Pub. Date 2014.03.20
User Manual
Rev. Date 2014.03.20
Rev. No 0.0
USER MANUAL
Product Occupancy Sensor
Model Name OSRF-STUS
Manufacture Samjin LND
Ver. V0.0
Document No. Model Name
OSRF-STUS
Page
페이지 1 / 4
User Manual
1.Specification
Description Material / Finish / Data
Pub. Date 2014.03.20
Rev. Date 2014.03.20
Rev. No 0.0
Model No.
Encloser
Size / Weight
Occupancy Sensing(PIR)
RF Sensing
Network Method
Operating Temp(℃)
Operating Humidity(℃)
OSRF-STUS
Polycarbonate, White
74.8x 68.5 / 0.06Kg
Ceiling height 2.7m / 100 degree angle / 3m radius
Wall Controller / Radius 25M
RF 900MHz
-10(min) ~25(typical)~45(max)
-10(min) ~90(max)
2.Operation
1) Occupancy sensor is a device for detecting presence of interior occupants, and an
energy saving method by controlling local luminaires. If movement of a person
or an animal is not detected for a preset length of time, luminaires are
automatically turned off, which decreases unnecessary use of luminaires and
increase energy savings.
2) Usage of PIR(Passive Infra-Red) Sensor
- Motion detection sensor – makes luminaires turned on automatically.
- Installed at rooms, porch, corridors, passages (detecting within 3m radius)
Document No. Model Name
OSRF-STUS
Page
페이지 2 / 4
Pub. Date 2014.03.20
User Manual
Rev. Date 2014.03.20
Rev. No 0.0
3.Installation
1) Contents : Sensor body, Rear Case for ceiling mount, fixing screw 2ea
No Description Detail(Function)
1
2
3
RJ 45 Connector
for power supply
Rear Case Rear Case for ceiling mount
Screw
Power supplied from luminaire (CAT5e LAN Cable)
Daisy Chain support(CAT5e LAN Cable)
Fixing Screw(×2) for Rear Case
Document No. Model Name
OSRF-STUS
Page
페이지 3 / 4
Pub. Date 2014.03.20
User Manual
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
●Reorient or relocate the receiving antenna.
●Increase the separation between the equipment and receiver.
●Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
●Consult the dealer or an experienced radio/TV technician for help.
Rev. Date 2014.03.20
Rev. No 0.0
FCC Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference,
(2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment. Information to user:
The user manual or instruction manual for an intentional or unintentional radiator shall
caution the user that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
Document No. Model Name
OSRF-STUS
Page
페이지 4 / 4
Loading...