SAMSON SPLICING INSTRUCTIONS
3-Strand Class I Rope-To-Chain Splice
Class I ropes are made from any or all of the following bers: olen, polyester, or nylon.
Although the 3-strand splice is the most common splice, and simple to perform,
technique is important to preserve splice strength. Take care that the tucks lie neatly,
as rope strength can be lost if the strands are twisted incorrectly.
Apply tape
Standing part of line
PREPARING THE ROPE
From one end of the rope, count back 16
picks. Unlay the strands from the bitter end
step
1
up to the taped section. Tape each individual
strand at the bitter end, to prevent unraveling,
and mark each strand 1, 2 and 3.
1 pick
Bitter
end
16 picks
1
2
step
2
step
3
THREADING THE CHAIN
Line up the rope to the last link of the chain so that Strand 2 is in the middle and Strands 1 and 3
are on either end. Take Strand 2 and pass it through one side of the chain link. Strands 1 and 3 are
to pass through the chain link from the opposite side, staying on the outside of Strand 2 (Fig. A).
Figure A
TUCKING STRANDS
Begin tucking the strands in an “over
1, under 1” pattern (Fig.B), just as in
a 3-Strand Eye Splice (page 6).
2
2
3
Figure B
3
1
1
3
SamsonRope.com | Email CustServ@SamsonRope.com | Tel +1.360.384.4669
PAGE 1 OF 2
SAMSON SPLICING INSTRUCTIONS
3-Strand Class I Rope-To-Chain Splice
step
4
FINISHING THE SPLICE
With Strands 1 and 3 tucked once, (Fig. C),
turn splice over to tuck Strand 2 (Fig. D).
2
Figure C
Figure D
3
1
2
3
1
Perform 4 more complete tucks with
step
all 3 strands. Tighten tucks if necessary.
5
Front of finished splice.
Back of finished splice.
NOTE:
DOCUMENT 3Strand_C1_Rope to Chain_AUG2012.pdf
SamsonRope.com | Email CustServ@SamsonRope.com | Tel +1.360.384.4669
© 2012 Samson Rope Technologies, Inc. All rights reserved. S/WD #108294 7/2012
This method of joining rope and chain is
designed to minimize chafe between rope and
chain, but as a matter of prudent seamanship,
the splice should be checked regularly and
remade if there is any evidence of wear.
PAGE 2 OF 2