Sams Scs-p1160 Owner's Manual

LIFESMART

PELLET GRILL Models: SCS-P1100 SCS-P1160 SCS-P1160WM SCS-P580

Questions? Contact technical support at:
657-341-0362, 9:00 a.m. - 5 p.m., PST, Mon ­Fri www.lifesmartcomfort.com
[e-mail]

Contents

Important Safety Information .........................................................3 & 4

Carton Contents ......................................................................................... 5

Assembling Your LONE STAR CHEF GRILL ……………………………………..6 & 7

Specifications………………………………………………………………….8

Initial Setup Procedure.................................................................9

TemperatureProbe……..........……………………………………………………9

Operating your LIFESMART PELLET GRILL …......………………10 & 11

Performance Tips…………………………………………………….12 &13

Maintenance and Cleaning ................................................................. 14

Folding for Transport & Storage ............................................................ 14

Troubleshooting ………………………………………………………….15 to 17

Manual Start Up ..................................................................................... 18

Controller Schematic ............................................................................. 19

Cooking Notes / USDA Temperature Chart……………………..20 & 21

Warranty Information………………………………………………………………...22

2

WARNING

FOR OUTDOOR USE ONLY

DO NOT SDTORE OR USE

COMBUSTIABLE MATERIALS

IN OR NEAR THIS APPLIANCE

TO PREVENT INJURY

NEVER MOVE TH E GRI L L

WHILE HO, UPRIGHT OR

WITHOUT ASSITANCE

NEVER STORE ANY GRILL IN

A SMALL SPACE OR

TRANSPORT IN A VEHICLE

UNLESS COMPLETELY COOL

AND VERIFIED THAT THE

FLAME IS EXTINGUISHED

LEAVE A MINIMUM OF 60

CIRCUMFERENCE BETWEEN

GRILL, DECKS, HOUSES OR

ANY COMBUSTIABLE

MATERIALS

”

USE ON LEVEL GROUND AWAY FROM

OVERHANGING ROOFS OR EAVES

3

IMPORTANT SAFETY INFORMATION

For outdoor use only. Do not use in any enclosed area. Use on Level Surface, away

from overhanging eaves.
Keep grill 60”or more from any combustible surfaces.
To prevent grease fires, clean your grill on a regular basis (especially after

greasy foods at lower temperatures). In the event of a grease fire, unplug the grill

and leave lid closed until the fire is out.

Do not put anything flammable in the storage area under the grill.
Never plug-in your grill without the service access panel located under the controller

installed.
Never put your grill in a vehicle without first ensuring that it is completely

no hot embers, pellets or ashes remain in the fire pot or auger.

Keep chi
Use heat-resistant barbecue mitts or gloves when operating this unit. Long handled,

non-plastic utensils are also recommended.

Before covering your grill, make sure that the grill has cooled completely.

Never put your hand in the pellet hopper or attempt to service any part while your

grill is plugged in.
Check burn pot periodically for obstructions to make sure proper airflow is

maintained. See cleaning instructions in this manual

Do not touch the cooking chamber attempt to move your grill while it is in operation.

Never attempt any service while the grill is plugged in

ldren and animals away while in use.

cooking

cool and that

4

PQGRSD /$T 7$T 1#O+'K%U$'D ;;=

Carton Contents

P lease note that during shipping some movement may have taken place. A complete
visual inspection is required. Be sureto inspect entire grill after removing the
protective shipping carton. Some surfaces may be sharp, so wear
assembling.

gloves when

Do not plug i n the grill until i

it i

Your carton contains the following:

#1 Assembled Body
#2 Caster Wheel Legs

#3 Wheeled Legs

#4 Bottom Shelf
#5 Grill Handle
#6 Pull Bar Handle

#7 Flame Deflector

s fully assembled and you're ready to cook

#8 Drip Pan
#9 Cooking Grates

#10 Drip Bucket

#11Temperature Probe
#12 Hardware Packet

5

Lifesmart Grill Assembly Instructions

C

D

A

STEP 1 – Unpack and Prepare for Assembly

Remove all items from inside grill body and lay grill body on its back. For ease of assembly,
complete steps 1-5 below before standing grill upright.

Tip: Flatten the cardboard box out and lay everything on it. This serves as a good working

area and it helps prevent the grill from getting scratched or damaged during
installation.

STEP 2 – Attach Legs

Attach legs with fixed wheels (#3) on the left side, with wheels facing outward to the front and

of grill. Attach legs with the rotating casters (#2) on the right side of the grill.

back
Attach all four legs using bolts (A), flat washers (B), lock washers (C) and nuts (D)

DO NOT FULLY TIGHTEN HARDWARE

All hardware is found in included Hardware Packet (#12)

STEP 3 – Attach Bottom Shelf

Align shelf (#4) between grill legs and attach using 4 bolts (A), flat washers (B), lock washers

and nuts (D).

(C)

FULLY TIGHTEN HARDWARE

EP 4 – Install Pull bar Handle

ST

Attach the pull bar handle (#6) using the two bolts that are screwed into the
handle.

STEP 5 – Grill Handle Assembly

Attach the grill handl e (#5) to grill lid using the small bolts that are screwed into handle.
Proper placement will result in the handle facing inward with the tip slightly upward.

STEP 6 – Stand Grill Upright

You will need two people to do this as the grill is very heavy.

Correct Hardware Alignm ent

6

PQGRSD /$T 7$T 1#O+'K%U$'D ;;=

STEP 7 - Flame Deflector (#7), Drip Pan (#8) Cooking Grates (#9), and

#1

#9

#8

#7

#10

Drip Bucket (#10) Installation

Open the lid of the
notches in the flame deflector over the small tabs located at the inside front and rear of the
grill body.

stall Drip Pan (#8) with the short lip sitting on the left-side drip pan support and

In
the longer lip resting on the right-side lower support. Make sure to leave equal gapping
between Drip Pan and front and back chamber walls to ensure even heat distribution.

BE CARE
DRIP PAN.

P: many customers line their drip pan with aluminum foil for easier clean up. When lining drip

(TI
pan, keep foil inside drip pan edges and do not wrap around as this can restrict airflow.)

Ins

tall the Cooking Grates (#9) by resting it flat on the front and back ledges inside chamber. Be

careful to avoid the temperature sensor during placement.

tall the Drip Bucket (#10) by clipping the handle to the integrated hook on grease spout on

Ins
right side of grill and allow it to hang.

FUL NOT TO DAMAGE THE TEMPERATURE SENSOR WHILE INSTALLING THE

grill and

Install the Flame Deflector (#7) over the Burn Pot with the small

Questions?

Call our customer service at 1-706-922-0890
10am-8pm EST. Mon-Thurs;
10am-7pm EST Fri;
9am-3pm EST Sat.

7

PQGRSD /$T 7$T 1#O+'K%U$'D ;;=