SAMPI Pulse Output Device User Manual
Pulse Output Device (POD)
Specifications Sheet
The SAMPI Pulse Output Device (POD)
converts the rotary motion of the Positive
Displacement Flow Meter into electronic
pulses. This allows the meter to interface
with a wide variety of electronic monitoring
devices and control equipment. The POD
mounts directly to the front cover of any
SAMPI/LC meter in place of the packing
gland. The motion of the meter’s blocking
rotor is magnetically coupled through a
stainless steel wall to the electronics
compartment of the POD. This eliminates the
dynamic seal of the packing gland and
isolates the electronics from the process fluid
in the meter.
Features
Glandless Drive
Pulse Output
Materials All wetted parts are in 316 stainless steel or equivalent
Weight & Measures
Requirements
Pressure Rating
Explosion Proof
Rating
Connections
-No dynamic seals to fail or leak
-Meets current environmental standards
-The unscaled output easily adapts to remote totalizers, batch
controllers, computers, PLC’s and other pulse receiving devices
-No amplifier or signal conditioner is required
Housing cover has a ready made location for lead wire seal
Process wetted portion carries 24 bar (350 PSI) working
pressure rating. Burst pressure exceeds 121 bar (1750 PSI)
II 2G Eexd II B T6, LCIE04ATEX6033
½” NPT conduit port with a removable screw terminal block for
all connections
Specifications
Voltage (V+): +8 to +24 Vdc (POD5 is +5 Vdc) ±5%
Current Supply 26 mA typical
Output Signal Resolution 100 pulses per encoder revolution, unscaled
Square Wave Single or dual quadrature channel output
Pulse Timing Nominal 50% on and 50% off
Operating Temperature Range -40°C to 85°C (-40°F to 185°F)
Output
Optional Open Drain FET (Field Effect Transistor).
FET Rating (Drain to Source Voltage)
Current sinking 100 mA maximum in “ON”
state; V+ supply @ 1.0 KΩ in “OFF” state
+30 Vdc maximum
Electromagnetic Compatibility To IEC 801 standard
Dimensions
SAMPI spa
A unit of IDEX Corporation
Via Amerigo Vespucci, 1
55011 Altopascio (Lucca) – Italy
Phone: +39 0583 24751
Fax: +39 0583 264748
www.sampi.it
Loading...