Page 1
www.salus-controls.com
SALUS Controls plc
SALUS House
Dodworth Business Park South,
Whinby Road,
Dodworth, Barnsley S75 3SP, UK.
SALES: T: +44 0 1226 323961
E: sales@salus-tech.com
TECHNICAL: T: +44 0 1226 323961
E: tech@salus-tech.com
For PDF Installation guide please go to
www.salus-controls.com
Maintaining a policy of continuous product
development SALUS Controls plc reserve the right to
change specication, design and materials of
products listed in this brochure without prior notice.
SALUS Controls is a member of the Computime Group
00086/2 Issue Date: June 2014
INSTALLER / USER MANUAL
Zigbee Coordinator
Models: CO10RF
SALUS Controls warrants that this product will be free from any defect in materials or
workmanship, and shall perform in accordance with its specication, for a period of ve years
from the date of installation. SALUS Controls sole liability for breach of this warranty will be
(at its option) to repair or replace the defective product.
Customer Name: .............................................................................................................................
Customer Address: ..........................................................................................................................
............................................................................... Post Code: ........................................................
Tel No: ........................................................ Email: .........................................................................
Engineers Company: .......................................................................................................................
Tel No: ......................................................... Email: ........................................................................
Instalation Date: ..............................................................................................................................
Engineers Name: ............................................................................................................................
Engineers Signature: .......................................................................................................................
WARRANTY
TECHNICAL DETAIL
SYSTEM DELETE
Model CO10RF
Type Zigbee Coordinator
Function Zigbee network coordinator for iT600 system
Control Open - Close the Zigbee network
Indication Tri Colour LED - RED - GREEN - AMBER
User Interface Single push button
Operating Temperature 0 to 50 ºC
Storage Temperature -20ºC to 60ºC
Frequency 2.4 GHz
Power Source 230V 50Hz via mains adaptor (supplied)
Approval CE
The button colour
will change to
AMBER to indicate
system delete. At this
point, the proceedure
cannot be cancelled.
If at any time you need to delete ALL installed iT600 devices
from your Zigbee network follow the steps below. As this
procedure can have a serious aect on your heating / cooling
system. It should only be carried out by your installer.
After all devices have been deleted from the Zigbee network, they will
need to be re-installed. Please refer to all relevant instruction manuals.
Press for 15
seconds
to activate
identify mode.
SYSTEM DELETE
iT600 System
SALUS Wiring Centre KL10RF
RX10RF
TRV10RF
VS10/20RF Thermostat
CO10RF
CO10RF 003.qxd_Layout 1 18.06.2014 13:40 Strona 1
Page 2
INSTALLATION
Product Compliance & Safety Info
Product Compliance
• Electro-Magnetic Compatibility directive
2004 / 108 / EC
• Low voltage Directive 2006/95/EC
Warning
These instructions are applicable to
the SALUS model stated on this
instruction guide.
This product must be tted by a competent
person, and installation must comply with the
guidance, standards and regulations applicable
to the city, country or state where the product is
installed. Failure to comply with the
requirements of the relevant guidance,
standards and regulations could lead to injury,
death or prosecution.
Warning
Always isolate the AC Mains supply before
installing or working on any components that
require 230 VAC 50Hz supply.
We hope you enjoy this product...
Box Contents
INSTALLER / USER MANUAL
Zigbee Coordinator
Models: CO10RF
1 x Installer / User manual
1 x CO10RF
1 x USB Adapter
1 x UK Plug + EU Plug Adapter
Switch the 230V mains outlet on and
ensure the button is illuminated (red)
as shown above.
Attach plug adapter to the USB adapter
Attach Coordinator to USB adaptor.
INSTALLATIONSYSTEM OVERVIEW
To commence system installation press and
hold the button until for 5 seconds or the
button starts ashing red. This means the
Zigbee network is ready to accept iT600
devices.
When everything is paired press and hold
button for 5 seconds or ashing stops.
Please refer to individual
device manuals.
UK or EU plug version
SALUS Wiring Centre KL10RF
RX10RF
TRV10RF
VS10/20RF Thermostat
CO10RF
INTRODUCTION
Thank for purchasing the SALUS CO10RF Zigbee
coordinator. The Zigbee coordinator controls the
Zigbee communication of your iT600 system.
CHECKING SYSTEM CONFIGURATION
Please refer to individual device
manuals for more information.
The Zigbee coordinator must be used with
the iT600 RF range of products below:
Press again for 1 second
to cancel identify.
Identify mode will time
out after 10 minutes.
To check that the complete system is
communicating and has been congured
correctly, you can use identify mode.
Using identify from the
coordinator will show all products
that are connected to your system.
4
6
7
5
8
Maintenance
If replacing or adding iT600
devices please ensure you
follow steps 6 to 8.
Insert the adaptor into 230V mains outlet.
Press for 1
second
to activate
identify mode.
1
2
3
iT600 System
For PDF Installation guide please go to
www.salus-controls.com
CO10RF 003.qxd_Layout 1 18.06.2014 13:40 Strona 2
Loading...