Salto Systems S L ABXW, ABXX User Guide

FCC Compliance Statements

(FCCID: UKCAE9, UKCAE9W, UKCL90, UKCG90, UKCRPOE, UKCNRF, UKCA9XX, UKCA9XW,
UKCCLAYIQ, UKCABXW, UKCABXX, UKCWRDB)

This device complies with Part 15 of the FCC Rules.Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Canadian Compliance Statement
(IC: 10088A-AE9, 10088A-AE9W, 10088A-L90, 10088A-G90, 10088A-RPOE, 10088A-NRF, 10088A­A9XX, 10088A-A9XW, 10088A-CLAYIQ, 10088A-ABXW, 10088A-ABXX, 10088A-WRDB)

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Distance between 10088A-CLAYIQ and human body must be higher than 20cm. Distance entre le
10088A-CLAYIQ et le corps humain doit être supérieure à 20 cm.

EU Compliance Statement
(Products: All Salto Systems S.L. products with RFID/Wireless capability)

EN Hereby, Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain), declares
that this access control equipment is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC
(R&TEE). You will be able to find a copy of the original declaration of conformity at the
following Internet address:
http://www.saltosystems.com/certificate

ES Por medio de la presente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180
Oiartzun– Spain) declara que este equipo de control de accesos cumple con los requisitos
esenciales y cualesquiera otras disposiciones aplicables o exigibles de la Directiva 1999/5/CE
(R&TEE). Podrá encontrar una copia de la declaración de conformidad original en la
siguiente dirección de internet:
http://www.saltosystems.com/certificate

FR Par la présente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain)
déclare que l’appareil
équipement pour le con trôle d’accès est conforme aux exigences essentielles et aux autres
dispositions pertinentes de la directive 1999/5/CE (R&TEE). Vous pouvez télécharger une
copie de la déclaration de conformité originale à travers
l’adresse suivante:
http://www.saltosystems.com/certificate

DE Hiermit erklärt Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain),
dass sich das Gerät Zutrittskontrollgeräte in Übereinstimmung mit den grundlegenden
Anforderungen und den übrigen einschlägigen Bestimmungen der Richtlinie 1999/5/EG
(R&TEE) befindet. Eine Kopie der originalen Konformitätserklärung finden Sie auf der
folgenden Internetseite:
http://www.saltosystems.com/certificate

NL Hierbij verklaart Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun–
Spain)dat het toestel toegangscontroleapparatuur in overeenstemming is met de
essentiële eisen en de andere relevante bepalingen van richtlijn 1999/5/EG
(R&TEE). u kunt een kopie van de originele verklaring van overeenstemming vinden op het
volgende internetadres:
http://www.saltosystems.com/certificate

EU Compliance Statement

(Products: All Salto Systems S.L. products without RFID/Wireless capability)

EN Hereby, Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain), declares
that this access control equipment is in compliance with the essential requirements and
other relevant provisions of Directive 2004/108/ EC (EMC) and Directive 2006/95/EC
(Electrical Safety). You will be able to find a copy of the original declaration of
conformity at the following Internet address:
http://www.saltosystems.com/certificate

ES Por medio de la presente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180
Oiartzun– Spain) declara que este equipo de control de accesos cumple con los requisitos
esenciales y cualesquiera otras disposiciones aplicables o exigibles de la Directiva
2004/108/CE (EMC) y la Directiva 2006/95/CE (Seguridad Eléctrica). Podrá encontrar una copia
de la declaración de conformidad original en la siguiente dirección de internet:
http://www.saltosystems.com/certificate

FR Par la présente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain)
déclare que l’appareil équipement pour le contrôle d’accès est conforme aux exigences
essentielles et aux autres dispositions pertinentes de la directive 2004/108/CE,
2006/95/CE. Vous pouvez télécharger une copie de la déclaration de conformité originale à
travers l’adresse suivante:
http://www.saltosystems.com/certificate