Samlex America S-R6-24 User Manual

S-R6 Inverter Remote Control User Manual

1. Features

• Battery bank voltage display

• Output power display

• Error condition indicator (High Battery, Low Battery, Over Temperature, Over Load conditions)

• Indicator for status of operation (INV, GRID, POWER SAVING)

• Failed connection display

2. Specification

• Input Voltage : separate versions for 12 V & 24 V inverters

• Operating Temperature Range : 0 – 40℃

• Storage Temperature Range : - 30℃ - 70℃

• Stand-By Current Draw : < 80mA

• Applicable Models : SA-1000K / 2000K / 3000K Series

3. Introduction

• Power ON/OFF Switch

Power ON/OFF switch is to turn the inverter on or off. You are supposed to hear one beep sound every time you switch

on or off.

www.samlexamerica.com

• Battery voltage indicator “BATTERY”

This bar chart controls a light that will move up and down as the battery voltage changes. Ideally, the voltage should

remain in the green area of the bar chart.

If the voltage goes into the red area at the top and bottom of the graph, inverter may shut down.

• Output power indicator “OUTPUT (%) POWER”

The AC load watt chart indicates the power drawn from the inverter by the load. Ideally, the watt indicator should remain

in the green & orange area of the bar chart.

If the OUTPUT POWER indicator is up to the red area of the bar, the light will flash and the inverter will shut down for

inverter safety.

• Over voltage protection indicator “OVP”

The over voltage protection indicator is to indicate that the inverter has shut down because its input voltage is above 12 /

24 VDC.

• Under voltage protection indicator “UVP”

The under voltage protection indicator is to indicate that the inverter has shut down because its input voltage is below 12

/ 24 VDC.

• Over temperature protection indicator “OTP”

The over temperature protection indicator is to indicate that the inverter has shut down because of overheating. The over

temp indicator will be OFF when the inverter cools down.

• Overload protection indicator “OLP”

The overload protection indicator is to indicate that the inverter has shut down because of short circuit or overload

problems.

• “INV” indicator

The INV indicator is to indicate that the inverter is ready.

• GRID indicator

The GRID indicator is to indicate that the inverter is in Pass Through Mode & transferring Grid power to the load

(Applicable to the versions with Transfer Relay).

• PWR.SAV. Indicator

Power saving functions are described below:

LED Meaning Inverter Output

Solid Ready ON

Flashing Active OFF

Off Inactive

www.samlexamerica.com