Samsung GTY3400 Users Manual

8 GT-Y3400 Installation Guide and User Manual

Figure

6. 2D Detail of the antenna connector

Figure 7. Detail of mated height

2.1.4 Connector location

The GT-Y3

co

nnection. The antenna connectors can be identified by the letters “M” for the main antenna

400 module supports receiver diversity. Both require a secondary antenna

“

and

D” for the Diversity, printed on the PCB.

Diversit

y Antenna

Main Antenna

SAMSUNG

8

This Document can not be used without Samsung's authorization | Samsung Electronics

Proprietary-Contents may change without notice

9 GT-Y3400 Installation Guide and User Manual

Figure 8. placement of the antenna connectors for the GT-Y3

400

2.1.5 Conducted RF measurement

HSUPA / HSPA+ / UMTS

. Multi-bands variants / 850 / 900 / 1900 / 2100 MHz

. UMTS Power Class 3 (24 dBm)

. HSUPA mode: 5.76 Mbps: category 6

. HSPA+ mode: 21 Mbps: Category 14

EDGE / GPRS

. 850 / 900 / 1800 / 1900 MHz

. GSM Power Class 4 (32dBm) for 850 / 900 bands

. GSM Power Class 1 (28.5dBm) for 1800 / 1900 bands

. EDGE class E2 (26.5 dBm in 850 / 900 bands, 25.8 dBm in 1800 / 1900 bands)

. GPRS / EDGE Multi-slot Class 12 (4 slots Rx, 4 slots Tx)

SAMSUNG Proprietary-Contents may change without notice

9

This Document can not be used without Samsung's authorization | Samsung Electronics

2.1.6 Installation restrictions and RF Exposure information

The installation of this module is limited to installation by Samsung Electronics IT Company. The
antenna gain used with this module must not exceed 1.4dBi in the 850MHz Cellular band and
1dBi in the 1900MHz PCS Band when it is integrated. This device is approved for use with the
following antenna (or equivalent):

Four S Tech Model: CDMA-DUAL WLL ANTENNA
Type: Dipole Antenna
Bands: CDMA 800MHz, 1900MHz, WCDMA 2.1GHz

RF Exposure – Critical Installation Requirements:

This device is approved for use as a mobile installation meaning that it will only be used in
products that are capable of maintaining a minimum separation distance of 20cm from the
antenna(s) of this device and the end user.

When installed in a final configuration the antenna must be installed such that a minimum
separation of 20 cm (8 inches) between the wireless device and the body of the user (this does
not include extremities) must be maintained during use and while the wireless device is on and
transmitting. This distance must be ensured for all operating modes and conditions.

This transmitter must not be collocated or operate in conjunction with any other antenna or
transmitter.

Installations in which the device is collocated with other transmitters or the minimum separation
distance between the body and antenna(s) can not be maintained require a separate FCC
authorization. Such installations may require additional testing for RF Exposure (i.e. SAR) and a
Class II Permissive Change filing for FCC approval. Please contact Samsung Electronics, Ltd.
regarding such installations.

Labeling:

The host equipment into which the module is installed must be clearly labeled with the FCC
identifier of the module. This label must be permanently installed and can not be placed on a
removable cover or part such as a battery cover. The label must be similar to the following:

Contains FCC ID: A3LGTY3400
Warning:

Any changes or modification to said product not expressly approved by Intel could void the user’s
authority to operate this device.