
the front cover, as shown in the figure below.

(1)

5. Remove the marked part from the front cover,
as shown in the figure below.

Caution: Do not lift the front cover over position (1),

which may cause damage to it.

6. Turn the monitor so the back of it is facing
upwards. Lift up and remove the back cover.

7. Use the jig to remove the shield lamp.
(Be careful Shield.)

11 Disassembly and Reassembly

11-3

Description Picture Description

LVDS

INVERTER

FUNCTION

LVDS

INVERTER

FUNCTION

19"

17"

8. Disconnect cables.
(LVDS, INVERTER and FUNCTION cable)

9. Lift up the LCD panel.

10. LCD Panel