Samsung CTI613EHD User Manual

CTI613EH series

Induction Hob

user manual

imagine the possibilities

Thank you for purchasing this Samsung product. To receive more complete service, please register your product at

www.samsung.com/global/register

using this manual

Please take the time to read this owner’s manual, paying particular attention to the safety information contained in the following section, before using your appliance. Keep this manual for future reference. If transferring ownership of the appliance, please remember to pass the manual on to the new owner.

The following symbols are used in the text

This is the safety alert symbol.

Warning indicates information concerning your personal safety. Important indicates information on avoiding damage to the appliance.

This symbol refers to measures that can be taken to help protect the environment.

This symbol indicates useful information and practical tips.

1. Numbers like these indicate step - by - step instructions for using the appliance.

2. ...

3. ...

This manual contains information on steps you can take yourself to diagnose and resolve

problems that may arise. Refer to the section “Troubleshooting”.

_ using this manual

safety instructions

The safety aspects of this appliance comply with all accepted technical and safety standards. However, as manufacturers we also believe it is our responsibility to familiarize you with the following safety instructions.

Electrical safety

•Be sure the appliance is properly installed and grounded by a qualified technician.

•The appliance should be serviced only by qualified service personnel. Repairs carried out by unqualified individuals may cause injury or serious malfunction. If your appliance is in need of repair, contact your local service centre. Failure to follow these instructions may result in damage and void the warranty.

•Flush - mounted appliances may be operated only after they have been installed in cabinets and workplaces that conform to the relevant standards. This ensures sufficient protection against contact for electrical units as required by the essential safety standards.

•If your appliance malfunctions or if fractures, cracks or splits appear:

-switch off all cooking zones;

-disconnect the hob from the mains supply; and

-contact your local service centre.

If the surface is cracked, switch off the appliance to avoid the possibility of electric shock.Do not use your hob until the glass surface has been replaced.

Child safety

This appliance is not intended for use by young children or infirm persons without the adequate supervision of a responsible adult.

Young children should be supervised to ensure that they do not play with the appliance.

The cooking zones will become hot when you cook. Always keep small children away from the appliance.

saf et ynsi rut ctions

safety instructions _

Safety during use

•Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot.

•After use, switch off the hob element by its control and do not rely on the pan detector.

•The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

•This appliance is to be used only for normal cooking and frying in the home. It is not designed for commercial or industrial use.

•Never use the hob for heating the room.

•Take care when plugging electrical appliances into mains sockets near the hob. Mains leads must not come into contact with the cooktop.

•Overheated fat and oil can catch fire quickly. Never leave surface units unattended when preparing foods in fat or oil, for example, when cooking chips.

•Turn the cooking zones off after use.

•Always keep the control panels clean and dry.

•Never place combustible items on the hob. It may cause fire.

•Do not use the hob to heat aluminium foil, products wrapped in aluminium foil or frozen foods packaged in aluminium cookware.

•There is the risk of burns from the appliance if used carelessly.

•Cables from electrical appliances must not touch the hot surface of the hob or hot cookware.

•Do not use the hob to dry clothes.

•Never store flammable materials such as aerosols and detergents in draws or cupboards under the hob.

Warning: Users with Pacemakers and Active Heart Implants must keep their upper body at a minimum distance of 30cm from induction cooking zones when turned on. If in doubt, you should consult the manufacturer of your device or your doctor.

Safety when cleaning

•Always turn the appliance off before cleaning.

•For safety reasons do not clean the appliance with a steam jet or high - pressure cleaner.

•Clean the hob in accordance with the cleaning and care instructions contained in this manual.

_ safety instructions

disposal instructions

Disposing of the packaging material

All materials used to package the appliance are fully recyclable. Sheet and hard foam parts are appropriately marked. Please dispose of packaging materials and old appliances with due regard to safety and the environment.

Proper disposal of your old appliance

Warning: Before disposing of your old appliance, make it inoperable so that it cannot be a source of danger.

To do this, have a qualified technician disconnect the appliance from the mains supply and remove the mains lead.

•The appliance may not be disposed of in the household rubbish.

•Information about collection dates and public refuse disposal sites is available from your local refuse department or council.

sposald i nsi rut ctions

disposal instructions _

contents

installing the hob

7

parts and features

11

before you begin

15

hob use

16

cleaning and care

23

warranty and service

25

technical data

27

7 Regulations and compliance

7Safety instructions for the installer

8Connecting to the mains power supply

9Installing into the countertop

11Cooking zones

11Control panel

12Components

12Induction heating

13The key features of your appliance

14Safety shutoff

14Residual heat indicator

15Temperature detection

15Initial cleaning

16Cookware for induction cooking zones

16Suitability test

16Size of pans

17Using suitable cookware

17Using the touch control sensors

18Switching the appliance on

18Select cooking zone and heat setting

18Switching the appliance off

19Switching a cooking zone off

19Using the child safety lock

20Timer

21Power boost control

21Power Management

22Suggested settings for cooking specific foods

23Hob

24Hob Frame (option)

24To avoid damaging your appliance

25FAQs and troubleshooting

26Service

27Technical data

27 Cooking rings

_ Contents

installing the hob

Important:

Be sure the new appliance is installed and grounded only by qualified personnel. Please observe this instruction. The warranty will not cover any damage that may occur as a result of improper installation.

Technical data is provided at the end of this manual.

Regulations and compliance

This appliance meets the following standards:

•EN 60335 - 1 and EN 60335 - 2 - 6, relating to the safety of electrical appliances for household use and similar purposes;

•EN 60350, or DIN 44546 / 44547 / 44548, relating to the operating features of electric cookers, hobs, ovens, and grills for household use;

•EN 55014-1

•EN 55014-2

•EN 61000 - 3 - 2; and

•EN 61000 - 3 - 3, relating to basic requirements for electromagnetic compatibility (EMC).

This appliance complies with the following EU Directives:

• 2006/95/EC, Low Voltage Directive

• 2004/108/EEC, Electromagnetic Compatibility Directive

Safety instructions for the installer

•A device must be provided in the electrical installation that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm. Suitable isolation devices include line protecting cut - outs, fuses (screw type fuses are to be removed from the holder), earth leakage trips and contactors.

•With respect to fire protection, this appliance corresponds to EN 60335 - 2 - 6. This type of appliance may be installed with a high cupboard or wall on one side.

•Drawers may not be fitted underneath the hob.

•The installation must guarantee shock protection.

•The kitchen unit in which the appliance is fitted must satisfy the stability requirements of DIN 68930.

•For protection against moisture, all cut surfaces are to be sealed with a suitable sealant.

•On tiled work surfaces, the joints in the area where the hob sits must be completely filled with grout.

•On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place with a suitable artificial resin or mixed adhesive.

•Ensure that the seal is correctly seated against the work surface without any gaps. Additional silicon sealant must not be applied; this would make removal more difficult when servicing.

•The hob must be pressed out from below when removed.

•A board is to be installed underneath the hob.

•The ventilation gap between the worktop and front of the unit underneath it must not be covered.

all ngnsiihet obh

installing the hob _

Connecting to the mains power supply

Before connecting, check that the nominal voltage of the appliance, that is, the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob.

Shut off power to circuit before connecting wires to circuit.

The heating element voltage is AC230 V~. The appliance also works perfectly on networks with AC220 V~ or AC240 V~.

The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. automatic line protecting cut - out, earth leakage trips or fuse.

A type H05RN - F cable or one of a higher grade must be used as the mains connecting cable.

	Rated current of appliance (A)	Nominal cross-sectional area (mm2)
1N~	> 25 and ≤ 32	≥ 2.5
2N~	> 10 and ≤ 16	≥ 1.5

The connection must be carried out as shown in the diagram. The connecting links should be fitted according to the appropriate connection diagram.

The earth lead is connected to terminal. The earth lead must be longer than leads carrying electric current.

The cable connections must be made in accordance with regulations and the terminal screws tightened securely.

The connecting cable is to be secured with the mains cable cleat and the covering closed by pressing firmly (locking into place). Before switching on for the first time, any protective foil or stickers must be removed from the ceramic glass surface.

Once the hob is connected to the mains supply, check that all cooking zones are ready for use by briefly switching each on in turn at the maximum setting with suitable cookware.

When the hob is powered on for the first time, all displays light and the child safety lock is activated.

220-240V ~

< IN ~ >

220-240V ~

380-415V ~ 220-240V ~

L:Brown

N: Blue

PE: Green

Warning: Pay attention (conformity) to phase and neutral allocation of house connection and appliance (connection schemes); otherwise, components can be damaged.

Warranty does not cover damage resulting from improper installation.

Warning: If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent.

_ installing the hob

Installing into the countertop

Make a note of the serial number on the appliance rating plate prior to installation. This number will be required in the case of requests for service and is no longer accessible after installation, as it is on the original rating plate on the underside of the appliance.

Pay special attention to the minimum space and clearance requirements. Secure the brackets at both sides with the provided screws before mounting the hob onto the brackets.

Min. 50 mm

Min. 5 mm

560 mm

	ø 6
x 4	90°

R3

	560±1	min. 20
	490±1	50
	600

Induction Hob
	min. 5 mm
20 mm
Insulation Panel	ventilation gap
Oven

all ngnsiihet obh

installing the hob _