Samsung GT-S5530 Disassembly & Reassembly
7.
7-1.
Level
Assembly
Repair
2
Remove RF cover
1)
1
Remove Itenna cover
2)
1
2
Be careful not to make scratch and molding
1)
damage!
BOTTOM
2
Be careful not to make scratch and molding damage!
1)
Disjoint rear screw5points ad set lower
1)
screw2points
3
1
Remove Intenna deco horizontally to set
)
lower direction
Be careful not to make scratch and molding
1)
damage!
4
1
Lift vertically from set and separate
)
rear
Be careful not to make scratch and molding damage!
1)
7-1
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Level2Repair
7.
1
5
separate from PBA
Beware that you do not damage FPCB
1)
key FPCB actuators after open,
)3*4
6
1
Disassemble PBA's screw1point
)
Beware that you do not damage PBA.
1)
7
1
In slide close status, lift PBA slightly
)
diagonally
Beware that you do not damage Slide FPCB
1)
1
Demount slide FPCB connector
8
Beware that you do not damage Slide FPCB
1)
)
7-2
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Level2Repair
7.
9
1
After slide open, disassemble lower
)
screw4point
Be careful not to make scratch and molding damage!
1)
11
1
Remove insulation tape attached to LCD
)
lower PCB
10
Be careful not to make scratch and molding damage!
1)
12
After close slide, takes out slide FPCB
1)
carefully to front hole and disassemble
front
After turning over slide FPCB and camera
1)
assy FPCB connector actuator, remove
FPCB horizontally
Disassemble speaker module
2)
Beware that you do not damage FPCB
1)
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
2
1
Beware that you do not damage FPCB
1)
7-3
Loading...