SALUS North America SC824ZB User Manual

IN THE BOX

SAFETY INSTRUCTIONS:

Read these instructions carefully before installing and
using the Low Voltage Contact Relay and keep this guide

in a safe place for future reference.

• Verify compatibility with your associated
connected home system before installation.

• Follow all instructions provided by your connected
home manufacturer regarding the addition of
devices to your connected home system. An
authorized, qualified installer may be required.

• Follow all applicable codes and regulations in the
municipality where this product is installed.

Salus accepts no responsibility for damage caused by not
following these instructions.

Low Voltage Contact Relay

Quick Start Guide

NOTE:

Additional equipment may be required to address
radio communication issues due to building
construction or materials, or other radio interference.

CONTROLS AND INDICATORS

Status
LED

Multi Button

Terminal
Strip

LED

Function

AMBER (RED + GREEN)

Power up

3 RED flashes

Network Search

Steady GREEN

Relay is Closed

No LED

Relay is Open

Long GREEN

Short RED

Relay is Closed,
no network

No LED

Short RED

Relay is Open
no network

Short GREEN

Short RED

Special Function
Mode

Long GREEN

Short AMBER

Relay Closed,
Identify

No LED

Short AMBER

Relay Open,
Identify

Terminal

Function

R (x2)

Power Input

C (x2)

Power Return

COM

Common relay contact

NO

Normally Open relay contact

Action

Function

Short press

Toggle output

Press 5x

Join/Rejoin network

Hold 3s

Enter Special Functions (SF)

SF: no press

Identify

SF: Hold 3s

Factory Reset

SPECIFICATIONS

Input Voltage

18-30 VAC

Input Current

30 mA,
50 mA max

Contact Voltage

30 VAC max

Contact Current

3 A max,
resistive

Quick Start Guide: Low Voltage Contact Relay (SC824ZB)

PAIRING INSTRUCTIONS

• Prepare to add devices per your system’s instructions.

• Power up the Low Voltage Contact Relay (LVCR).

• When the LVCR is detected, follow your system’s instructions to finish adding the switch to the system. You may

need to press the Multi Button to identify the switch.

USING THE LOW VOLTAGE CONTACT RELAY (LVCR)

TURN OFF/ON

• To toggle the LVCR (turn ON when OFF, or turn OFF when ON), press the Multi Button briefly.

FORCE REJOIN TO CURRENT NETWORK

• To find a better path to the connected home system if the network is intermittent and/or other ZigBee devices
are added/deleted, press the Multi Button 5 times quickly (less than ½ sec between presses).

IDENTIFY MODE

• To initiate Identify Mode, press the Multi Button until the LED turns Amber (~3 seconds), then release. The LED
will then alternate between RED and GREEN. Wait 3 seconds and the device will enter Identify Mode and flash
the LED accordingly.

RESET TO FACTORY DEFAULTS

• To reset to factory default settings, press the Multi Button until the LED turns Amber (~3 seconds), then release.
The LED will then alternate between RED and GREEN. Press the Multi Button again until the LED turns Amber (~3
seconds), then release. The device will factory reset and return to normal operations.

FCC STATEMENTS

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC AND INDUSTRY CANADA

RF Radiation Exposure statement: This equipment complie

for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters
between the antenna and all persons.

s with FCC and Industry Canada RF radiation exposure limits set forth

INDUSTRY CANADA

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
The distance between user and products should be no less than 20cm.
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation, Sciences et
Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes :
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable de
l'appareil.
La distance entre l'utilisateur et de produits ne devrait pas être inférieure à 20cm.

SALUS WARRANTY

SALUS North America, Inc. (“Salus”) warrants that for a period of five (5) years (“Warranty Period”) from the date of purchase by the
consumer (“Customer”), this device, excluding batteries (“Product”), shall be free of defects in materials and workmanship under
normal use and service in accordance with all supplied instructions. During the warranty period, Salus shall, at its option, repair or
replace any defective Products, at no charge for the device. Any replacement and/or repaired devices are warranted for the remainder
of the original Warranty Period or ninety (90) days, whichever is longer.

This warranty does not cover removal or reinstallation costs. This warranty does not apply to any Product (i) which has been modified,
repaired, or altered, except by Salus or an authorized Salus representative, (ii) which has not been maintained in accordance with any
handling or operating instructions supplied by Salus, or (iii) which has been subjected to unusual physical or electrical stress, misuses,
abuse, negligence or accidents.

This warranty is the only express warranty Salus makes for the Product. Any implied warranties, including warranties of
merchantability or fitness for a particular purpose, are limited to the Warranty Period or the shortest period allowed by law.

SALUS SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL
DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER
FAILURE OF THIS PRODUCT. Some states and provinces do not allow the exclusion or limitation of incidental or consequential
damages, or limitation on the duration of implied warranties of merchantability or fitness, so these exclusions or limitations may not
apply to you.

No oral or written information or advice given by Salus or a Salus-authorized representative shall modify or extend this warranty. If
any term is held to be illegal or unenforceable, the legality or enforceability of the remaining terms shall not be affected or impaired.

Customer’s sole and exclusive remedy under this limited warranty is product repair or replacement as provided herein. If a Product
under warranty is defective, the Customer may:

• contact the party (“Seller”) from which the Customer purchased the Product to obtain an equivalent replacement product after
the Seller has determined that the Product is defective and the Customer is eligible for a replacement, or

• contact Salus Service at [e-mail], to determine whether the device qualifies for a replacement. If a replacement is
warranted and is shipped prior to the return of the device under warranty, a credit card is required and a hold may be placed on
the Customer’s credit card for the value of the replacement until the returned device is verified as eligible for replacement, in
which case, the Customer’s credit card will not be charged.

This warranty gives you specific legal rights, and you may also have other rights that vary from jurisdiction to jurisdiction. If you have
any questions regarding this warranty, please write Salus at:

SALUS North America, Inc.
850 Main Street
Redwood City, CA 94063